Bosch AMC2-16IOE Manuel utilisateur
AMC2 Extensions
AMC2-16IOE / -8IOE / -16IE
en Installation Manual
Table of contents
1Safety Instructions 5
1.1 Important Safety Notes 5
1.2 Safety Precautions 7
1.3 Unpacking 9
2Important Information 10
2.1 Explanation of symbols in this document 10
2.2 Internet 11
3Introduction 12
3.1 Description 12
3.1.1 Extension AMC2-16IOE 12
3.1.2 Extension AMC2-8IOE 13
3.1.3 Extension AMC2-16IE 14
3.2 Equipment Configuration 15
3.3 Performance Characteristics 16
3.4 System Overview 17
4Installing 19
4.1 Mounting 19
4.2 Unmounting 20
4.3 Opening the Case 21
4.4 Closing the Case 22
4.5 Cabling 23
4.5.1 Conductor data 23
4.6 Grounding and Shielding 25
4.6.1 Grounding for Extension Interface 26
4.7 Connecting Power Supply 27
4.7.1 Direct Power Supply 27
4.7.2 Power Supply via RS-485 Interface 28
4.7.3 Overview - Power supply/consumption 29
4.8 RS-485 for extension modules 32
4.8.1 Addressing 33
4.9 Connecting Relay Outputs 33
4.10 Connecting Analog Input Devices 38
4.11 Tamper Protection 41
AMC2 Extensions Table of Contents | en 3
Bosch Sicherheitssysteme GmbH 2016-11 | AMC2-16IOE |
5Operating 42
5.1 Status Display of the AMC2 42
6Technical Data 44
7Appendices 48
7.1 Connecting Diagrams 48
Index 52
4en | Table of Contents AMC2 Extensions
2016-11 | AMC2-16IOE | Bosch Sicherheitssysteme GmbH
Safety Instructions
Important Safety Notes
1. Read, follow, and retain instructions - All safety and
operating instructions must be read and followed properly
before putting the unit into operation. Retain instructions
for future reference.
2. Do not ignore warnings - Adhere to all warnings on the unit
and in the operating instructions.
3. Accessories - Use only accessories recommended by the
manufacturer or those sold with the product. Accessories
not recommended by the manufacturer must not be used,
as they may cause hazards.
4. Installation precautions - Do not place this unit on an
unstable stand, tripod, bracket, or mount. The unit may fall,
causing serious injury to persons and damage to the unit.
Mount the unit according to the manufacturer’s
instructions.
5. Service - Do not attempt to service this unit by yourself.
Opening or removing covers may expose you to dangerous
voltages or other hazards. Refer all servicing to qualified
service personnel.
6. Damage which requires service - Disconnect the unit from
the main AC or DC power source and refer servicing to
qualified service personnel under the following conditions:
– If the power supply cord or plug is damaged.
– If liquid has been spilled or an object has fallen into
the unit.
– If the unit has been exposed to water and/or inclement
weather (rain, snow, etc.).
– If the unit does not operate normally when following
the operating instructions. Adjust only those controls
specified in the operating instructions. Improper
1
1.1
AMC2 Extensions Safety Instructions | en 5
Bosch Sicherheitssysteme GmbH 2016-11 | AMC2-16IOE |
adjustment of other controls may result in damage,
and require extensive work by a qualified technician to
restore the unit to normal operation.
– If the unit has been dropped or the cabinet damaged.
– If the unit exhibits a distinct change in performance.
7. Replacement parts - If replacement parts are required, the
service technician must use only replacement parts that are
specified by the manufacturer. Unauthorized replacements
may result in fire, electrical shock or other hazards.
8. Safety check - Upon completion of service or repair work
on the unit, ask the service technician to perform safety
checks to ensure that the unit operates properly
9. Power sources - Operate the unit only from the type of
power source indicated on the label. If unsure of the type
of power supply to use, contact your dealer
10. Lightning - For added protection during electrical storms
external lightning conductors can be installed. This
prevents power surges from damaging the unit.
11. The units should be installed in locations with restricted
access.
6en | Safety Instructions AMC2 Extensions
2016-11 | AMC2-16IOE | Bosch Sicherheitssysteme GmbH
Safety Precautions
Read instructions!
Before working with the AMC2 device, read these instructions
carefully. Make sure you have understood all information
described in this document.
!
Warning!
Risk of electric shock
External power supplies must be installed and put into service
by qualified personnel.
Ensure compliance with the relevant regulations.
Ground the controller.
Disconnect both AC and battery power supply before working
on the controller.
!
Warning!
Risk of fire
Installation of the AMC2 device must comply with any local fire,
health, and safety regulations. A secured door that may be part
of an escape route from an area must be installed with:
Install a fail-safe lock (A), so that the door will be released if
power fails. Ideally, use a magnetic lock.
Install a normally-closed break glass or a manual pull (B) in the
lock supply wiring, so that in an emergency the fail-safe lock
can be immediately powered down.
1.2
AMC2 Extensions Safety Instructions | en 7
Bosch Sicherheitssysteme GmbH 2016-11 | AMC2-16IOE |
!
Warning!
Risk of explosion of Lithium battery
The battery can explode if it is replaced incorrectly.
Replace only with the same type as recommended by the
manufacturer.
Dispose used batteries according to the battery manufacturer’s
instructions.
Notice!
Risk of damage to equipment
Protect the hardware from electrostatic discharge by observing
ESD instructions before unpacking of touching connectors of
electronics.
Always switch off power of the AMC2 device before modifying
the installation.
Do not connect or disconnect plug connectors, data cables, or
screw connectors while power is on.
Rules and Conditions
There are no specific requirements as for selling and delivery. As
for storage and safe operation, the environmental temperature
should not exceed the range of 0°C to 50°C.
Disposal
Your Bosch product is designed and manufactured with high-
quality materials and components which can be recycled and
reused.
8en | Safety Instructions AMC2 Extensions
2016-11 | AMC2-16IOE | Bosch Sicherheitssysteme GmbH
This symbol means that electrical and electronic equipment, at
their end-of-life, should be disposed of separately from your
household waste.
In the European Union, there are separate collection systems for
used electrical and electronic products. Please dispose of this
equipment at your local community waste collection/recycling
center.
Unpacking
Check the packaging for visible damage. If anything has been
damaged during transport, please inform the transport agency.
Unpack the unit carefully. This is an electronic device that must
be handled with care to avoid damage. Do not attempt to put
the unit into operation if components are damaged.
If any parts are missing, inform your customer service
representative or a Bosch Security Systems salesperson. The
shipping carton is the safest transport container for the unit.
Store it and the other packaging material for future use. If the
unit has to be sent back, use the original packaging.
1.3
AMC2 Extensions Safety Instructions | en 9
Bosch Sicherheitssysteme GmbH 2016-11 | AMC2-16IOE |
Important Information
Remarks
This hardware is part of a security system. Access should be
limited to authorized persons only.
Some states do not allow the exclusion or limitation of implied
warranties, or limitation of liability for incidental or
consequential damages, hence the above limitation or exclusion
might not apply to you.
Bosch Security Systems retains all rights not expressly granted.
Nothing in this license constitutes a waiver of Bosch’s rights
under the U.S. Copyright laws or any other federal or state law.
If you have any questions concerning this license, please, write
to:
Bosch Sicherheitssysteme GmbH
Robert-Bosch-Ring 5
85630 Grasbrunn
Germany.
Explanation of symbols in this document
Throughout this document, warning messages, important notes,
and helpful tips are presented for the reader. These appear as
follows:
Danger!
Cause of Hazard
Indicates a hazardous situation, which, if not avoided, will result
in death or serious injury.
!
Warning!
Cause of Hazard
Indicates a hazardous situation, which, if not avoided, could
result in death or serious injury.
2
2.1
10 en | Important Information AMC2 Extensions
2016-11 | AMC2-16IOE | Bosch Sicherheitssysteme GmbH
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels Bosch Contrôleurs
Bosch
Bosch MAP Guide de l'utilisateur
Bosch
Bosch 2 Manuel utilisateur
Bosch
Bosch Rexroth IndraDrive MPH-02 Instructions d'utilisation et d'installation
Bosch
Bosch CR 10 Manuel utilisateur
Bosch
Bosch Rexroth IndraDrive C HCS03.1 Manuel technique
Bosch
Bosch WORCESTER Sense II Manuel utilisateur
Bosch
Bosch CL550 Manuel utilisateur
Bosch
Bosch Rexroth IndraControl L40 Manuel technique
Bosch
Bosch CL200 Manuel utilisateur
Bosch
Bosch MS 200 Manuel utilisateur
Bosch
Bosch Rexroth lndraDrive HCS02 Series Manuel utilisateur
Bosch
Bosch HPC Manuel utilisateur
Bosch
Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS Instructions d'utilisation et d'installation
Bosch
Bosch Readykey K6199-CNCii Manuel d'utilisation et d'entretien
Bosch
Bosch CS 550 Manuel utilisateur
Bosch
Bosch KJR-120C1/BTF-E Mode d'emploi
Bosch
Bosch Smart Home Controller AA Manuel utilisateur
Bosch
Bosch REXROTH IndraMotion MLD Manuel utilisateur
Bosch
Bosch System Controller Manuel utilisateur
Bosch
Bosch BRC3100 Manuel utilisateur
