1918
ENGLISH ENGLISH
GENERAL SAFETY INSTRUCTIONS
Please read and understand this entire manual before attempting to assemble,
operate or install the product. And save these instructions for future reference.
When using electrical appliances,basic precaution should always be followed to
reduce the risk of re, electric shock, and injury to persons, including the following:
1. Do not operate or store the appliance in humid or wet areas or outdoors.
This appliance is NOT intended for use in boats or moving vehicles. Do not
use any accessories, attachments, consumables, or spare parts (e.g. foils,
bags, vacuum containers) not recommended by the manufacturer. Do not
operate the appliance, when the appliance or any part of it is likely to be
damaged. Damaged or unsuited parts could cause injuries and damage due to
overheating, implosion, and electric shock.
2. Before each operation, ensure that the vacuum chamber is completely
clean. Always ensure that the vacuum pump will not sunk in any liquids.
Immediately cancel the running process by pressing the “HỦY” button, if
liquids are sucked in.
3. Operate the appliance on a well accessible, stable, level, dry and suitable
large table or counter. During operation keep the appliance in an appropriate
distance of at least 10cm on each side. Keep at least 50cm of free space in front
and above the appliance for free access.
4. Do not place any clothes or tissue or other objects under or on the appliance
during operation, to avoid risk of re, electric shock and overheating. Do not
place the appliance or any part of it on or near hot surfaces (e.g. burner, heater,
range, or oven).
5. Keep in mind that the heating bar and sealing bar will get hot during operation.
Do not touch the heating bar and sealing bar with your hands or any delicate
objects shortly after operation.
6. The vacuum sealer is intended for vacuuming and sealing the designated bags,
and vacuum containers only. Insucient or damaged vacuum containers may
burst (implode) when vacuumed, leading to a high risk of injuries and damage
according to splinters and splashes ying around. Unsuited foils, and bags
could cause overheating, and re, or stick down to the sealing or heating bar.
Do not overll the bags or containers to avoid damage and overheating. Do
not place an foreign objects into the appliance. Always handle any vacuumed
containers with special care to avoid injuries and damage due to implosion,
hurling splinters and splashes all about. Do not expose vacuumed containers
to heat or mechanical or thermal shock or direct sunlight.
7. Risk of explosion and re! Do not seal or vacuum containers or bags with
lled with any inammable substances (e.g. alcoholic drinks or food, organic
solvents).
8. Do not use abrasive cleaners or cleaning pads for cleaning the appliance or any
part of it. Do not clean the appliance with any corrosive chemicals (e.g. bleach).
Do not use any hard or sharp-edged objects for operation or cleaning. Always
handle the heating bar, sealing bar, and vacuum gaskets with special care. Do
not place the appliance or any part of it in an automatic dishwasher.
9. If the operator is installed with cardiac pacemaker,please follow the doctor’s
advice before using.
10. Children should be supervised to ensure that do not play with the appliance.
ENVIRONMENT FRIENDLY DISPOSAL
This marking indicates that this product should not be disposaled
with other household wastes throughout the EU. To prevent
possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resource. To return your used device,
please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for
environmental safe recycling.
NOTE
• Equipment is only use for family.
• Power o before clean the equipmen.
•There is NTC temperature control. When the heating wire reach 65 degree, the
lights will ash, and it will stop to work. Usually it takes 10 times for sealing or 20
timers for vacuum and sealing. When the lights ash need to wait for 5 mins and
then go on another work circle.
