
4
THERMOMETER TEST
While wearing a protective glove, hold the thermometer by the dial
and insert the stem into boiling water. The needle should quickly move
around the dial and register approximately 212°F/100°C (plus or
minus 5°F/2.78°C). This indicates whether or not the temperature
reading is accurate.
FAULTY THERMOMETER
Do not attempt to use a thermometer if it is not working properly.
Contact Barbour International, Inc. to replace a faulty thermometer
with Model #5025.
PLACEMENT OF THERMOMETER
• Set the clip at least 2-in/50mm below the dial.
• Attach the thermometer to the side of the pot or basket.
• Insert the needle at least 1-in/25mm into the oil.
THERMOMETER
A 12-inch fry thermometer is provided with this stockpot. Always use a thermometer when frying any food products.
A thermometer is a sensitive measuring device which may not work properly if dropped, bent, or twisted. Always
check to be sure the thermometer is working properly before frying. Follow these instructions for proper use:
• Never insert the stem of the thermometer into food. This will cause an incorrect temperature
reading.
• Regardless of the thermometer reading, if oil/grease starts to smoke, STOP COOKING
IMMEDIATELY. The thermometer is not working properly and must be discarded and replaced.
WARNING
Barbour International, Inc. (“Vendor”) warrants to the original retail purchaser of this appliance and no other person, that if this product is assembled and operated
in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in such product shall be
free from defects in material and workmanship. Vendor may require reasonable proof of your date of purchase from an authorized retailer or distributor.
Therefore, you should retain your sales slip or invoice. This Limited Warranty shall be limited to the repair or replacement of parts, which prove defective
under normal use and service and which Vendor shall determine in its reasonable discretion upon examination to be defective. Before returning any parts,
you should contact Vendor’s Customer Service Department using the contact information listed in this manual. If Vendor confirms, after examination, a
defect covered by this Limited Warranty in any returned part, and if Vendor approves the claim, Vendor will replace such defective part without charge. If
you return defective parts, transportation charges must be prepaid by you. Vendor will return replacement parts to the original retail purchaser, freight or
postage prepaid.
This Limited Warranty does not cover any failures or operating difficulties due to accident, abuse, misuse, alteration, misapplication, improper installation
or improper maintenance or service by you or any third party, or failure to perform normal and routine maintenance on the product, as set out in
this owner’s manual. In addition, the Limited Warranty does not cover damage to the finish, such as scratches, surface chips and cracks, discoloration, rust
or other weather damage, after purchase.
This Limited Warranty is in lieu of all other express warranties. Vendor disclaims all warranties for products that are purchased from sellers other that authorized
retailers or distributors. AFTER THE PERIOD OF THE ONE (1)-YEAR EXPRESS WARRANTY, VENDOR DISCLAIMS ANY AND ALL IMPLIED WARRANTIES,
INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. FURTHER,
VENDOR SHALL HAVE NO LIABILITY WHATSOEVER TO PURCHASER OR ANY THIRD PARTY FOR ANY SPECIAL, INDIRECT, PUNITIVE, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES. Vendor assumes no responsibility for any defects caused by third parties. This Limited Warranty gives the purchaser specific
legal rights; a purchaser may have other rights depending upon where he or she lives. Some jurisdictions do not allow the exclusion or limitation of special,
incidental or consequential damages, or limitations on how long a warranty lasts, so the above exclusion and limitations may apply to you.
Vendor does not authorize any person or company to assume for it any other obligation or liability in connection with the sale, installation, use, removal,
return, or replacement of its equipment, and no such representations are binding on Vendor.
WARRANTY