Blake UK TRI-BEAM48 Manuel utilisateur

Instruction Manual TRI-BEAM48

27380 –48 Element High Gain Tri-Beam Aerial

Kit Contents:

•Aerial

•Screws

•F Connector

•Weather Boot

You will need:

•Flat Head Screw Driver

•Suitable Spanner

Features:

•High performance compact Tri Beam aerial.

•Shorter aerial than similar aerials for lofts or areas

with limited space.

•Optimised design for LTE rejection.

•Partially pre-assembled for ease of installation.

•Male F connection with weather boot and F female connector.

•Very flat frequency response over all operating bandwidths.

•Supplied with weather resistant clamp, suitable for horizontal or vertical polarization.

1. Assemble the aerial

a. Expand the 3 aerial booms.

b. Remove the screw on the back of the aerial (where the 3 booms are secured) and push the plastic spacers together

so the holes match up. Insert the screw through the hole on the plastic spacer and screw in using a flat head screw

driver. This will hold the plastic spacers in place.

c. Repeat step b. with the plastic spacer joining the booms together in the middle of the booms.

d. Assemble the dipole on the single boom at the rear end of the aerial. Remove the bolt and position the dipole into

place. Then, replace bolt and tighten.

e. Push the reflector sections into the rear triangular plastic housing at the back of the aerial ensuring both spring

buttons are located back through the hole.

Instruction Manual TRI-BEAM48

27380 –48 Element High Gain Tri-Beam Aerial

2. Position the aerial.

a. Put the mast clamp on the end of the aerial ensuring it is positioned correctly (vertical or horizontal) and clamp it

onto the mast.

b. Mount the aerial vertically or horizontally dependent on your local transmitter and point the aerial towards it. (Take

care to ensure correct alignment).

c. Prepare the cable end and fit the screw-on F connector provided with the aerial.

d. Push the weather boot over the cable, so it is behind the F connector.

e. Screw the F connector onto the connection and push the weather boot over the connection to prevent water

ingress.

www.blake-uk.com [email protected]m 0114 223 5000

Digital UK Coverage checker http://www.digitaluk.co.uk/ (select detailed view box).

BBC Reception Advice 08700 100123, e-mail recep[email protected]k, web: www.bbc.co.uk/reception

PD2011-4593-08

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Blake UK Antenne

Blake UK

Blake UK LTE800-20 Manuel utilisateur

Manuels Antenne populaires d'autres marques

Alfa Network

Alfa Network APA-L01 Manuel utilisateur

Naval

Naval PR-422CA Manuel utilisateur

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manuel utilisateur

TERK Technologies

TERK Technologies TV44 Manuel utilisateur

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manuel utilisateur

HP J8999A Manuel utilisateur

MobilSat

MobilSat MSP-S Manuel utilisateur

Steren

Steren ANT-UHF 13 Manuel utilisateur

Novatel

Novatel 600-G Manuel d'utilisation

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manuel utilisateur

TRENDnet

TRENDnet TEW-AO12O Manuel utilisateur

Radio Shack

Radio Shack 15-1837 Manuel utilisateur

CommScope

CommScope CMAX-OMFX-43M-I53 Manuel utilisateur

Ramsey Electronics

Ramsey Electronics DAP25 Manuel utilisateur

COBHAM

COBHAM SAILOR 800 VSAT Manuel d'utilisation et d'entretien

Trango Systems

Trango Systems AD900-9 Manuel utilisateur

Steren

Steren ANT-100 Manuel utilisateur

Proxim

Proxim 5054-PA-23 Manuel utilisateur