BEC Audio
1325 Millersport Hwy (Suite 203) Williamsville, NY 14221
Toll Free 888-556-3998 / Main Office #716-689-0871
·Check for shorts or opens on intercom station cable runs.
·Check for shorts or opens on chime module and door station cable runs. (Continuous
chime will lock up the master. See System Diagnostics.)
·Reset master unit by inserting a paperclip in the reset hole, which is located
behind the door.
·Check that there are not a lot of excess room station cables run behind the
master. Bulky wire may cause master circuit boards to compress against each
other and trigger the buttons.
·Check the total length of run isn't above 350' or system over 1000' total
If there is no radio or intercom audio:
·Check that room switches are not in the “OFF” or “MONITOR” position.
·Check that volume settings and controls are set properly. (See AUDIO
SETTINGS)
·Make sure the “SOURCE” selection is correct.
·Check for shorts or opens on intercom station cable runs.
·Check that room station and patio connectors are terminated correctly.
·Reset master unit by inserting a paperclip in the reset hole, which is located
behind the door.
·Possible defective master.
If the unit has hum, popping, or audible oscillation:
·Check that room station and patio connectors are terminated correctly.
(Remove room stations from the master one at a time to identify the source of
the interference.)
·Check for shorts on intercom station cable runs.
·Check that cable runs are not too close to AC lines.
·Check that room stations and master are not mounted too close to electrical
equipment. (i.e. TV, Cordless phones, microwave oven, etc.)
