SECTION 1B : inStallation - Heart rate
The heart rate sensors are integrated in the soft elastic belt. For
a correct heart rate measurement, the belt must be positioned
slightly below your chest, directly on your skin.
1. Make the two contact areas moist before you start your exer-
cise.
2. The chest belt needs to be snug to stay in place. Slide the buck-
les to adjust the length of the belt for a snug but comfortable
fit.
3. Press the ANT+ transmitter to the elastic belt on the two push-
button connectors.
Maintenance
- Remove the transmitter from the elastic belt after every use
and dry the push-buttons connectors on the transmitter. Rinse
the soft elastic belt under running water after every use.
- Wash the elastic belt regularly in a washing machine at 30ºC.
Use a washing pouch. Do not spin-dry, iron, dry clean or bleach
the elastic belt. Do not use detergent with bleach or fabric soft-
ener.
- Never put the transmitter in the washing machine!
INSTALLING THE HEART RATE SENSOR
The sensor batteries are pre-installed. When needed, check below illustrations for correct
replacement.
1. Open the battery cover by turning the cover counter clockwise.
2. Insert the battery (CR 2032) with the negative side (-) facing up for 3 seconds. This will
reset the sensor.
3. Insert the battery (CR 2032) with the positive side (+) facing up. Close the battery cover by
turning it clockwise.
Batteries should be disposed of in compliance with local regulations.
» BATTERY REPLACEMENT FOR THE HEART RATE SENSOR
12
6
+
3s
