BougeRV CR PRO 20 Manuel utilisateur
For Portable Car Refrigerator
Model: CR PRO 20 / CR PRO 23 / CR PRO 25 / CR PRO 30
Please read this operating manual carefully before using the device.
Keep it for future reference.
Contents
1. Safety Instructions
2. Product Features
3. Product Structure
4. Preparing Before Use
5. Operation Instruction
6. Car Battery Protection Voltage Reference
7. Cleaning and Storage
8. Troubleshooting and Error Problems
9. Warranty and Maintenance
10. Specification
1
2
2
3
3
5
6
6
9
10
1. Safety Instructions
WARNING！ Failure to obey these warnings could result in a malfunction of
your device and possible injury for yourself and other users.
• Do not operate the device if it is visibly damaged.
• Do not block the gaps of the device with things like pins, wire, etc.
• Do not expose the device to rain or soak it in water.
• Do not place the device near naked flames or other heat sources (heaters, direct sunlight,
gas ovens, etc.)
• Do not store explosive substances like spray cans with flammable propellants in the device.
• Before starting the device, ensure that the power supply line and the plug are dry.
• Check if the voltage specification on the type plate matches that of the energy supply.
• Once unpacked and before turning on, the device must be placed on a level surface for
more than 6 hours.
• Make sure that the device stays horizontally when it is running. The tilt angle must be less
than 5° for a long time running and be less than 45° for short time running.
• The refrigerator must be well ventilated for heat dissipation and make sure to keep some
space around it. (Back Space>200mm, Side Space>100mm)
• The device may only be repaired by qualified personnel. Improper repairs can lead to safety
hazards. If the power cable is damaged, it must be replaced by the manufacturer, customer
service, or a similarly qualified person in order to prevent safety hazards.
• The device can be used by children aged 8 or over, as well as by persons with reduced
physical, sensory or mental capabilities or a lack of experience and/or knowledge, providing
they are supervised or have been taught how to use the device safely and are aware of the
resulting risks.
Children must be supervised to ensure that they do not play with the device.
• The installation of DC power in the boat must be handled by qualified electricians.
• Never pull the plug out of the socket by the cable.
• Disconnect the device or switch it off when you turn off the engine. Otherwise, you may
discharge the battery.
Food is suggested to be stored in its original packaging or in suitable containers.
Set the suitable temperature for food or medicine stored in the device.
NOTICE！
CAUTION！
1
Multiple Application Scenarios: you can use the fridge on various vehicles such as SUV,
Truck, RV, Camper, Jeep, Van, Boat, etc. You can take it with you, during camping, tailgating,
road trips， outdoor travels, off-road, even at home.
Freezer or Refrigerator: with a temp range-8°F~50°F(-22℃~10℃), you can use it as a freezer
or refrigerator.
Energy Efficiency: with ECO energy-saving mode, the operating mode is less than 45W. It
consumes far less than 1kwh/day for its intelligent cycle work.
Fast Cooling with Compressor Refrigeration: running on Max mode in empty
condition, the freezer could achieve 15 min fast cooling from 77℉ to 32℉ and 50 min from
77℉ to -4℉
3-level battery protection mode: the battery monitor will shut off the fridge/freezer as soon
as the supply voltage falls below the set level.
45dB Low Noise: the fridge is designed with low noise to make sure you have a good sleep
after long driving.
2. Product Features
1. Ventilation Port
2. 12/24V Power Outlet
3. Damping Door
4. Interior Handle
5. Control Panel
6. Safety Tie-down Point
7. Storage Compartment
8. Lid
9. Sealed Rubber Ring
10. Refrigerator Compartment
3. Product Structure
2
1. Unpackage and take out the accessories and lay the refrigerator flat for 24 hours.
2. Before using it for the first time, clean the inside and outside of the refrigerator with a
damp cloth and wait until it gets dry.
3. Place your refrigerator in a proper position which depends on your use scenario (car,
truck, RV, camper, Van, Jeep, SUV, boat, home, etc.)
4. According to your use scenario, please choose the corresponding power cord (AC cord or
DC cord) for the power supply. Please read the next part carefully for the details.
Power Supply
Display Screen
Initialization
Connect to 12/24 DC power (use in car, truck, or power station)
Connect to 110~240V AC power (use a home outlet or ac outlet of
power station)
When the refrigerator is powered on, you will hear a "BEEP" sound, and
the display will flash once, and then nothing will be displayed.
This means that the refrigerator is at the standby status.
(Note: When the refrigerator is at the standby status, you can't operate it
until the refrigerator is turned on)
On/Off Button Temp Increase Button
Temperature Display Area
MAX/ECO Switching Display Area
Temp Decrease Button
Compressor working Icon
(It lights up when the compressor is working)
Battery Protection Setting
Unlock/Setting Button
Electricity/Voltage Display Area
4. Preparing Before Use
5. Operation Instruction
3
Turn on/off
Temperature
Setting
MAX/ECO Mode
Switching
Temperature
Unit Switch
Battery
Protection
Setting
Press for one time to turn on the refrigerator when it is at the
standby status.
Press and hold for 3 seconds to turn off the refrigerator.
In working status, press or for temperature setting. The setting
will be saved automatically after stopping operating for 4 seconds.
If you keep holding the button, the temperature will be adjusted fastly.
(Note: the temperature displayed is the current temperature of
the compartment. The refrigerator will take a while to reach the set
temperature.)
Temperature setting range: -22~+10℃（-8~50℉）
In working status, press one time, and the "MAX/ECO" will flash.
Then press again, and you can switch to MAX or ECO working mode.
If you stop the operation for 3 seconds, it will automatically confirm the
mode you are going to switch to.
ECO: Energy Saving Mode, 45 watts.
MAX: Fasting Cooling Mode, 60 watts.
In working status, press and at the same time for 3~5 seconds to
switch Celsius(℃)/Fahrenheit(℉). (Factory setting is ℉).
Battery Protection Setting
In working status, long press until the "H" flashes, and then press
to switch the HIGH, MEDIUM, or LOW levels.
It is suggested to set a HIGH level of the fridge when connecting with a
car battery.
To set MEDIUMand LOW levels when with a power station or other
batteries. (Factory setting is H）
This car refrigerator has a power-off memory function, and the working state (power on/off
state and working mode) before the power off is automatically restored after the next power
on, and there is no need to set it again.
4
The BougeRV fridge/freezer is equipped with a battery preservation monitor. It has
three settings to monitor your battery to prevent a full discharge. The higher level
you set, the higher the cut-off voltage will be.
· When you set it to HIGH, the battery monitor will provide maximum protection for
the battery running the fridge/freezer against excessive/full discharge.
· When you set it to LOW, the battery monitor will allow the fridge/freezer to use
more of the battery energy.
The battery monitor will shut off the fridge/freezer as soon as the supply voltage
falls below the set level. The fridge/freezer will restart after 2 minutes once the
cut-in voltage is reached.
Voltage
NOTE:
Factory default voltage protection level sets to H Mode
Cut-out is the input voltage in which the fridge/freezer will turn off.
Cut-in is the input voltage in which the fridge/freezer will turn on.
High mode
12V DC Cut out 11.3V 10.1V 9.6V
12.5V 11.4V 10.9V
24.6V 22.3V 21.3V
26.0V 23.7V 22.7V
Cut in
Cut out
Cut in
24V DC
Medium Mode Low mode
6. Car Battery Protection Voltage Reference
5
■Cleaning:
• Unplug the refrigerator first to avoid electric shock.
• Use a wet cloth to clean the refrigerator and dry it.
• Do not soak the refrigerator in water and do not wash it directly.
• Do not use abrasive cleaning agents as these can damage the refrigerator.
■Storage:
If you would not use the refrigerator for a long period, please follow the steps:
• Turn off the power and unplug it.
• Remove all the items in the refrigerator.
• Wipe off the water from the fridge with a soft rag.
• Put the refrigerator in a cool and dry place.
• Leave the lid slightly open to avoid odors.
■Defrosting:
Humidity can form frost in the interior of the cooling device or on the evaporator. This
reduces the cooling capacity.
• Turn off the power and unplug it.
• Remove all the items in the refrigerator.
• Keep the lid open.
• Wipe off the defrosted water.
7. Cleaning and Storage
Never use hard or sharp tools to remove ice or to loosen frozen objects.
If an abnormal situation cannot be resolved through simple troubleshooting, please contact
professional customer service for assistance：
If you bought it from Amazon, please contact service@bougerv.com.
If you bought it from BougeRV Website, please contact support@bougerv.com.
Note: In order to resolve the issue, you are expected to attach more details as follows in your
email.
1. The order number.
2. If possible, send us pictures or videos to show the problem.
3. What do you connect with the fridge and what is the power source?
4. Do you notice any error code on the display panel.
5. Your shipping address and phone number for the potential shipment.
8. Troubleshooting and Error Problems
6
The car refrigerator
does not work
Check whether the power is connected correctly
or not.
(If the plug is loose, positive and negative poles
are reversed).
Check whether the power switch on the operation
panel is turned on.
Check the cooling ventilation is normal.
Check whether the fuse is blown or not.
Check whether the door is closed.
The door cover seal is damaged or deformed and
the seal is not strict.
Poor ventilation in the car refrigerator cooling.
Improper temperature settings.
Causes and solutions
Not cooling
Sufficiently
Some noises are normal.
The place of the refrigerator is not stable.
Internal parts are loose or fall off.
Abnormal noise
Troubles
When the ambient air humidity is > 75%, the
surface of the box will normally have slight
condensation.
The refrigerator
surface condensation
It is normal for the temperature to float at a certain
range, and it is normal in the range of ± 5 ℃.
It is normal that the temperature measured by
yourself is 3 ℃ higher than that of the display
screen.
If the temperature does not drop for a long time,
please empty the refrigerator, adjust it to the
lowest temperature and let it stay for a longer time.
Please touch the inner wall of the refrigerator with
your hand. If you can feel the cold obviously, there
is no problem with the refrigeration of the refriger-
ator.
Temperature fluctuation/
problems
7
The definition of the error code on the display
E3
E4
E2 Fan Problem
Compressor
turbine speed
too low
E5
E6
Controller chip
overheating
NTC cable
disconnecting
or in a short circuit
E1 Input voltage
too low
①Scenario one: the input voltage of the adapter is too
low.
Solution: Adjust the battery protection level to
"Medium" or "Low" level. Wait for 3-5 mins to let the
refrigerator reset itself.
If the fridge still does not start properly, Please use the
AC power cord to run the refrigerator.
②Scenario two: Insert the refrigerator power cord into
the car cigar lighter when the car doesn't start.
Solution: Connect the refrigerator later after the car
starts.
Please replace a new fan when you confirm the fan
malfunction. Contact us and we will send you a new fan
for replacement.
The input voltage needs to be adjusted and reconnect
the refrigerator to power.
If the solution is not helpful, please contact us.
You need to shut down the fridge for 5 minutes. After
that, check whether it is an overheating caused by the
blockage around the vent of the compressor.
Pry out the display panel and check whether the NTC
cable is disconnecting.
If the solution is not helpful, please contact us.
①Scenario one: E3 appears when using the fridge in the
car.
Solution: Shut down the fridge for 5 minutes. If it still
does not work after you restart it, then it is an E1 fault,
please refer to the E1 troubleshooting and solution.
②Scenario two: E3 appears when using the fridge at
home.
Solution: Adjust battery protection level to Medium or
Low level. If the fridge still does not start properly, Please
use the AC power cord to run the refrigerator.
If the solution is not helpful, please contact us.
Compressor Start
up frequently
Input voltage fault
Error Code Error Type Solutions
8
Ce manuel convient aux modèles suivants
3
Table des matières
Langues :
Autres manuels BougeRV Réfrigérateur
