B&D BND87622 Manuel utilisateur
Connect the camera to
power using the AC
adaptor and switch on
Ensure your wireless
router is turned on and
the camera is within
range
AND
WPS
OPTIONAL: insert SD card into camera now for recording
before connecting power (requires FAT32 format, 32GB - 128GB)
Micro SD Card Slot
Open the App
and go into
the settings
Select:
Devices ->
Add Camera
Connect a
new camera
Then select
Wi-Fi Setup.
Before you continue, make sure your Smart Hub is
online and you have the B&D App downloaded to
your smart phone.
STEP TWO
ELECTROCUTION! Be mindful not to drill into existing
wiring as this may result in serious harm and or death.
MOUNT THE CAMERA
STEP THREE
OPEN THE PACKAGING
STEP ONE
ADDING THE CAMERA
STEP FOUR STEP FIVE
tip
tip
CONSIDER: mounting the camera in a position that
provides a clear / unobstructed view.
Place phone
screen in
front of
camera to
register
Select how
your camera
will display
in the APP.
Then select
Save.
Check green light is on,
on camera
CONSIDER: Set up camera rst on a bench,
close to WiFi router, before mounting camera in place.
Rotate the base of the
camera until points “a”
and “b” are aligned, to
remove mounting plate
Install
mounting
plate “a” to
wall or
ceiling with
screws.
a
b
Align points “a” and “b”
to insert camera base to
plate. Rotate clockwise
to secure in place
STEP SIX STEP SEVEN
b
a
Ceiling mounted
cameras, ip
image vertically
from button.
Image settings
can be
adjusted using
the camera
controls on the
stand alone
camera page.
You can receive
notications on
motion and/or
sound detection
and adjust the
sensitivity.
Select:
Settings ->
Devices ->
Your Camera
Manage ->
Detection Settings
CAMERA DETAIL
RESET THE CAMERA
To restore the camera back to factory settings:
1. Hold the Reset button for about 10 seconds with
the camera powered on.
2. Release the button and wait about 30 seconds.
The camera will automatically restart, and restore
factory settings.
CHANGE WI-FI NETWORK
First, setup the Smart Hub on the new network and
then:
1. Open the Smart Hub phone app and remove the
camera from the Smart Hub.
2. Reset the camera using the instruction above.
3. Re-follow the instructions “Adding the Camera”.
FOR WPS SETUP
To use WPS to connect your Camera to your home
network, hold the ‘WPS’ button on the back of the
camera for 2 seconds and then press the WPS
button on your Wi-Fi router within 60secs.
NOTE - Your router must have WPS enabled (refer to
the routers user manual)
After WPS has successfully completed, proceed with
the “Adding the Camera”instructions.
CONFIGURE THE CAMERA
STEP EIGHT
tip
Check out the HELP menu on the home page in the
APP for more instructions
FOR WIRED CONNECTIONS
To connect the Camera to your home network using
a wired connection, connect the Camera to your
router using the Ethernet cable before you follow
the “Adding the Camera”instructions.
1
LAN
WPS/Reset
Power
Power light/
Network light
Micro SD Card Slot
Microphone
Lens
Magnetic Bracket
refer to bnd.com.au for full warranty details.
Table des matières
Autres manuels B&D Caméra de sécurité
