Bloomfield INTEGRITY 8773 Manuel utilisateur
Page 1 of 4
BLOOMFIELD INDUSTRIES
2 Erik Cir. P.O.Box 280
Verdi, NV USA 89439
www.wellsbloomfield.com
Automatic Brewer
Model 8773 w/optional
8881 Airpot
Pour-Over Brewer
Model 8774 w/optional
8881 Airpot
PAPER
FILTER
BREW
CHAMBER
COFFEE BREWER USER GUIDE
Automatic & Pour-Over Airpot Coffee Brewers
Includes Instructions for
Brewing Coffee, Cleaning the Brewer and Deliming the Water Tank
BREW COFFEE
CAUTION: Water from the brew head is extremely hot. Hot
water can cause serious burns.
“READY
TO BREW”
INDICATOR
BREW
SWITCH
HOT
READY
TO BREW
LIGHT
READY
TO BREW
LIGHT
BREW
TANK
HEATER SWITCH
TANK
HEATER SWITCH
OFF ON
ENERGY SAVERENERGY SAVER
TANK
HEATER
SWITCH
HOT WATER FAUCET
TYPICAL AUTOMATIC BREWER
CONTROL PANEL
TYPICAL POUR-OVER BREWER
CONTROL PANEL
“READY
TO BREW”
INDICATOR
READY
TO BREW
LIGHT
READY
TO BREW
LIGHT
TANK
HEATER SWITCH
TANK
HEATER SWITCH
OFF ON
ENERGY SAVERENERGY SAVER
TANK
HEATER
SWITCH
1. Preparation
Press TANK HEAT switch to ON.
When READY TO BREW light glows, water in tank is at proper brewing
temperature.
Place one (1) genuine Bloomfield paper filter in the brew chamber.
Add a pre-measured amount of fresh coffee grounds.
Gently shake the brew chamber to level the bed of grounds.
Slide the brew chamber into place under the brew head.
2. Automatic Operation
CAUTION: Prevent overflow. Always use an EMPTY airpot to
brew coffee. Overflowing hot coffee can cause serious burns.
Place the appropriate EMPTY airpot in place under the brew chamber.
BE sure “READY TO BREW” light is glowing.
Press the “BREW” switch. The solenoid will open for an amount of time
determined by the timer setting, admitting a measured quantity of water into
the basin.
BLOOMFIELD AIRPOT COFFEE BREWERS
Page 2 of 4
3. Pour-over Operation
CAUTION: Prevent overflow. Always use an EMPTY airpot to
brew coffee. Overflowing hot coffee can cause serious burns.
NOTE: Any Integrity™ or Koffee-King™ brewer can be used in the
pour-over mode.
Place the appropriate EMPTY airpot in place under the brew chamber.
BE sure “READY TO BREW” light is glowing.
Fill an airpot or server, identical to the one being used, with tap water.
Lift the pour-over cover and pour the entire contents of the container into
the pour-over opening, which will fill the basin.
4. The Brew:
Water from the basin will displace a like amount of heated water from the
tank. The hot water will be forced into the brew head where it will spray
over the bed of grounds.
Freshly brewed coffee will begin to fill the airpot under the brew chamber.
When the flow and all dripping stops, the coffee is ready to serve.
5. Empty the Brew Basket:
CAUTION: Brew chamber and contents will be very hot.
Use the handle to manipulate the hot brew chamber.
Discard the grounds and the paper filter. Rinse the brew chamber under
clear water.
When the “READY TO BREW” light glows, the brewer is ready for another
brew cycle.
6. Hot Water Faucet (Automatic Brewers Only):
Hot water may be drawn from the hot water faucet at any time by lifting the
red handle. Hot water flow will shut off automatically when the handle is
released.
IMPORTANT:
Excessive use of the hot water faucet during a brew will lower the
temperature of the brew water and compromise the quality of the coffee
product.
Page 3 of 4
BREW HEAD
GASKET
SPRAY DISK
REMOVE
INSTALL
CLEANING
CAUTION: Burn Hazard
Brewing and serving temperatures of coffee are extremely hot.
Unplug brewer and allow to cool before cleaning
CAUTION: Electric Shock Hazard
Do not submerge or immerse brewer or airpots in water.
IMPORTANT:
DO NOT use steel wool, sharp objects, or caustic, abrasive or chlorinated
cleansers to clean the brewer or airpots.
PRECAUTIONS: Disconnect brewer from electric power.
Allow brewer to cool.
FREQUENCY: Daily
TOOLS: Mild Detergent, Clean Soft Cloth or Sponge
Bristle Brush.
1. Disconnect brewer from electric power. Allow brewer to cool before
cleaning.
2. Remove and empty airpot.
3. Remove and empty brew chamber.
4. Remove the spray disk from the brew head. Press up on the spray disk
ears, then turn the disk to the left to unlatch. Remove the gasket from
inside the brew head.
5. Wipe inside of brew head and area around the brew head with a soft clean
cloth or sponge moistened with clean water.
6. Wash the spray disk in a sink using warm water and a mild detergent. A
bristle brush may be used to clear clogged spray holes. Rinse the spray
disk with clean water and allow to air dry.
7. Wash the brew chamber in a sink using warm water and a mild detergent.
A bristle brush may be used to clean the inside. Rinse with clean water and
allow to air dry.
8. Wipe the exterior of the brewer with a soft clean cloth or sponge moistened
with clean water.
10. Reinstall the gasket INSIDE the brew head, then reinstall the spray disk.
11. Reinstall the brew chamber.
12. DO NOT submerge airpots in water. Clean airpots by filling with warm
soapy water. Scrub the inside with a bottle brush. Empty then rinse with
clean water. Wipe the exterior with a soft clean cloth or sponge moistened
with clean water. Invert and allow to air dry.
Procedure is complete
Page 4 of 4
DELIME THE WATER TANK
CAUTION - CHEMICAL BURN HAZARD
Deliming chemicals may be caustic. Wear appropriate protective gloves and
goggles during this procedure. Never siphon deliming chemicals or solutions by
mouth.
IMPORTANT:
This operation to be performed by qualified service personnel ONLY!
IMPORTANT:
DO NOT spill, splash or pour water or deliming solution into or over any internal
component other than the inside of the water tank.
IMPORTANT:
DO NOT allow any internal components to come into contact with the deliming
solution. Take care to keep all internal components dry.
PRECAUTIONS: Disconnect brewer from electric power.
Allow brewer to cool.
FREQUENCY: As required (Brewer slow to heat)
TOOLS: Deliming Solution
Protective Gloves, Goggles & Apron
Mild Detergent, Clean Soft Cloth or Sponge
Bristle Brush, Bottle Brush
Large Sink (or other appropriate work area)
1. Disconnect brewer from the electrical supply. Turn off the water shut-off
valve and disconnect the water supply line from the brewer inlet fitting.
2. Disconnect faucet plumbing. Remove the tank lid assembly.
3. Remove the water tank from the brewer body by lifting straight up. Empty
all water from the tank. Set the tank back into the brewer.
4. Mix 2 quarts of deliming solution according to the manufacturer’s directions.
Carefully pour the deliming solution into the water tank. Lower the lid
assembly back onto the tank. Allow to sit for 30 minutes, or as directed by
the chemical manufacturer.
5. At end of soaking period, remove lid assembly from tank. Thoroughly rinse
internal components of lid assembly with clear water. Using a stiff bristle
brush, scrub the heating element to remove lime and calcium build-up.
Rinse with clean water. Store lid assembly in a safe location.
6. Remove the tank from the brewer and empty. Using a stiff bristle brush,
scrub the interior of the water tank to remove lime and calcium build-up.
Rinse with clean water.
7. Set the tank back into the brewer. Reassemble faucet plumbing to the tank
lid, and the tank lid to the water tank. Make sure the gasket is properly in
place, then reinstall the hold-down strap.
Autres manuels pour INTEGRITY 8773
3
Ce manuel convient aux modèles suivants
1
Autres manuels Bloomfield Cafetière
Bloomfield
Bloomfield E.B.C. 1080 Manuel utilisateur
Bloomfield
Bloomfield POD2 Manuel utilisateur
Bloomfield
Bloomfield Horizon 0420 Manuel utilisateur
Bloomfield
Bloomfield 9311 Manuel utilisateur
Bloomfield
Bloomfield Koffee-King 8540 Manuel utilisateur
Bloomfield
Bloomfield 8792 Manuel utilisateur
Bloomfield
Bloomfield 9221EX Manuel utilisateur
Bloomfield
Bloomfield 8783D3FM Manuel utilisateur
Bloomfield
Bloomfield HD8799 Manuel utilisateur
Bloomfield
Bloomfield E-MAX Manuel du propriétaire
Bloomfield
Bloomfield 8783MCD Manuel utilisateur
Bloomfield
Bloomfield 1016BVM Manuel utilisateur
Bloomfield
Bloomfield Integrity 9010 Manuel utilisateur
Bloomfield
Bloomfield GOURMET 1000 8792 Manuel utilisateur
Bloomfield
Bloomfield 9421 (SS2-HE) Manuel utilisateur
Bloomfield
Bloomfield 9003 Manuel utilisateur
Bloomfield
Bloomfield 8357G Manuel utilisateur
Bloomfield
Bloomfield Koffee-King 8542 Manuel utilisateur
Bloomfield
Bloomfield Gourmet 1000 Manuel utilisateur
Bloomfield
Bloomfield 9003 Manuel utilisateur
