BSG provides ice machine specifi c instructions for many styles of ice
machines. Please download these instructions from the ICEZONE installation
page on BSG’s website: www.bsg-uv.com/products/chill-ice/icezone/
The following steps outline general guidelines for ICEZONE installation on cuber
style ice machines.
To determine the best location for your ice machine, start by looking for areas
of mold growth and choose a position for ICEZONE that will provide maximum
treatment to that area.
Mark the location for the supply and return
ports on the ice machine according to
these steps:
▬Supply and return ttings and tubing
should be installed above the ice
levels
▬Supply should be positioned to target
areas that are vulnerable to slime
build-up with UV-plasma
▬Supply and distribution lines should
be positioned as far apart as possible
to maximize distribution of UV-plasma
▬UV-plasma is heavier than air, so
install the supply line relatively high,
and the return line relatively low
Remove top panel or cover to be drilled. Drill the 1” (25mm) holes for the bulkhead
ttings. Clean the drilling debris from the holes in the ice machine. Install the ttings
for the supply and return ports.
It is recommended that the ICEZONE be
mounted on top of the ice machine. To avoid
condensation, do not mount ICEZONE with
the supply and return ports pointing up.
Flat mount
Ports horizontal
Outside ice
machine
Inside ice
machine
Side mount
Ports horizontal
Side mount
Ports down
Side mount
Ports up
Step 1: Identify installation location
Step 2: Drill supply and return ports
General installation guidelines
3
Expanded view of
supply fi tting
