6
Intended Usage
The Brewista® Cold Pro Nitro 2™ Dispenser is a ready-to-use dispenser to tap nitrogenated
and cooled beverages in particular cold-brew coee from any pressurized or non-
pressurized container. Such systems are mainly used for professional customers in cafes,
hotels, restaurants, and bars. The nitrogen eect is created through ltered compressed
air which contains 78% nitrogen and chilling it to 36°F (2°C). The device is only approved
for this application and is not suitable for cooling hot liquids, unltered liquids, chemicals,
or similar substances. The Brewista® Cold Pro Nitro 2™ Dispenser must only be operated
by a trained person. The appliance is not to be used by persons (including children) with
reduced physical, mental, or sensory abilities or with scarce experience and/or expertise,
unless they are supervised by a person responsible for their safety, or they are instructed
by this person on how to properly use the Cold Pro Nitro 2™ machine.
Operation Instructions
Assemble your Cold Pro Nitro 2™
1) Place the device in a level, clean, and dry location. Ensure there is enough
space around the machine for proper ventilation — about one inch (2.54 cm)
from the side vents and 4 inches (10 cm) from the top.
2) Let the machine sit upright for 5 hours before rst use so the compressor
works properly.
3) Assemble the tap handle (1) by screwing on at the top of the dispenser’s spout
component [(2) and (3)].
4) Ensure the power button (6) at the bottom of the machine is switched o. If
the red light inside of the switch is o, then the air compressor is o.
5) Plug in the power cord (8) to a grounded outlet (refer to Additional
Safeguards, page 3).
6) Connect the intake tube (11) to the Cold Pro Nitro 2™ by pushing the male
elbow coupler (12) into the female coupler at the bottom of the machine
located at the far end of the machine on the bottom.
◦Lift the machine slightly if needed.
◦To release the coupler attachment, push the metal spring component to
loosen.
7) The pre-lter comes attached upon delivery of the Cold Pro Nitro 2™ machine.
Ensure all tubing is installed rmly at all connections to prevent air bubbles
from entering the tube. Tubing may have loosened during shipment.
◦Note: If a lter adapter is not part of your intake line, coee grounds or
other particles could block the jet nozzles in the device or impair the
functionality of the membrane pump and make the device unusable.
Connect your Cold Brew Container
• Note: Brewista recommends checking functionality of your system by using
water. This will also help ush out any cleaning solution residue from the
system as well.
• Connect the intake line tubing (11) to your cold brew container such as the
Brewista Cold Pro 2™. If your intake line is connected to a keg, be sure the
system can draw air or is fed with inert gas when tapping starts and coee is
dispensed.
