BT-CT66 Multi-function Wire Tracker
User Manual
(3) Quickly verify the tracking result (only for RJ45 port).
After found the cable, connect the network cable to wire
receiver “UTP” port for pair line detection. For example,
When the “Straight/Cross/Other” lights up, indicates the
verification of the matching cable. The indicator also shows
the type of the cable. The 1-8 and G indicators show the
detection of line sequence by default, and the order in
which the indicator lights up is the sequence of the line.
When connected the cable, the receiver indicator the cable
status by sound, the “di” sound is connected pair lines, the
“du” sound is short circuit pair lines, all indicator lights of
short circuit pairs are on at the same time.
(4) Port continuity and short circuit detection:
Press “MUTE” button, when the indicator light of port is
on, the 1-8 and G indicator lights will show the continuity
of the line of the RJ45 cable connector or within 1 meter
from RJ45 cable connector. As shown on the right, If the
light is on, it means it is connected and vice versa. One
end of network cable connected to the receiver, the other
end is not connected to the emitter, press “Mute”, the
“Port” light on, can test the continuity and short circuit of
network cable.
Application: Connect one end of network cable to Switch,
and the other end connect to RJ45 port of emitter, press “SET” key to switch to the “SWITCH” mode, If the
1236 indicators light on, that is 100M switch, If 12345678 indicators light on, that is 1000M switch.
(5) The UTP port of emitter and receiver can max 60V withstand voltage, the wire can be traced directly in
connection with PoE switch
5.2 UTP detection
5.2.1 Sequence and pair line continuity detection
Step 1: Connect the network cable or telephone cable to the RJ45 port of emitter, and the other end connect to
the UTP interface of receiver. (The wire receiver needs to be turned on)
Step 2: Switch the wire tracker emitter to UTP mode, the 1-8 and G indicators will indicate the sequence of
cable, 100M and 1000M indicator will indicate whether the cable is 100M or 1000M network, the cable receiver
also can see the sequence.
Quickly determine the cable whether is normal through wire tracer emitter or wire receiver, if indicate Direct/
Cross, the cable is normal. After the 8 indicators flashed, the wire receiver will beep to indicate the type of
network cable. One sound is a straight cable, double sound is cross cable, and triple sound is another or wrong
cable.
