Document Number: 1900-0571 Issue Date: 05/21/13 Revision No: 001 Page: 3 of 39
SPECIFICATIONS ( WI-0091-A )
Bayne THINLINE
®
Premium Lift Systems
A. Rotary Actuator - rack and pinion style design.
• Rack, pinion, and shaft bearings are constantly lubricated by the hydraulic oil for
extended life.
• Body and caps are made of high quality ductile iron.
• Pinion output shaft and racks are made of high tensile alloy steel.
• The rotary actuator provides smooth motion throughout the lift cycle, which results in
longer cart life with virtually no cart damage or abuse.
B. Arm bearings are made of a composite material which provides superior compression
strength along with self-lubrication, thus eliminating the need to grease the arm bearings.
C. The THINLINE
®
lift unit can measure as little as 7 1/8” thick from the back of the
mainframe to the front of the lifter, depending on the types of arms used.
D. The faceplate is normally at 45 degrees in the dump position and extends 10” to 12” from
the back of the mainframe into the hopper or container opening. This places the cart or
barrel 13” to 15” into the truck or container opening thus reducing any potential spillage
of materials.
E. Cycle times for safe, fast, efficient service.
• 6 - 8 seconds for Actuator to rotate up and down.
• 3 - 4 seconds for GRL arms to clamp and unclamp.
Note : Cycle time is controlled by flowrate, as flowrate increases, cycle times decrease.
Warning : Never exceed the cycle times listed above. In order to avoid injury and maintain
manufacturer’s warranty never operate outside of these recommendations.
F. Recommended flow rates are as follows:
• 2 to 2 1/2 GPM for 1100 series units
• 2 to 4 GPM for 2200 series units
G. Hydraulic pressure requirements are as follows:
• 1800-2000 PSI normal working pressure
• 3000 PSI maximum pressure
