CARE AND MAINTENANCE
CLEANING THE POLISHER
1. Ensure polisher is OFF and unplug power cord from the outlet.
2. Clean external surface of cutlery polisher daily using a dampened sponge. Do not
immerse in water or spray with water. Dry the surface with a soft cloth.
3. Open lid and wipe all visible surfaces with a damp cloth to remove dust. Wipe with
a dry cloth.
REPLACING THE GRANULATE
Note: It is recommended to change the granulate approximately every 60 days or 400
hours of operation. May vary with use and cutlery type. CALL YOUR DEALER OR (954)
960-1468 TO ORDER.
1. Unplug polisher from power source.
2. Open top and unscrew large black screw to remove drum lid.
3. Remove used granulate and vacuum out thoroughly.
4. Wipe inside of drum and all surfaces with damp cloth/sponge, then with a dry cloth.
5. Replace drum lid and tighten screw.
6. Close top.
7. Plug power cord into grounded GFCI outlet.
8. Pour 4.4lb of Bar Maid granulate into the chute.
9. Press ON/OFF button to turn polisher ON.
10. For CP-7000 pour second 4.4lb granulate into chute, then 1⁄2of third bag. Over time,
granulate may need to be “topped off.” Keep Granulate in a sealed bag in a dry place.
CLEARING A JAM
Avoiding a jam: Follow Step 5 of Operating Instructions for your model carefully.
WARNING: Surface or cutlery may be hot.
1. Ensure polisher is OFF and unplug power cord
from the outlet.
2. Open top and unscrew large black screw to
remove drum lid.
3. Carefully separate and remove the jammed
cutlery.
4. Replace drum lid and tighten screw.
5. Close top.
6. Plug power cord into grounded outlet.
7. Press ON/OFF button to turn polisher ON and
resume polishing.
SAFETY INFORMATION
THESE CAUTION MARKS ARE LOCATED THROUGHOUT THIS GUIDE.
= Lightning flash within a triangle, is to alert the user of the presence of
dangerous voltage that may create a risk of electric shock. Do not open cover.
No user serviceable parts within.
= The exclamation point within a triangle is to alert the user to:
• “CAUTION” important information regarding the care and use of this equipment
• “WARNING” possibility of personal injury
IMPORTANT SAFEGUARDS! PLEASE READ THIS FIRST
Follow these basic safety precautions when this using electrical appliance to reduce the
risk of fire, electric shock and/or personal injury.
WARNING: Plug unit only into a GROUNDED outlet that matches the voltage/cycle as
listed on the motor. Outlet must be equipped with a UL/CSA approved ground-fault
circuit interrupter (G.F.C.I.).
WARNING: Keep electrical cord clear of water.
WARNING: DO NOT use machine if the power cord is cracked or damaged.
WARNING: DO NOT immerse in water or spray with water.
WARNING: Disconnect from the power source when not in use and before servicing,
clearing a jam or replacing granulate.
WARNING: Do not operate without top and front cover in place.
WARNING: Do not operate polisher without granulate, as floor of drum gets
very hot.
WARNING: Loose clothing, long hair and jewelry can be caught in moving parts,
posing an entrapment hazard.
WARNING: This product can expose you to Bisphenol A, which is known to
the State of California to cause birth defects or other reproductive harm. For more
information go to www.P65Warnings.ca.gov.
CAUTION: Stop operation if yellow operate lamp is off.
CAUTION: Use machine only for the purpose it was intended.
CAUTION: Use only genuine Bar Maid®replacement parts.
