No warranty
Both the manufacturer and the distributors shall not be liable, neither express
nor implied, as to the range of application possibilities of our spot welding
appliance WELDMAN.
We assume no liability for damages resulting directly or indirectly, from the
delivery, use and working results of WELDMAN in connection with a random
choice of materials. In each individual case, the materials and their joining
qualities are to be tested in trial welding, and checked by an expert.
Both the manufacturer and the distributors are liable for damages only within
the framework of legal requirements.
Safety Instructions –please read carefully!
The general safety instructions as quoted here are to be followed during use,
maintenance or repair of this spot welding device. Any disregard of the
instructions or warnings printed in this brochure represents a breach of safety
standards as regards the range of applications for which the welder is designed.
The manufacturer and distributors will assume no liability for any resulting
damage arising from the disregard of these instructions and warnings.
The Welding Unit must have earthing equipment!
This spot welder belongs to Safety Class 1 (provided with protective grounding).
In order to minimize the danger of electric shock, the casing should be
grounded and therefore has to always be operated with a three-conductor cable
with earthing conductor and be connected to a socket installed according to
regulations.
If electrostatic charging cannot be excluded (dry air, floor covering, clothing
made from synthetic material etc.), preventive measures have to be applied. For
example, the welder could be placed on a conductive base which is connected
to the grounding plug socket in the front panel of the welder. The operator has
to touch this conductive base before using the device. If not, there is a
possibility that the switched-on welder will become active in case of electro-
static discharge between the operator and the welder, which however is not in
itself harmful.
If the welder is switched on while both electrodes are in contact with each other,
a short circuit is likely to result. The fuse will react correspondingly. In case of a
supposed fault in the welder it is necessary to check the fuse.
Do not open Casing!
All maintenance and repair to be done by trained service personnel only.
Operator must wear protective goggles!
