BEMIS SANCTUARY 5000 Manuel utilisateur

OWNER’S MANUAL

SANCTUARY

5000

2 3

TABLE OF CONTENTS

PRODUCT INFORMATION

Functions & Settings...................................................4

Parts.........................................................................................8

Diagram................................................................................9

Product Information................................................10

PRODUCT INSTALLATION

Seat Installation............................................................11

Water Connection......................................................12

Remote Installation...................................................13

Installing & Replacing Battery Box...............14

Testing..................................................................................15

PRODUCT OPERATION

How To Use......................................................................17

Maintenance..................................................................21

Specifications................................................................23

Warnings & Safety......................................................24

Troubleshooting..........................................................30

WARRANTY

Warranty............................................................................34

4 5

FUNCTIONS & SETTINGS

FLUSH

Activates flush. The seat must be unoccupied.

FRONT

Press to activate the oscillating front wash.

Press again to turn off oscillation.

REAR

Press to activate the oscillating rear wash.

Press again to turn off oscillation.

STOP

Press to stop any operations.

DRYER

Press to activate the warm air dryer.

Press again to adjust the fan speed.

AIR TEMP | WATER TEMP. | SEAT TEMP.

Press the corresponding buttons to adjust the temperature

settings on each feature.

•Low - Blue

•Medium - Purple

•High - Red

*Press and hold the nozzle cleaning and

dynamic stream buttons

for 3 seconds to turn the automatic open

function on/off.

OPEN/CLOSE LID*

Press to open or close the lid.

OPEN/CLOSE SEAT*

Press to open or close the seat.

6 7

ULTRAVIOLET STERILIZATION

This feature automatically activates after a wash cycle. The seat cannot

be used during this time. This feature can only be activated when the seat

is not occupied.

POWER/STOP BUTTON

Short press to power on or long press to enter standby mode.

Short press while powered on to stop any operations.

•When the power button is blue, it is in UV sterilization mode or in use.

•When the power button is red, it is ready to use.

FUNCTIONS & SETTINGS (CONT.)

DYNAMIC STREAM

Press during a wash to quickly alternate between

hot and cold water. This feature assists in stimulating bowel movements.

NIGHT LIGHT

Press to turn the night light on/off.

NOZZLE CLEAN

Press to extend the nozzle for manual cleaning.

This feature can only be activated when the seat is not occupied.

WATER PRESSURE

The water pressure starts off low. Press the + or - buttons to adjust the

water pressure accordingly.

NOZZLE POSITION

Press the arrow keys to adjust the position of the nozzle accordingly.

AUTO CLEAN

Press to activate a rear wash for 90 seconds, followed by the dryer

function for 4 minutes. Pressing the Auto button a second time during the

wash will skip ahead to the dryer function.

8 9

DIAGRAM

Warm Air Dryer

Nozzle

Heated Seat

Toilet Base

Kick Control

Lid

Hose

Water Supply Valve

T-Valve

Power Cord

Side Buttons

PARTS

Intelligent Toilet

Remote Control

(holder 1pc, screw 2pc)

Wax Ring (1pc) 2 Water Supply

Hoses

T-Valve with

conversion nut

CR2030 Button

Battery (2pc)

Required Tools

Drill (Dia. 0.24in)

Marking Pen 0.91-0.98in

(Spanner model varies

for different pipes)

Screwdriver Measuring Tape

Silicone Gun Teflon Tape Knife

10 11

PRODUCT INFORMATION

Side View Front View Top View

Unit: Inches

Check Your Water Supply

The lowest acceptable water pressure is 0.14 MPa. The highest

acceptable water pressure is 0.75MPa. The toilet cannot reach full

cleaning functionality if the water pressure cannot reach 0.14MPa.

SEAT INSTALLATION

1. Open the box right side

up. Remove the accessories

first, then remove the unit

from the top as shown in

the diagrams above.

2. Place the wax ring and toilet

base and position the wax

ring on the flange. Remove

the access covers and cap

from the water inlet on the

back of the toilet. Align the

toilet over the flange and

bolts. Carefully lower the

toilet into the flange.

3. Secure the toilet base. Press

down evenly on the toilet

to set the wax ring. Install a

washer and nut onto each

bolt. Hand tighten the nuts.

Use a wrench to tighten the

nuts one quarter turn beyond

hand tight.

12 13

WATER CONNECTION

1. Attach the toilet hose to the

T-valve and Sanctuary 5000.

2. Attach the bidet hose

to the T-valve and

Sanctuary 5000.

3. Connect the T-Valve to the

water supply valve.

Bidet hose

REMOTE INSTALLATION

1. Drill two 6mm holes on the

wall that line up with the

remote bracket.

2. Install the wall anchors in the

newly drilled holes.

3. Place the remote bracket over

the wall anchors.

4. Use the provided screws to

attach the remote control

bracket to the wall.

5. Place the remote

control on the bracket.

Wall anchor

Remote Control

Bracket

Remote Control

Screws

14 15

INSTALLING & REPLACING BATTERY BOX

Installing The Battery Box

1. Remove the extension cable from the

back of the bowl (The cable is attached

inside the back of the toilet. Tug it

gently to let it free.)

2. Plug the cable into the battery box.

Then, secure the water-proof nuts.

3. Place the battery box in its proper

position shown on the right. The

batteries and cables are divided into

positive and negative poles. Do not

forcefully connect them. Doing so

may damage the product. If you

have any questions, please call

Bio Bidet by Bemis at 847.458.2334.

Replacing The Battery Box

1. Loosen the battery box screws

and remove the cover. Remove

the battery and safely discard it.

2. Load the new CR-P2 battery and

re-secure the screws.

3. Place the battery box back

into its place.

The battery should be kept out of

children’s reach. Please ensure that the

battery’s polarity is correctly matched. If

they are incorrect it may lead to chemical

leaks or explosions. The battery box is

water proof so please make sure all the

screws are tightly secured to ensure that

the box is perfectly sealed.

TESTING

Testing the Water Flow

1. Open the water supply valve.

2. Check each connection for leaks

3. If leaks occur, turn off the water supply valve and

re-connect the leaking components.

Connecting Power

1. Plug in the power cord.

2. Check to see if the power light is on.

If not, push the reset button.

3. Once the power light is on, the toilet will run its

initial diagnostics: lights will turn on, cleaning

nozzle will extend, the motor will begin to run and

water will run through the system. Once the light is

off, the self-diagnostic is complete.

Testing the Product

1. Are all the functions working properly? Please

test all of the following functions: Posterior Wash,

Front Wash (including water pressure and nozzle

position adjustment), Heated Dryer, Water and

Seat Temperature Adjustment, Nozzle Cleaning,

Deodorization, and Remote Control.

2. To check the posterior wash, place a hand on

the sensor point (shown in the illustration), press

Posterior on the Side Control Panel or the wireless

remote. Use your hand to block the nozzle spray.

seat sensor

16 17

TESTING (CONT.)

Matching Your Remote Control Code

Your remote control will be matched with a code

at the time of delivery. In the case that your remote

control malfunctions, match the codes as per the

following method.

1. Unplug your product. Press and hold the

stop key until the level indicators flicker.

2. Place the remote control close to the product

and plug your product back in.

3. The level indicator should stop flickering and all

lights should be on normally. All level indicators

should light up red (normal).

4. Codes are matched properly when

all lights are on.

HOW TO USE

Power on/off Button

Push the button to power on.

Push and hold the button to power

off. Press during a wash to stop

all operations.

Auto Rear Wash

Press the auto rear wash button.

When seated, press the auto rear

button to start a rear wash for 1 minute,

followed by the dryer function for 4

minutes. If you press the button again

during a wash, it will skip to the dryer.

Auto Front Wash

When seated, press the auto front

button to start a rear wash for 1 minute,

followed by the dryer function for 4

minutes. If you press the button again

during a wash, it will skip to the dryer.

NOTE: After 24 hours, product

will automatically go into power

saving mode and all functions will

shut off. To turn back on, simply

push the Power button on the

Side Control Panel.

18 19

Kick Flush

Tap the Kick Button with your

foot for easy manual flushing.

Wash functions cannot be used

during a flush.

Kick Open/Close the

Lid and Seat

Tap the “Kick Button” with your

foot to raise your toilet seat/lid.

Tap the kick button once:

Lid opens.

Tap the kick button twice:

Seat raises.

Tap the kick button three times:

Seat and Lid will close and the

toilet will flush.

HOW TO USE (CONT.)

Dryer Flush

Press the “Dryer” button.

The warm air function is activated

and a flush is performed.

Blackout Flush

When the product is unplugged,

press the Power/Stop button. If

the toilet is not flushing properly,

replace the battery.

Auto Flush

When the seat sensor no longer

detects a user, it will automatically

flush. The toilet will only

flush once.

Table des matières

Autres manuels BEMIS Toilettes

BEMIS

BEMIS bioBidet HD-7000 Manuel utilisateur

BEMIS

BEMIS bioBidet USPA 6800U Manuel utilisateur

BEMIS

BEMIS bioBidet SLIM THREE Manuel utilisateur

BEMIS

BEMIS WELLSPRING 100 Manuel utilisateur

BEMIS

BEMIS bioBidet DIB Special Edition Manuel utilisateur

BEMIS

BEMIS carrara & matta Smart Lift STA-TITE Manuel utilisateur

BEMIS

BEMIS bioBidet SLIM ONE Manuel utilisateur

BEMIS

BEMIS BIOBIDET BB-550 Manuel utilisateur

BEMIS

BEMIS bioBidet PRODIGY P500 Manuel utilisateur

BEMIS

BEMIS BioBidet SLIM 3 Manuel utilisateur

BEMIS

BEMIS HAVEN 3000 Manuel utilisateur

BEMIS

BEMIS bioBidet BB800 Manuel utilisateur

BEMIS

BEMIS bioBidet DISCVOERY DLS Manuel utilisateur

BEMIS

BEMIS bioBidet Discovery DLS Mode d’emploi

BEMIS

BEMIS bioBidet UB-4800 Manuel utilisateur

BEMIS

BEMIS bioBidet SLIM TWO Manuel utilisateur

BEMIS

BEMIS NextStep Manuel utilisateur

BEMIS

BEMIS bioBidet Pearl S400 Manuel utilisateur

BEMIS

BEMIS PURE CLEAN 5000 Manuel utilisateur

BEMIS

BEMIS bioBidet Bliss BB1700 Manuel utilisateur

BEMIS

BEMIS BIOBIDET SLIM TWO Manuel utilisateur

BEMIS

BEMIS CLICK & CLEAN CLASSIC ABNBCDBL Manuel utilisateur

BEMIS

BEMIS carrara & matta Canyon STA-TITE Manuel utilisateur

BEMIS

BEMIS bioBidet BB-600 Manuel utilisateur

Manuels Toilettes populaires d'autres marques

Toto

Toto Washlet TCF4911 Series Manuel utilisateur

Kohler

Kohler K-6419 Manuel utilisateur

Grohe

Grohe Sensia ARENA Manuel utilisateur

Kohler

Kohler K-5171K Instructions de montage

Geberit

Geberit AQUACLEAN MERA CLASSIC Manuel utilisateur

Kohler

Kohler K-24097X Instructions de montage

Better Bathrooms

Better Bathrooms BUN/BeBa 27555/78725 Manuel utilisateur

American Standard

American Standard CONCEPT Cube TF-2704 Manuel utilisateur

BIOLAN

BIOLAN ECO Manuel de la liste des pièces

Thetford

Thetford C260 Series Manuel utilisateur

KELISS

KELISS T162A Series Manuel utilisateur

Kohler

Kohler K-22241K Instructions de montage

Kohler

Kohler ESCALE K-32771T-NS Manuel utilisateur

BIOLAN

BIOLAN GARDEN TOILET Manuel de la liste des pièces

washloo

washloo Prestige Manuel utilisateur

JABSCO

JABSCO 37010 Series Manuel utilisateur

Drive

Drive TSE 150 Manuel utilisateur

Olympia

Olympia EPOQUE 69209 Mode d’emploi