Bedfont ToxCO Manuel utilisateur
Instant screening for carbon monoxide poisoning.
Contents
How to perform a bump test with a non-smoker 2
How to perform a bump test with veried gas 3
How to perform a calibraon 4
How to perform a breath test 5
Infecon control plays an important role in the medical device industry, but now
more than ever, we must take extra precauon to ensure the safety of healthcare
professionals and paents alike when performing CO breath tests.
This guide has been put together to help you safely resume CO monitoring.
Aach the regulator to the ToxCO® monitor
If it’s been a while since you’ve used your
ToxCO®, please check the baeries have charge.
Replace them if necessary
As roune maintenance, a bump test should always be performed aer
long periods of no use to check the device is reading correctly. You can
perform a bump test using either a non-smoker or cered gas to ensure
the device is reading correctly.
Once the countdown has nished and the screen prompts
to exhale, open the gas regulator to perform the bump test
Start the breath test on the ToxCO® monitor
Once the reading has stabilised on screen
close the regulator to turn o the gas
Make sure the ToxCO® monitor is reading
between 15 and 22 ppm
If the ToxCO® is not reading between this range,
please calibrate the monitor
To perform a bump test using gas, rstly aach the gas canister
to the gas regulator by screwing the canister into the regulator
How to perform a bump test with veried gas:
As prompted, aach the regulator to the
ToxCO® monitor and follow the onscreen
instrucons to run the calibraon
Open the gas regulator
to perform the test
Close the regulator when the calibraon is nished
To perform a calibraon test, rstly turn on the ToxCO® monitor Press the sengs icon to open the sengs menu
Press the cylinder calibraon icon to proceed Allow the ToxCO® monitor to zero. If the monitor is too cold or hot
please wait for it to come to ambient temperature before connuing
If the the ToxCO® failed its calibraon a red cross will show,
press the retry icon to try again. If unsuccessful consult the troubleshoong
secon of the manual or contact your local distributor for help
If the ToxCO® successfully completed its calibraon a
green ck will show.
How to perform a calibraon:
The ToxCO® should be wiped clean
with the alcohol-free anbacterial wipes provided
with the monitor before and aer each test
A new SteriBreath™ mouthpiece should be
used for each paent. It is best pracce for
the paent to insert their own mouthpiece
Follow the instrucons
on the ToxCO® to complete
a breath test
The paent will be
prompted to inhale and
hold their breath
There will be a 15 second
countdown
The paent will be prompted to exhale
slowly into the monitor, and should aim
to completely empty their lungs
The results will rise and stabilise
onscreen
Allow the paent to throw away their
used mouthpiece
Results can be interpreted using the
AEGLs for Carbon Monoxide
The ToxCO® should be wiped clean with the
alcohol-free anbacterial wipes provided
with the monitor before and aer each test
The external surfaces of the D-piece™
lter should also be wiped down before and
aer each test
D-piece™ should be replaced every 30 days
The external surfaces of the D-piece™ lter should
also be wiped down before and aer each test
D-piece™ should be replaced every 30 days
Bedfont® Scienc Ltd. has put together some advice on how to safely perform breath tests during the pandemic, however,
rst and foremost, it is recommended that you follow your local guidelines on breath tesng procedures and necessary PPE
How to perform a breath test with a mouthpiece:
Bedfont® Scienc Ltd
Staon Road, Harrietsham, Maidstone, Kent,
ME17 1JA, England
Tel: +44 (0)1622 851122, Fax: +44 (0)1622 854860
Email: ask@bedfont.com, Web: www.bedfont.com
Issue 1 - November 2020, Part No: MKT530
Bedfont® Scienc Limited reserve the right to change or update this literature without
prior noce. Registered in: England and Wales. Registered No: 1289798
Bedfont® GmbH
Mierbachweg 18, 5081, Anif, Austria
Tel: +43 662 635050 Fax: +43 662 635050-50
Email: bedfont-gmbh@bedfont.com
The ToxCO® should be wiped clean
with the alcohol-free anbacterial wipes
provided with the monitor before and aer
each test
Assemble the sampling system by inserng the
D-piece™ lter into the ToxCO®, then the sampling
system and nally the face mask. A new face mask
sampling system should be used for each paent.
Follow the instrucons
on the ToxCO® to complete
a breath test
Prompt the paent to inhale
and exhale into the face mask
Sampling will last 60 seconds as the
%COHb/ppm levels rise and hold.
The result will be shown onscreen.
Allow the paent to throw away their
used mouthpiece
Results can be interpreted using the
face mask test interpretaon chart
The external surfaces of the D-piece™
lter should also be wiped down before and
aer each test
D-piece™ should be replaced every 30 days
Bedfont® Scienc Ltd. has put together some advice on how to safely perform breath tests during the pandemic, however,
rst and foremost, it is recommended that you follow your local guidelines on breath tesng procedures and necessary PPE
How to perform a breath test with a face mask:
The ToxCO® should be wiped clean with the
alcohol-free anbacterial wipes provided
with the monitor before and aer each test
The external surfaces of the D-piece™ lter should
also be wiped down before and aer each test
D-piece™ should be replaced every 30 days
Autres manuels pour ToxCO
6
Autres manuels Bedfont Équipement médical
Bedfont
Bedfont Gastro+ Gastrolyzer Manuel utilisateur
Bedfont
Bedfont FENObreath Manuel utilisateur
Bedfont
Bedfont NOBreath Manuel utilisateur
Bedfont
Bedfont Gastro+ Gastrolyzer Manuel utilisateur
Bedfont
Bedfont LungLife Manuel utilisateur
Bedfont
Bedfont NOBreath Manuel utilisateur
Bedfont
Bedfont GastroCH4ECK Gastrolyzer Manuel utilisateur
Bedfont
Bedfont ToxCO Manuel utilisateur
Bedfont
Bedfont FENObreath Manuel utilisateur
Bedfont
Bedfont FENObreath Manuel utilisateur
Bedfont
Bedfont Micro+ Smokerlyzer Series Manuel utilisateur
Bedfont
Bedfont FeNObreath CaliBag Manuel utilisateur
Bedfont
Bedfont NOBreath Manuel utilisateur
Bedfont
Bedfont iCOquit Smokerlyzer Manuel utilisateur
Bedfont
Bedfont Smokerlyzer Series Manuel utilisateur
Bedfont
Bedfont ToxCO Manuel utilisateur
Bedfont
Bedfont GastroCH4ECK Gastrolyzer Manuel utilisateur
Bedfont
Bedfont GastroCH4ECK Gastrolyzer Manuel utilisateur
Bedfont
Bedfont coVita Gastro+ Gastrolyzer Manuel utilisateur
Bedfont
Bedfont Smokerlyzer Series Manuel utilisateur
