R.W. BECKETT CORPORATION
P.O. Box 1289, Elyria, Ohio 44036
R.W. BECKETT CANADA, LTD
430 Laird, Unit 3, Guelph, Ontario, N1G 3X7
Important Notes
—Some device and web browser combinations have difficulty in using a Wi-Fi connection that does not connect
to the internet. If your device successfully connects to the BeckettLink but does not display the webpages,
try these troubleshooting steps: “allow” the connection if your device gives a notification requiring it, use a
different web browser, or temporarily turn off your phone’s mobile data.
—For Warranty or Product Information visit www.beckettcorp.com/product/beckettlink.
—BeckettLink will not transmit any information when the spark igniter in the control is active.
—BeckettLink can only link to one phone or tablet at a time.
—Beckett gas ignition controls can only have the timings and sequences configured during the first 4 hours of
burner operation. After 4 hours of operation, the control configuration is locked. Some controls will have the
configuration locked at the factory to meet specific application requirements.
—If your phone or tablet had automatically connected to a WiFi network prior to powering the BeckettLink,
when power is removed from BeckettLink, your phone or tablet may automatically connect back to the
existing WiFi network. If this happens, you will need to reconnect to the BeckettLink network in your settings.
You could also choose to “forget” the existing network.
—The Troubleshooting and Product Information Link, the Send Email Link and the Beckett Corp. Website Link
will not function while the phone or tablet is connected to BeckettLink. Disconnecting the BeckettLink device
will allow the phone or tablet to access those links using cellular data or a standard WiFi connection.
—Any websites other than http://192.168.1.3 or http://BeckettLink will not work while connected to
the BeckettLink.
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy, and if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
yReorient or relocate the receiving antenna.
yIncrease the separation between the equipment and
receiver.
yConnect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
yConsult the dealer or an experienced radio/TV
technician for help.
To satisfy FCC RF Exposure
requirements for mobile and base
station transmission devices, a separation distance of
8” (20cm) or more should be maintained between the
antenna of this device and persons during operation.
To ensure compliance, operation at closer than this
distance is not recommended.
The antenna(s) used for this transmitter must not be
co-located or operating in conjunction with any other
antenna or transmitter.
This device complies with industry Canada license - exempt
RSS standard(s). Operation is subject to the following two
conditions: (1)This device may not cause interference, and
(2) this device must accept any interference that may cause
undesired operation of the device.
BeckettLink Product page
on www.beckettcorp.com
