www.heatairwelder.com www.plasticweldingtool.com
Email:chinabosite@yahoo.cn Tel:0086-1516740071 1
Application
Application
Application
Application scope
scope
scope
scope
1. Thermoplastic plastic HDPE.PP. PVDF, especially PE can show the characteristic best.
2.
It
is forbidden to use for electric conduction plastic (PE-EL), which can bring electric conduction short circuit of
machine.
3.
It
can once weld the line with width of more than 10mm and plastic board with 40mm below.
4. This machine is used for the fourth part of the barrel bath and the tub and accords to the standard of the
DVS(Germany Welding Association)
Operation
Operation
Operation
Operation instructions
instructions
instructions
instructions
1. Put the tool to the placement frame, fit with the handle, plug the main pin,
2. Switch the power supply of the hot welder on, set the temperature around 300 ° C when welding, when it is
below 270 ° C, motor would be shut off, above 270 ° C, turn on the motor, it start working. Switch on the hot air
gun, adjust the temperature knob, and then the material in the welding nuzzle will be soften when heat up
about 7 to 8 minutes.
3. Button the switch of the motor and then the motor begin to rotate. Big noise may caused by the resonance
between the machine and seat or the intensity of spare parts inside the machine.
If
the motor move smoothly
and the inside noise disappeared after feeding the material , it is qualified.
4. After motor start up, Keep the machine standby for around 5 to 6 minutes, then feed the welding rod. Adjust the
temperature knob until the plastic rod is totally soften.
5.
It
will rotate easily without plastic rod. While it is heavy after feeding material.
If
it become too heavy, stop the
machine immediately, maybe it is heated not enough.
6. Different welding shoes for different welding method, two standard welding shoes is provided.
7. Press the machine to the welding joint. Extruding few rod to heat the welding shoe, and make the welding joint
surface not smooth.
8. The welding joint performance would be effected by welding speed, material feeding, welding angle and the
design of welding shoe. The strength of the welding joint is depends on the temperature and air volume of
pre-heating. the heat temperature normally is about 260 ’ C-400 ’ C. And, the faster it moves, the higher
temperature it needs.
9.
To
set the suitable temperature is very important, heat the welding material until it loose its original shiny is
enough.
10. Don ’ t knock the chromosorb welding head hardly when replacing it.
It
is better to heat up for a while.
11. Please replace the carbon brush of the heat blast motor in advance since the span is about 800 hours. Pls
change it before it is used up.
12.
It
should adjust the temperature of the heat blast knob to the lowest point when the machine stop using. And it
shouldn ’ t turn the wind motor off until blowing several minutes.
13.
It
keep some welding rod in when stop the machine for fear of the scratch when extruding the screw racing
screw roller.
14.
It
must clean the material in the glue tongue when open the machine.
Maintenance
1.
It
will be fixed for one year since the product BOSITE -5001A Extruding welder is sold out .
2. Users should check the machine whether it is in good shape or not, if it is no news within two days, it will be
viewed as tact and pass the check
