BOSSCO DS-1 Manuel utilisateur
1
Owner's Manual
DCAC
AC & BATTERY
POWERED
FET
2
Thank you, and congratulations on your choice of BOSS DS-1 Distortion.
Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY”
and“IMPORTANTNOTES”(separatesheet).Thesesectionsprovideimportantinformation
concerningtheproperoperationoftheunit.Additionally,inordertofeelassuredthatyou
havegained agood graspof everyfeature providedby yournew unit,this manualshould
be read in its entirety. The manual should be saved and kept on hand as a convenient
reference.
Copyright © 1994 BOSS Corporation
All right reserved. No part of this publication may be reproduced in any form without the
permission of BOSS Corporation.
3
FEATURES
The DS-1 is an effect unit that generates both distortion and sustain effects.
By rotating the knobs you can create all kinds of sounds, from warm, soft sustain to hard,
powerful distortion.
The DS-1 can be powered by a battery or an optional AC adaptor.
4
PANEL DESCRIPTIONS 1. AC Adaptor Jack
Acceptsconnection ofan ACAdaptor (op-
tionally available BOSS PSA-Series). By
usinganACAdaptor,youcanplaywithout
being concerned about how much battery
power you have left.
* You may find that it is a good idea to keep a
battery installed in the unit even while using
an adaptor. That way your playing won't be
disrupted even if the adaptor is accidentally
disconnected.
* If you are going to use an AC adaptor, be sure
to use the specified unit (BOSS PSA-Series).
Use of any other adaptor may result in dam-
age, malfunction or electric shock.
Also, if you are not going to be using it for an
extended period of time, disconnect the AC
adaptor from the AC outlet.
1
2
3
4
5
6
5
2. CHECK Indicator
This indicator shows whether an effect is
ON/OFF, and also doubles as the Battery
Check indicator.
The indicator lights when an effect is ON.
Ifthisindicatorgoesdimornolongerlights
while an effect is ON, the battery is near
exhaustion and should be replaced imme-
diately.
* TheCHECKindicatorshowswhethertheeffect
is being applied or not. It does not indicate
whether the power to the device is on or not.
3. OUTPUT Jack
The output jacks are used to connect the
unit to amplifiers or other devices.
4. Pedal Switch
This switch turns the effects ON/OFF.
5. Thumbscrew
This thumbscrew is loosened to open the
pedal, allowing battery replacement. For
instructions on how to replace the battery,
please refer to “Changing the Battery.”
6. INPUT Jack
This jack accepts input signals (coming
from a guitar, some other electric or elec-
tronic musical instrument, or another ef-
fects unit).
* The INPUT jack also serves as the power
switch.Poweris turnedonwhenever aplugis
insertedintotheINPUTjack, andisturnedoff
when the plug is disconnected. When not
using the unit, you should disconnect any
cord connected to the INPUT jack.
6
TONE Knob
Thisknobcontrolsthetoneofthedistortion
sounds. Rotating the knob clockwise cuts
lower frequencies, creating sharp sounds.
Rotating the knob counterclockwise cuts
higherfrequencies,creatingsofter,warmer
sounds.
DISTORTION Knob
This knob controls the depth of distortion
soundsandthelengthofsustainedsounds.
Rotatingtheknobclockwisecreatesdeeper
distortion and a longer sustain time.
LEVEL Knob
This knob adjusts the level of the effect
sounds.Set the knobso there isno volume
difference between the effect and straight
guitar sounds.
DISTORTION Knob
LEVEL Knob
TONE Knob
7
MAKING THE CONNECTIONS
AC Adaptor (PSA-Series; Optional)
Electric Guitar
Amplifier
OUT 9V DC/ 200mA
* Inserting a plug into the Input Jack will automatically switch the unit on.
*Beforeconnectingordisconnectinganypatchcords,besureallthevolumecontrolsinyoursystem
are set to minimum. This will help prevent any damage to system components.
8
OPERATING THE UNIT
1.After you have made the necessary con-
nections, set the knobs as shown in the
illustration.
2.Depress the pedal switch to turn the
effect on. (Make sure that the CHECK
Indicator lights.)
3.Adjust the depth of distortion with the
DISTORTION Knob.
9
4.AdjustthedistortiontoneusingtheTONE
Knob. 5.Set the LEVEL Knob so there will be no
volume difference between the effect
sounds and the straight guitar sounds.
10
CHANGING THE BATTERY
Whenthe indicator goes dim or no longer lights
while an effect is on, it means that the battery is
nearly dead and must be replaced.
Replace the battery following the steps below.
1.Loosen the thumbscrew at the front of the
pedal,thenliftthepedalupwardstoopenthe
unit.
* The thumbscrew can be left in the pedal
while changing the battery.
2.Removetheoldbatteryfromthebatteryhous-
ing,andremovethesnapcordconnectedtoit.
3.Connectthesnapcordtothenewbattery,and
place the battery inside the battery housing.
* Be sure to carefully observe the battery+s
polarity (+ versus -).
4.Slipthecoilspringontothespringbaseonthe
back of the pedal, then close the pedal.
*Carefullyavoidgettingthesnapcordcaught
in the coil spring.
5.Finally, insert the thumbscrew into the guide
bush hole and fasten it securely.
Thumbscrew
Pedal
Spring Base
Coil Spring
Guide
Bush
Hole
Battery
Housing
Battery Snap Cord
Battery Snap
9V Battery
Autres manuels pour DS-1
3
Table des matières
Autres manuels BOSSCO Pédale musicale
BOSSCO
BOSSCO SD-1 Manuel utilisateur
BOSSCO
BOSSCO Chorus CE-3 Manuel utilisateur
BOSSCO
BOSSCO VE-500 Manuel utilisateur
BOSSCO
BOSSCO OD-2R Turbo Over Drive Manuel utilisateur
BOSSCO
BOSSCO VE-2 Manuel utilisateur
BOSSCO
BOSSCO SYB-5 Manuel utilisateur
BOSSCO
BOSSCO ME-80 Manuel utilisateur
BOSSCO
BOSSCO DS-1W Manuel utilisateur
BOSSCO
BOSSCO MD-2 Manuel utilisateur
BOSSCO
BOSSCO Super Chorus CH-1 Manuel utilisateur
BOSSCO
BOSSCO GT-100 Guide de configuration
BOSSCO
BOSSCO AW-2 Auto Wah Manuel utilisateur
BOSSCO
BOSSCO AC-3 Manuel d'utilisation et d'entretien
BOSSCO
BOSSCO PSM-5 Power Supply & master switch Manuel utilisateur
BOSSCO
BOSSCO RPH-10 Manuel utilisateur
BOSSCO
BOSSCO ME-33 Manuel utilisateur
BOSSCO
BOSSCO V-Wah PW-10 Manuel utilisateur
BOSSCO
BOSSCO CS-3 Manuel utilisateur
BOSSCO
BOSSCO BF-2 Flanger Manuel utilisateur
BOSSCO
BOSSCO FV-50L Manuel utilisateur
Manuels Pédale musicale populaires d'autres marques
Matthews Effects
Matthews Effects Whaler V2 Manuel utilisateur
Grid 1
Grid 1 Pedal Jeanie Manuel utilisateur
Amptweaker
Amptweaker tightboost Manuel utilisateur
Ibanez
Ibanez TS-808 Tube Screamer Overdrive Pro Manuel utilisateur
PuzzleSounds
PuzzleSounds DR. Q ENVELOPE FILTER Manuel utilisateur
BYOC
BYOC Analog Chorus Manuel
