10
4.5 Dispense Water Only:
By pressing and holding the WATER button you can dispense cold water only
as desired. The maximum amount of time the feature will run is 25 seconds.
4.6 Run Blender Motor Only:
This feature can be used in two ways: as a ramp pulse (gradually increasing
speed) or to run a constant speed. To use as a ramp pulse, press and hold the
BLEND button until the drink is completed, the motor will stop when the BLEND
button is released. To run at a constant speed, select the speed (1-9) and then
press and hold the BLEND button. The unit will run until the BLEND button is
released or for 25 seconds.
Section 5: Cleaning and Sanitizing
5.1 After Each Use:
After every use of the unit, the operator should ensure that the blender jar has
been rinsed, the blend station has been wiped out if there is spillage, and that
the blender door is wiped down if there is spillage. Always keep an empty jar
on the blender motor when the unit is not in use. This helps any melt water
that is not captured by the ice hopper drain from splashing onto the blender
motor itself.
5.2 Jar Care:
SHORT TERM – As needed, wash the jars with a mild detergent solution. Do not
immerse the jars for longer than necessary in any type of liquid. Wash quickly
with a smooth cloth or sponge, rinse, and sanitize with appropriate solution.
Some sanitizer manufacturers require their sanitizer to remain in contact with
the sanitized object for a specific amount of time before rinsing or removing.
Refer to your manufacturer’s instructions before rinsing. Hold the jar by the
handle and give three or more sharp downward shakes to remove all water
from around the shaft area. Then place the jar upside down on a rack to dry.
LONG TERM – As needed, fill the jar with hot water and a tablespoon of chlo-
rine bleach or other sanitizer, per manufacturer’s instructions. Stir and let stand
for 5 minutes, then empty. Hold the jar by the handle and give three or more
sharp downward shakes to remove all water from around the shaft area. Then
place the jar upside down on a rack to dry
5.3 Unit Care:
SHORT TERM – Daily or weekly, wipe down the exterior of the unit and the
interior of the blend station with a damp rag. Carefully tilt the machine either
backward or forward (two person operation) and wipe underneath the unit with
a damp rag. Disconnect the drain tube from the back of the unit and run hot
sanitizer solution through the tube to help keep the tube clear.
LONG TERM – Monthly, sanitize the ice hopper and blend station utilizing the
steps below. The best time to perform this cleaning is either before or after
