3. Warnings
To avoid electrical shock, do not use this product with wet hands.
Please carefully read this instruction manual before operation to avoid
any personal injury. Only trained laboratory personnel should operate
the system.
Do not attempt to open or repair the MyGel system. Contact your
distributor or Benchmark Scientific for service.
Always use the MyGel in an environment with low humidity and low dust,
also keep away from water, direct sunlight / strong light, corrosive gas,
high magnetic fields, heaters, fires and other heat sources.
The power switch for the power supply is located on the top
of the control panel, press “I” to power on, “O” to turn off.
Do not detach the power supply module from the migration tank when
the power is on. Attempting to do so can cause damage.
Always turn off the power after operation. When not in use, detach
the power supply and store in an area that is free from moisture
and dust.
7
When operating, do not move or bump the system, do not put your
finger or any other objects into the migration tank.
2. Installation
Place the electrophoresis system on a smooth, level surface.
Connect one end of the power cord to the instrument and the other end to an
appropriate outlet, the input voltage should be between 100~120VAC. When the
input voltage is 220VAC, use the transformer inline.
