Bowens Streamlite 330 Guide de l'utilisateur

Owner’s Han book

All Bowens electrical products are covered by a two year

warranty against any faulty design, materials and

workmanship.

If a product does not work on arrival or up to a maximum

period of four weeks from the date of purchase, it should be

returned to the dealer/retail outlet from where it was

purchased, to exchange (if available) the faulty unit for a new

one; if the faulty unit was part of a kit that was purchased, the

dealer / retailer may choose to simply replace the unit and not

the entire kit. Alternatively the dealer may offer to repair the

unit as soon as possible at no charge.

If neither an exchange or repair is possible for the faulty unit,

then a full refund may be made.

If a warranty fault occurs after the initial four week period (and

within the max two year warranty period), then the unit should

be returned to the dealer, who will arrange to repair the unit

as soon as possible, at no charge.

This warranty does not apply to consumable items such as

flash tubes, modelling lamps, fuses, consumable type

batteries.

Should a unit be returned at any time within the two year

warranty period, and it is judged to have experienced any of

the following points, failure to follow working instructions

correctly, accidental or willful damage, misuse, alteration or

repair by a non authorised Bowens service / repair centre,

then the warranty will be deemed invalid and any repairs that

may need carrying out will be payable by the owner.

The cost of any repairs should be notified to the owner, by the

dealer, in advance of undertaking any work that may be

required.

No warranty repairs can be undertaken to any units without

proof of purchase.

All warranty repairs or returns must be conducted with the

dealer from where the product was purchased.

ther terms and conditions may be applicable in specific

countries, if stated by the dealer at the time of purchase.

Contents

All Bowens products are certified by the CE mark. The CE certified mark is a

declaration of conformity to the required EEC directives 89/336/EEC

‘Electromagnetic Compatibility’ and 73/23/EEC ‘Low Voltage Directive’.

warranty

Warranty 2

CE Mark 2

Intro uction 3

Safety Notes 3

Streamlite 330 4

Streamlite 530 5

Operation 6

Operation 7

Cocoon & 7

Cocoon Stan Assembly

3- Streamlite | In roduc ion & Safe y No es.

introduction

Thank you for choosing the Streamlite from

Bowens. The Streamlite has been designed by

working closely with photographers to develop a

continuous light source that meets the high-

quality standards required in todays professional

studios.

In order to obtain the full benefit from your

purchase, please take a few moments to

familiarise yourself with this user manual.

For more information on all Bowens products and

to find details of your nearest Bowens dealer,

please visit the Bowens website.

www.bowens.co.uk

safety notes

• Switch power off and disconnect from the power supply

before changing a lamp or fitting removing accessories.

• Disconnect the power supply before changing the fuse.

Never replace with a fuse of a different rating.

A spare fuse is fitted in the fuse holder under the AC inlet

(see pages 4-5).

• Exercise care when handling equipment that has been in

use.

• Avoid placing cables where they can be tripped over.

Protect from heavy, sharp or hot objects, which may

cause damage & replace damaged cables immediately.

• Always remove the power cord by gripping the plug.

NEVER pull the cord.

• Always ensure that any extension cord used has a

suitable current rating to prevent overheating and never

use coiled extension cords.

• Use the specified lamps. A fire hazard exists if lamps

other than the ones specified are used.

• Use in an environment where moisture or flammable

vapour is likely to come in contact with the unit.

• Restrict air vents while in use.

• Use a unit with damaged housing, mouldings or

lamp. If the unit is dropped or damaged in any way,

always have it checked before using.

• Use any equipment with a damaged mains cable.

• perate the unit without a safe grounded AC supply.

always... never...

4- Streamlite | 330

Streamlite 330

30W spiral lamp

Reflector

Carry handle

AC power input

n/ ff switch

Adjustable stand

bracket

Maximum Power 90W (3 x 30W)

Lamps 230V 30W E27 5600K BW-3457

117V 30W E27 5600K BW-3458

Supply Voltage 230V 220-240V 50/60Hz

117V 110-130V 50/60Hz

Dimensions 414mmØ x 325mm inc re lector

161⁄3”Ø x 124⁄5”inc re lector

Weight 1.95Kg (4.2lbs) inc re lector

Specifications:

117V 230V

Streamlite 330 BW-3455 BW-3450

Streamlite 330 kit BW-3475 BW-3470

Streamlite 330 di user BW-3456 BW-3456

Part Co es:

30W spiral lamp

Reflector

Carry handle

Lamp n/ ff

switch

AC power input

Power n/ ff

switch

Adjustable stand

bracket

5- Streamlite | 530

Streamlite 530

Maximum Power 150W (5 x 30W)

Lamps 230V 30W E27 5600K BW-3457

117V 30W E27 5600K BW-3458

Supply Voltage 230V 220-240V 50/60Hz

117V 110-130V 50/60Hz

Dimensions 460mmØ x 335mm inc re lector

181⁄10”Ø x 131⁄5”inc re lector

Weight 2.8Kg (6.17lbs) inc re lector

Specifications:

117V 230V

Streamlite 530 BW-3465 BW-3460

Streamlite 530 di user BW-3466 BW-3466

Part Co es:

General Operation

• Always use the cable supplied from your

Bowens dealer to connect the unit to the

mains power supply.

• It is recommended to switch on the Streamlite

a few minutes before you start shooting as the

light output will improve after the lamps have

been switched on for a short period.

• When operating the Streamlite angled down

more than 45° below horizontal, heat build up

can shorten the lamp life. If used this way limit

use to around 1 hour then switch off and allow

to cool before recommencing operation.

Replacing Lamps

• Switch FF the power and disconnect from

the mains supply before removing / replacing

any lamps.

• Remove the reflector.

• While holding the lamp by the base, gently

screw the lamp into the lamp holder (as shown

in figure 1).

• Repeat previous step until all lamps are

positioned into the lamp holders (figure 2).

Attaching Reflector

• Position the spigots on the reflector into the

slots on the Streamlite (figure 3).

• Gently turn the reflector clockwise until locked

into place (figure 4).

Note: It is recommended that only lamps purchased

under a Bowens ‘BW’ stock code number are used as

replacements. The manufacturer will not accept liability

for the use of any other lamps.

6- Streamlite | Opera ion

Operation

figure 1. figure 2.

figure 3.

figure 4.

Operation

Attaching Diffuser

• Place the diffuser over one side of the

reflector, as shown below.

• Stretch the elasticated diffuser over the

reflector until appears as shown.

Cocoon Stan Assembly

StepONE - Place the two

leg sections on the floor

with the legs fully

extended.

StepTWO - Attach one of

the Cocoon Supports.

Use the studs on either

side of the support to

lock in place with the leg

sections.

StepTHREE - nce the

studs are locked in place

the first support should

appear as shown.

StepFOUR - Attach both

supports to the legs.

Your assembled Cocoon

Stand should appear as

shown opposite.

Cocoon Assembly

StepONE - Place the

central translucent panel

onto the floor with the

red and blue coloured

dots facing upwards.

StepTWO - Fasten the

two side panels using the

attached velcro. Ensure

coloured dots on each

panel line up to the

correct sides.

StepTHREE - Attach the

final panel as shown.

Make sure all coloured

dots are correctly placed.

StepFOUR - Finally, zip

all of the panels together.

Your assembled Cocoon

should appear as shown.

Cocoon & Cocoon Stand Assembly

7- Streamlite | Opera ion

ONE

TWO

THREE

FOUR

ONE

TWO

THREE

FOUR

BWL0575 | S reamli e 330 and 530 07/2010

Owner’s Han book

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Bowens Équipement d'éclairage

Bowens

Bowens ESPRIT GEMINI GM125 Manuel utilisateur

Bowens

Bowens Streamlite 330 Guide de l'utilisateur

Bowens

Bowens ESPRIT 2 125 Manuel utilisateur

Bowens

Bowens EQUIPE 2400 Pack Manuel utilisateur

Bowens

Bowens ESTIME 3000 Manuel utilisateur

Bowens

Bowens Espirit Gemini GM125 Manuel utilisateur

Bowens

Bowens EQUIPE HEAD Manuel utilisateur

Bowens

Bowens ESPRIT GEMINI GM200 Manuel utilisateur

Bowens

Bowens GEMINI DIGITAL 500 Manuel utilisateur

Bowens

Bowens ESTIME 3000 FLASH HEAD Manuel utilisateur

Bowens

Bowens ESPRIT digital DX 250 Manuel utilisateur

Bowens

Bowens Octo 90 Guide de l'utilisateur

Bowens

Bowens DUO-LITE HEAD Manuel utilisateur

Bowens

Bowens XMS Series Manuel utilisateur

Bowens

Bowens ringflashpro BW-7670 Manuel utilisateur

Bowens

Bowens CREO 1200 Guide de l'utilisateur

Bowens

Bowens ESPRIT 2 500 Manuel utilisateur

Bowens

Bowens EQUIPE 1200 Pack Manuel utilisateur

Bowens

Bowens ESPRIT DIGITAL 750 Manuel utilisateur

Bowens

Bowens ESPRIT 250 Manuel utilisateur

Bowens

Bowens ESPRIT 1500 Manuel utilisateur

Bowens

Bowens ESPRIT II 1000 Manuel utilisateur

Bowens

Bowens DUO 4800 PACK Manuel utilisateur

Bowens

Bowens BW3370 UNILITE Manuel utilisateur

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur