BEH003 User Manual - 6 -
4. INSTRUCTIONS
4.1Bluetooth Headset Fuction
Below functions should be under Headset switch to power on mode.
4.1.1 Power On Bluetooth Headset Function
1. Press and hold the TALK button for at least 3 seconds until 2 beeps are heard
2. At the same time, Green LED flashes 5 times rapidly for a few times
3. The Bluetooth headset is now turned on. Green LED will flash once every 3
seconds.
4.1.2 Power Off Bluetooth Headset Function
1. Press and hold the TALK button for at least 3 seconds until 2 beeps are heard
2. At the same time, Red LED flashes 5 times rapidly for a few times
3. The Bluetooth headset is now turned off.
4.1.3 Pairing the BEH003
Before you can use the BEH003 Bluetooth headset function, you must pair it. To pair the
BEH003 Bluetooth headset function with the Audio Gateway device like as Cell Phone,
you need to:
1. Turning the BEH003 Bluetooth headset function power OFF
2. Press and hold the TALK button. 2 beeps would be heard after 3 seconds. After 4
more seconds, the two LEDs would cross-flash RED/GREEN. Release the TALK
button.
3. The BEH003 Bluetooth headset fuction is now in pairing mode and is ready to be
paired with a Bluetooth-enabled device.
4. Pair the BEH003 Bluetooth headset function with the device according to the
instructions provided by the device’s user guide. The default passkey is ‘0000’.
5. When pairing success, Green LED flashes every 3 seconds. If the LEDs still
cross-flashes RED/GREEN, it means the pairing was failed. You need to go back to
Step 1 and pair again.
