BCP SKY1826 Manuel utilisateur
SKY1826
Ver. 2
INSTRUCTION
MANUAL
28.5" Electric Fireplace
• Please retain these instructions for future reference.
• Please read through all instructions before mounting and using this fireplace.
• This fireplace is not intended for commercial use.
• There should be at least 3.5 ft. clearance between this product and the ceiling.
• The cable should only be routed to the bottom right of the heater.
• Only use this heater with an AC power supply with the correct voltage.
• Do not plug in other devices into the same circuit.
• Do not turn the appliance on until it is properly installed.
• Do not leave appliance unattended during use or when plugged in.
• Do not let children operate or go near this appliance.
• Do not let children or small pets near during mounting and installation.
• Do not operate this product if the cord or any parts of this appliance are damaged. Do not attempt to modify
the cord.
• Periodically check the cord and appliance for damage.
• Do not run cord under rugs, furniture, etc.
• Do not allow cord to hang over sharp edges or place near hot surfaces.
•Do not cover or obstruct the heater in any way.
• Do not store flammable liquids near this heater.
• Do not touch this heater when it is in use.
• Never immerse this appliance or cord in water or any other liquids.
• Do not expose this heater to water or humidity.
•Repairs to this appliance should only be performed by a licensed and qualified electrician.
•Disconnect and discontinue use of this appliance if any water damage occurs, or if the unit becomes hot to the
touch, broken, or smokes/smells like smoke.
•Do not dispose of this appliance as unsorted waste. Use special collection facilities for electrical appliances.
NOTE: When the heat function is turned on for the first time, a slight odor may be present. This is normal and
should not occur again.
NOTICE
ON/OFF
DIMMER HEAT
Pg. 2
1 PC
TRIM KIT
1 PC
REMOTE CONTROL
PARTS
APPROXIMATELY
15 MINUTE
ASSEMBLY
2 PERSON
ASSEMBLY
AB
Power Supply
Rated Power
120 V/60 Hz
750 W/1500 W
SPECIFICATIONS
• This appliance has a safety-cut o that will engage if the fireplace overheats. The fireplace will NOT automatically
reset for safety reasons. To reset the appliance, unplug the unit for 15 minutes and then plug it back in.
• This appliance can be controlled by the panel on the unit or the remote.
• Do not press the buttons more than once in two seconds; it takes some time for the fireplace to respond.
HEATER/FIREPLACE OPERATION
• ON/OFF: Turn the heating/ display
eect on and o.
• DIMMER: Controls the brightness
levels. Press to cycle through
dimness levels and the OFF setting.
• HEAT 1/ HEAT 2: Controls the
heating level. Press to cycle through
the low setting (750W), high setting
(1500W), and the OFF setting.
• STANDBY SWITCH: Press to toggle standby on/o. This must be switched on to use the heater/fireplace. It is
located on the right side of the fireplace.
The remote has a 3V CR2025 lithium cell battery included. Remove the
slip between the battery and contacts before operating the remote.
REMOTE CONTROL OPERATION
ON/OFF
DIMMER – Adjust dimmer settings
HEAT – Adjust heat settings
• Press the release and slide open the back panel of the remote.
• Remove the battery.
•Insert a brand new CR2025 battery, ensuring the “+” and “-“ signs are in the correct order.
• Replace back panel.
REPLACING BATTERIES
1
PRODUCT ASSEMBLY Please retain these instructions for future reference.
Slide the part A trim kit into the brackets until
it is securely in place.
ON/OFF DIMMER HEAT1/
HEAT2
ON/OFF
DIMMER HEAT
Pg. 3
Insert the heater into your fireplace mantel.
2
A
All items can be returned for any reason within 60 days of the receipt and will receive a full refund as long as the
item is returned in its original product packaging and all accessories from its original shipment are included. All
returned items will receive a full refund back to the original payment method. All returned items will not be charged
a re-stocking fee.
All returned items require an RA (Return Authorization) number, which can only be provided by a Best Choice
Products Customer Service Representative when the return request is submitted. Items received without an RA
may not be accepted or may increase your return processing time. Once an item has been received by Best Choice
Products, refunds or replacements will be processed within 5 business days.
All returns must be shipped back to the Best Choice Products Return Center at the customer’s expense. If the
reason for return is a result of an error by Best Choice Products then Best Choice Products will provide a pre-paid
shipping label via email. Boxes for return shipping will not be provided by Best Choice Products, and is the
customer’s responsibility to either use the original shipping boxes or purchase new boxes.
Pictures may be required for some returns to ensure an item is not damaged prior to its return. Items returned are
not considered undamaged until they are received by Best Choice Products and verified as such. All damages to
items are the customer’s responsibility until the item has been received by and acknowledge by Best Choice
Products as undamaged.
CONTACT US; WE’RE HERE 7 DAYS A WEEK TO HELP YOU!
WARNING
Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or
loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use,
inadequate maintenance, or neglect of this product.
PRODUCT WARRANTY INFORMATION
bestchoiceproducts.com customerservice@
bestchoiceproducts.com 844.948.8400 LEARN MORE!
• Turn unit o and unplug before any maintenance. Wait at least 15 minutes after unplugging
before cleaning or maintenance.
• Use a vacuum/duster to keep vent area and heater clear of debris and dust.
• Fireplace exterior should be cleaned with a damp cloth or duster.
• Do not use abrasive cleaners or liquids.
CARING FOR YOUR HEATER
• Do not mix alkaline, standard (carbon zinc) and rechargeable (nickel hydride) batteries.
• Do not mix old and new batteries.
• Non-rechargeable batteries should not be charged.
• Rechargeable batteries should be charged under adult supervision only.
• Exhausted batteries should be removed.
• The supply terminals should not be short-circuited.
• Do not put batteries next to or in a heat source (fire, electronic heating device, etc.).
• Do not hit batteries against hard objects.
• Do not submerge batteries in water.
• Batteries should be inserted with the correct polarity.
WARNINGS REGARDING BATTERIES
Table des matières
Autres manuels BCP Cheminée intérieure
