ENGLISH ENGLISH
13
14
15
16
17
18
The lling aperture must not be opened during use.
The iron must be used and rested on a stable surface.
When placing the iron on its stand, ensure the support surface is stable.
The iron is not to be used if it has been dropped, visible damaged
or leaked.
Do not repair the unit by yourself because of high voltage inside.
The appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible
for their safety.
FOR STEAM IRON:
When using steam iron, it is recommended to use distilled water.
Burns can occur from iron the hot metal parts, hot water, or steam.
It is cautioned when you turn a steam iron upside down – because
there may still have hot water in the reservoir.
Use steam when temperature knob is at least at “ ”
Do not use chemical additive, scented substances or decalciers.
Failure to comply with the above-mentioned regulations leads
to the loss of guarantee.
NOTE:
When using the iron for the rst time, you may notice a slight emission
of smoke and hear some sounds made by expanding plastics. This
is quite normal and it stops after a short time. We also recommend
passing the iron over an ordinary cloth before using it for the rst time.
FILLING WITH WATER (FOR STEAM- IRONING AND SPRAYING)
SETTING THE TEMPERATURE
Please ll this iron with distilled water before using for the rst
time.
For relling, you can use tap water.
Do not use hard water.
Do not ll the water tank exceed the MAX indication.
The steps for lling water:
Remove the main plug from the wall socket before lling the iron.
Set the steam control to no steam position and temperature
control to“Min” position.
Open the lling funnel.
Pour water into the lling aperture.
Use the measuring beaker with spout for this purpose.
Close the lling funnel.
Set ironing temperature.
PREPARING FOR USE
IMPORTANT:
By default, the Voltage Selector is set to the 220V-240V setting. Be sure
to select the correct voltage for your location before plugging power
cord into an electrical outlet.
1. Stand the iron on its end
2. Set the voltage control to the corret ironing voltage
Please check the voltage of convert switch under the iron (which is
near soleplate), use“key”change voltage for convert the voltage.
2
2
0
-
2
4
0
V
1
1
0
-
1
2
0
V
The iron can be used during 110-120V
1918
