Introduction The purpose of this manual is to assist you in Maintaining and operating
your Redline backhoe. Read it carefully, it provides information and instructions that will help you achieve years of reliable
performance. Some information may be general in nature due to unknown and varying conditions. However, through
experience and these instructions, you should be able to develop operating procedures suitable to your particular situation.
“Right” and “Left” as used throughout this manual are determined by position operator is facing when in use.
The photos, illustrations and data used in this manual are current at the time of printing, but due to possible in-line
production changes, your machine may vary slightly in detail. The manufacturer reserves the right to redesign the machine
as may necessary without notification.
Important: Illustrations used in this manual may not show all safety equipment that is recommended to ensure safe
operation of tractor and backhoe. Refer to the Safety Precautions section of this manual for information concerning safety,
consult your dealer for further information. Serial Number and Location
Serial Number and Location The serial and model number is important information about the machine and it may be
necessary to know it before obtaining the correct replacement part. The identification plate is located on the right side of
control console. It is also recorded by your dealer on back page of this manual.
1.1 SAFETY
Understand that your safety and the safety of other people is measured by how you service and operate this Backhoe.
Know the position and operations of all controls prior to
operation. Make sure you check all controls in safe area
before starting.
Read this manual completely and make sure you understand all controls. All equipment has a limit. Make sure you are
aware of the stability and load characteristics of this Backhoe before you begin operating.
The Safety information given in this manual does not replace any safety codes, insurance needs, federal, state and local
laws. Make sure your machine has the correct equipment required by your local laws and regulations.
[2]
