Basta Boatlifts 2x2k50 Manuel utilisateur

866-GoBasta gobasta.com

BASTA INC.

8/22

L392-0121A

BASTA BOATLIFTS

OVER-CENTER HYDRAULIC ALUMINUM LIFT

2,000 lb Capacity Per PWC Lift

Model 2x2k50 & 2x2k50W

PAGE 2

Basta Boatlifts are protected by one or more US Patents

www.gobasta.com/patents

DANGER

• Do not exceed the maximum weight capacity speciﬁed for the lift. Maximum weight

capacity can be found on the cover of this manual and on the H frame of the lift.

Improper use or failure to follow this instruction can cause property damage,

serious injury, or death.

• Never use for lifting humans or animals. Improper use or failure to follow this

instruction can cause property damage, serious injury, or death. The lift should only

be used for lifting boats & watercraft.

• Always avoid being under, and maintain adequate clearance from, the lift. Failure to

follow this instruction can cause serious injury or death.

• Always use AGM batteries and follow battery manufacturer’s warnings and instructions.

Improper use, or use of other batteries, have the potential to produce ﬂammable hydrogen

gas which can result in serious injury or death.

• Visually inspect all parts and assemblies for damage or defects prior to assembling lift.

• Install the lift on ﬁrm and level ground.

• Verify the lower frame of the lift is level before each use.

• Do not play on or near the lift.

• Do not service the unit with the watercraft on the lift.

• High pressure hydraulics can penetrate skin. Oil injected into the skin from

high pressure systems can cause severe injury. In the case of injury, seek

medical attention immediately.

• Do not install the lift alone.

• The lift should only be used for lifting boats & watercraft.

• Passengers should stand clear of the lift when the lift is in operation.

CAUTION

WARNING

TABLE OF CONTENTS

PAGE 3

PRODUCT INFORMATION

Model #:

Serial #:

Purchased From:

Date of Purchase:

Contact Name:

Phone #:

Notes:

SAFETY ............................................................................................... P 2

PARTS LIST AND DIAGRAMS ................................................................. P 4-5

ASSEMBLY INSTRUCTIONS .................................................................... P 6-17

OPERATIONAL INSTRUCTIONS ............................................................... P 18

REMOTE CONTROL FOB INFORMATION ................................................... P 19

TROUBLESHOOTING / FAQ .................................................................... P 20

MAINTENANCE ..................................................................................... P 21

MAINTENANCE LOG .............................................................................. P 22

WARRANTY ......................................................................................... P 23

IMPORTANT!

WARRANTY MUST BE

REGISTERED WITHIN 30 DAYS

OF INSTALLATION.

TO REGISTER, SCAN HERE OR VISIT

WWW.BASTABOATLIFTS.COM/SUPPORT

PART NO. DESCRIPTION QTY.ITEM ITEM PART NO. DESCRIPTION QTY.

ITEM ITEMPART NO. PART NO.DESCRIPTION DESCRIPTIONQTY. QT Y.

K200-0125 Leg

DD1

DD2

W117-0001

W105-0012

W111-0019

W111-0022

A431-0040

A431-0039

H310-0008

Foot Pad

Side Rail

118” Base Crossmember (2x2k50)

158” Base Crossmember (2x2k50W)

H-frame, Forward

H-Frame, Aft

Hydraulic Cylinder Assembly

H-Frame Arm, Inner

Bunk Rail Assembly, Left

Bunk Rail Assembly, Right

Base Pivot Bushing

Pivot Block

Bunk Board Assembly (part of JJ, KK)

(4)

Nut, 3/8-16 Nylock SS

Bolt, Hex Head 3/8-16 x 3-1/2 SS

Bolt, Hex Head 5/16-18 x 1.0 SS

Washer, Flat 5/16 SS

Washer, Lock 5/16 SS

Clevis Pin 3/4 x 5.0 SS

Washer, Flat 3/8 SS

Base Pivot Pin SS

Bolt, Hex Head 3/8-16 x 3-3/4 SS

Ring Cotter Pin 3/4 x.091 SS

Anti-Seize Grease Packet

Cotter Pin 5/16

Cotter Pin 3/16 x 2.0 SS

P Pin SS

Bunk Pin SS

Nut, 3/8-16 Nylock Thin SS

Plastic Cap for 2” ID SQ Tube

Clevis Pin, 3/4 x 3.5 SS

Extension Pin SS

Bolt, Hex Head 1/2-13 x 1.0 SS

Bolt, Hex Head 1/4-20 x 1.75 full thread SS

Washer, Lock 1/4 SS

W102-0045

A427-0037

A427-0038

M621-1002

K200-0127

W410-0067

S362-0008

S313-0008

S313-0007

S322-0007

S342-0007

S503-0015

S103-0515

S503-0012

S520-1604

S103-0516

S522-0801

S520-1706

Y356-0003

S532-1801

S503-0020

S362-0108

F730-0021

S503-0013

S503-0011

S103-0705

S103-0338

S322-0006

15 19

23 S313-0013 Flat Washer, SAE 3/4 SS 16

PARTS LIST - BOAT LIFT

PAGE 4

1&2 2&10

20 14

DD 2&10

1&2

1&2 2&10

1&2

DD2

DD1

10&2

(2x2k50W)

(2x2k50)

2&1

20 14

16&2

10&2

2&10

1&2

21&22

21&22 21&22

21&22

MM LL

POWER PACKAGE DUAL

#H653-0015

R812-0016

PART NO.

R283-0002

R310-0001

R310-0002

Remote Control Master Unit

DESCRIPTION

Solar Controller

On/Off Switch

Up/Down Switch

QTY.

ITEM

R815-0011

C243-0003

Solar Panel Assembly

Enclosure

PAGE 5

Symbol Glossary for the following pages:

indicates an illustration for a procedure.

indicates a major part described in the parts list

on pages 4 and 5.

or indicate hardware items shown above and

described in the parts list on pages 4 and 5.

Tools needed for the job:

• Tape measure

• Level

• 9/16 ratchet

• 9/16 box-end wrench

• Large slip joint pliers

• Medium sized adjustable wrench

c+d

9&15&23

9&23

9&15&23

9&23

NOTE: The 3 different holes

shown can be used for pin ‘14’

to allow fine height adjustment

during installation.

Pictured: Steps 1-3

QTY 4: 3/8 x 3.75” bolts (“10”)

QTY 4: 3/8 nylon insert lock nuts (“1”)

QTY 8: 3/8 flat washers (“2”)

QTY 4: leg P pins (“14”)

QTY 4: 1/2 x 1.0” bolts (“20”)

BB 20

2+1

10+2

Feet & Legs (4 Places)

Do not tighten bolt ‘20’

until step 17.

Do not tighten any

hardware until step 13.

Use a small amount of

‘moly’ lube on bolt

threads through the

assembly process.

ASSEMBLY INSTRUCTIONS

(2x2k50)

(2x2k50W)

PAGE 6

Forward Crossmember

3Aft Crossmember

QTY 4: 3/8 x 3.75” bolts (“10”)

QTY 8: 3/8 flat washers (“2”)

QTY 4: 3/8 nylon insert lock nuts (“1”)

QTY 4: 3/8 x 3.75” bolts (“10”)

QTY 8: 3/8 flat washers (“2”)

QTY 4: 3/8 nylon insert lock nuts (“1”)

10+2

1+2

10+2

Assemble lift on level

ground and adjust legs

so that lift base frame

is level during lift

assembly.

PAGE 7

Pictured: Steps 4-6

QTY 8: pivot blocks (“MM”)

Pivot Blocks (8 places)

Use a small amount of

‘moly’ lube on bolt

threads through the

assembly process.

ASSEMBLY INSTRUCTIONS

PAGE 8

H-frame Bushings (fwd & aft)

H-frames (4 places)

QTY 8: THIN 3/8 nylon insert lock nuts (“16”)

QTY 8: 3/8 flat washers (“2”)

QTY 8: 3/8 x 3.5 bolts (“7”)-Note shorter length!

QTY 8: cotter pins (“12”)

QTY 8: base pivot pins (“8”)

QTY 16: plastic bushings (“LL”)

Forward H-frame is

shown. Aft H-frame

installation is the same.

16+2

PAGE 9

Install cylinders with lift

in ‘down’ position.

Cylinders

QTY 2: 3/4 x 3.5” clevis pin (“18”)

QTY 2: 3/4 x 5” clevis pin (“6”)

QTY 4: ring type cotter pins (“11”)

Pictured: Steps 7-9

11+6

11+18

Use a small amount of

‘moly’ lube on bolt

threads through the

assembly process.

ASSEMBLY INSTRUCTIONS

PAGE 10

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Basta Boatlifts Système de levage

Basta Boatlifts

Basta Boatlifts Over-Center 4.5k37 Manuel utilisateur

Basta Boatlifts

Basta Boatlifts Over-Center 18k59 Manuel utilisateur

Basta Boatlifts

Basta Boatlifts Over-Center 10k53 Manuel utilisateur

Basta Boatlifts

Basta Boatlifts Over-Center BM4050SP Manuel utilisateur

Basta Boatlifts

Basta Boatlifts Over-Center 2k40 Manuel utilisateur

Basta Boatlifts

Basta Boatlifts 1.4k60 Manuel utilisateur

Basta Boatlifts

Basta Boatlifts Over-Center 36k60 Manuel utilisateur

Basta Boatlifts

Basta Boatlifts Over-Center 18k59 Manuel utilisateur

Basta Boatlifts

Basta Boatlifts Over-Center 7k51 Manuel utilisateur

Basta Boatlifts

Basta Boatlifts 8k53 Manuel utilisateur

Basta Boatlifts

Basta Boatlifts Over-Center 12k64 Manuel utilisateur

Basta Boatlifts

Basta Boatlifts Over-Center 4.5k37 Manuel utilisateur

Basta Boatlifts

Basta Boatlifts Over-Center 24k60 Manuel utilisateur

Manuels Système de levage populaires d'autres marques

morse

morse 82H-124 Manuel utilisateur

Braun

Braun NL955 Series Manuel utilisateur

haacon

haacon 1889.10 Manuel utilisateur

Protekt

Protekt AT 252 Manuel utilisateur

R. Beck Maschinenbau

R. Beck Maschinenbau HS 600 Manuel utilisateur

Nova Technology International, LLC

Nova Technology International, LLC NAS Series Manuel utilisateur

Genie

Genie Z-60/34 Manuel utilisateur

Screen Technics

Screen Technics INTERFIT Vertical Up Lift Manuel utilisateur

Mortuary Lift

Mortuary Lift ULTIMATE 1000 Manuel utilisateur

Custom Equipment

Custom Equipment Hy-Brid 3 Series Manuel de programmation

Custom Equipment

Custom Equipment Hy-Brid Lifts 2 Series Manuel de programmation

Hy-Brid Lifts

Hy-Brid Lifts HB-P3.6 Manuel de programmation

BERG

BERG BeNomic EasyLeaf Manuel utilisateur

Powermate

Powermate LiftGate LG-3 Manuel utilisateur

Snorkel

Snorkel TM12 Series Manuel utilisateur

Terberg

Terberg OMNIDEKA Manuel utilisateur

Harmar Mobility

Harmar Mobility AL625 Mode d'emploi

Rotary

Rotary SPO16 Manuel utilisateur