Bosch GCC 30-4 Professional Instructions de montage
IMPORTANT:
Read Before Using
IMPORTANT :
Lire avant usage
IMPORTANTE:
Leer antes de usar
For English Version
See page 2 Version française
Voir page 19 Versión en español
Ver la página 37
Call Toll Free for
Consumer
Information and Service
Locations
Pour obtenir des informations et les
adresses de nos centres de service
après-vente, appelez ce numéro gratuit
Llame gratis para obtener in-
formación para el consumidor
y ubicaciones de servicio
Operating/Safety Instructions
Consignes de sécurité/d’utilisation
Instrucciones de funcionamiento y seguridad
1-877-BOSCH99 (1-877-267-2499) www.boschtools.com
GCC30-4
2
Safety Symbols
The definitions below describe the level of severity for each signal word. Please
read the manual and pay attention to these symbols.
!
This is the safety alert symbol. It is used to alert
you to potential personal injury hazards. Obey
all safety messages that follow this symbol to
avoid possible injury or death.
DANGER indicates a hazardous situation which,
if not avoided, will result in death or serious in-
jury.
WARNING indicates a hazardous situation
which, if not avoided, could result in death or
serious injury.
CAUTION, used with the safety alert symbol,
indicates a hazardous situation which, if not
avoided, will result in minor or moderate injury.
3
Only use batteries listed in this operating manual. Do
Only use Button/coin cell 3V lithium CR2032 battery.
Do not use any other button/coin cells or other forms of electrical power supply.
Ensure that battery replacement is carried out prop-
erly. There is a risk of explosion.
Chemical Burn Hazard. Keep batteries away from chil-
dren. This product contains a lithium button/coin cell bat-
tery. If a new or used lithium button/coin cell battery is swallowed or enters the
body, it can cause severe internal burns and can lead to death in as little as 2 hours.
If you think a battery might have been swallowed or placed inside any part of the
body, seek immediate medical attention.
Always completely secure the battery compartment
cover. If the battery compartment cover does not close
securely, stop using the product, remove the battery, and keep it away from chil-
dren.
When discarding batteries, insulate the ‘+’ and ‘–’ ter-
minals with insulating tape. When disposed of improp-
erly, lithium batteries may short, causing them to become hot, burst or ignite.
Never dispose of the batteries in a fire or expose to
high heat. The batteries may explode.
Do not attempt to recharge the batteries and do not
short circuit the batteries. The batteries may leak, ex-
plode, catch fire and cause personal injury.
Follow all instructions and warnings provided by your
Bluetooth® device manufacturer. Failure to follow rec-
ommended procedures could result in personal injury or property damage.
GCC30-4 is equipped with a radio interface. Local op-
erating restrictions, e.g. in military sites or hospitals,
are to be observed. Transmitters have demonstrated an ability to unintentionally
interfere with other devices.
THINK SAFETY
SAFETY IS A COMBINATION OF OPERATOR COMMON SENSE AND ALERTNESS AT
ALL TIMES WHEN THE CONNECTIVITY MODULE IS BEING USED.
General Safety Rules
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
4
FCC Caution
The manufacturer is not responsible for radio interference caused by unauthorized
modifications to this equipment. Such modifications could void the user’s author-
ity to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that
may cause undesired operation.
NOTE! This equipment has been tested and found to comply with the limits for
a Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdierentfromthattowhich
the receiver is connected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
“Exposure to Radio Frequency (RF) Signals: The wireless device is a radio trans-
mitter and receiver. It is designed and manufactured not to exceed the emission
limit for exposure to radio frequency (RF) energy set by the Ministry of Health
(Canada), Safety Code 6. These limits are part of comprehensive guidelines and
established permitted levels of RF energy for the general population.
These guidelines are based on the safety standards previously set by international
standard bodies. These standards include a substantial safety margin designed to
assure the safety of all persons, regardless of age and health.
This device and its antenna must not be co-located or operating in conjunction
with any other antenna or transmitter.
SAVE THESE INSTRUCTIONS
5
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Op-
eration is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
SAVE THESE INSTRUCTIONS
6
Description and Specifications
1Battery compartment cover
2Groove on the battery compart-
ment cover
3Module housing
4Battery
5Battery compartment key
6Cable clip GCA30-4
7 Gasket*
8Data matrix code*
9Protective film*
10 Battery compartment*
*Not shown
4
6
5
1
3
2
7
Specifications
Model GCC30-4
Bluetooth® module TI CC2640
Operating temperature 14 °F…+ 104 °F
(–10 °C...+40 °C)
Storage temperature -4 °F…+ 158 °F
(–20 °C...+70 °C)
Degree of protection IP 67 (water-tight)
Dimensions 1⅓” x 1¼” x ½”
(34 x 32 x 13 mm)
Weight according to EPTA-Pro-
cedure 01:2014 0.7 oz. (0.02 kg)
Data transmission
Bluetooth® Bluetooth® 4.2 (Low Energy)A
Signal Interval 8s
Signal Range 100 ft. (30 m)B
Frequency range used 2402–2480 MHz
Output power <1mW
Power Supply
Battery Button/coin cell (3 V lithium battery,
CR2032)
Battery service life, approx. 36 months
AThe mobile terminal device must be compatible with Bluetooth® Low Energy de-
vices (version 4.1) and support the Generic Access Profile (GAP).
BThe signal range may vary greatly depending on external conditions. The Blue-
tooth® range may be significantly weaker inside closed rooms and through me-
tallic barriers (e.g. walls, shelving, units, cases, etc.)
IC: 909H-GCC304
FCC: TXTGCC30-4
8
System Requirements
Mobile terminal device
(tablet, smartphone) Android 4.3 (and above)
iOS 8 (and above)
Bluetooth® 4.0 (and above)
PC Windows Vista, 7, 8, 8.1
Linux Mint 17, Ubuntu 14.10, Debian GNU/Linux
7.0, Mageia 4, Fedora 21
Mac OS X 10.7 to 10.10
Browser Internet Explorer 10 (and above), Firefox 28 (and
above), Chrome 26 (and above), Safari 7.0 (and
above)
9
Assembly and Preparations
Registering and setting up the app/web-based applications
Before you can use the GCC30-4, you need to register with TrackMyTools online.
• Openthewebsitewww.bosch-trackmytools.com and register.
After registration is complete, you will receive your access information.
Bosch offers a special application (app) or web-based application for managing
the inserted GCC30-4 module and determining its location. Note: Tool presence
is indicated within the range of the GCY30-4 Bluetooth™ transmitter, it is not pro-
vided by GPS.
• DownloadtheTrackMyTools app/web-based application via the appropriate
app store (Apple App Store, Google Play Store) or access the web application
at https://web.bosch-trackmytools.com, where you can log in using your ac-
cess details.
You can now create and manage your inventory using the app/web-based applica-
tion.
Help on using the app/web-based application and creating the inventory
Note: First, complete the tutorial for the app/web-based application. This will pro-
vide you with a better overview of the procedure for creating the inventory and
using the software.
– Scan the data matrix code 8on the side of the GCC30-4 module using the
TrackMyTools app (Fig. A).
This means that the GCC30-4 module is clearly identified and can be assigned
to an inventory set up in the software.
8
A
10
Never remove the battery compartment cover and the
battery with an unsuitable object such as a screw-
driver or needle nose pliers. Using unsuitable objects can damage the electron-
ics or the gasket.
Initial Set-Up
– Using the battery compartment key 5, turn the battery compartment cover
1counterclockwise until the tips of the arrows for the “unlocked” symbol are
aligned (Fig. B).
–
Remove the protective film 9. To do this, press down lightly at the position shown
in the figure C so that the battery compartment cover 1cannot drop down.
1
5
9
9
1
2
2
5
B
C
D
Autres manuels pour GCC 30-4 Professional
1
Table des matières
Langues :
Autres manuels Bosch GPS
