Select INPUT by pressing the INPUT switch on the front of the CS2, or the IN-
UP/DOWN buttons of the remote control RC1, AMP section.
The selected input is displayed in the meter window of the CS2.
During the switching procedure the music signal will be faded down and up again,
thus avoiding hard switching noise.
Whenever the CI-mode is active an additional “XLR-CI” lights up in the display.
Input Selection and Display General Safety Precautions
1. Read this owner's manual.
2. Keep the owner's manual.
3. Pay attention to all imortant safety information an warnings.
4. Follow the manual instructions.
5. Never use the unit close to water or in a humid sourrounding, like basins, a humid
basement, swimming pools...
6. For cleaning use a dry micro fiber cloth exclusively.
7. Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions. If placed in a shelf make shure to keep about 15cm to
each side and 30cm to the top. Do not place the unit in a way covering the bottom
plate like a sofa, a bed, thick carpets or blankets.
8. Do not install the unit near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
9. Do not spoil the safty meaning of earthed AC power cables! The earth contact pin
serves your safety. In case the attached cable does not match to your AC-Line wall
socket, please ask an electrician to replace such outdated wall outlet.
10. Protect the unit's power cord from being walked on or pinched, especially around
the plugs, convenience receptacles, and where it exits the unit's casing.
11. Only use attachments/accessories specified by the manufacturer.
12. Only use the unit with a cart, stand, tripod, bracket, or table specified by the
manufacturer or sold with the unit. If using a cart, exercise caution when moving
the cart unit combination to avoid injury from it tipping over.
13. Unplug the unit during lightning storms or when leaving it unused for extended
periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the
unit itself, its power-supply cord, or plug has been damaged in any way, when
liquids have been spilled onto the unit, when foreign objects have fallen into the
unit, when the unit has been exposed to rain or moisture, when the unit does not
operate normally, or when the unit has been dropped.
15. Plug the AC power cord into an easily accessible AC wall outlet, so it can be quickly
unplugged in case of emergency.
16. Remove the AC wall plug for seperating the unit from the AC power line. The AC
plug should always be accessible.
17. Do not expose the unit to drips or splashes. Do not place any objects filled with
liquids, such as vases, on the unit.
18. Do not place any open fire close to the unit, like candles.
19. This unit was designed to work properly in a temperature range from 15°C to 30°C
and a maximum of 80% humidity.
20. AMP CS2 is heavy, 40 kg or about 88 lb. Please handle with care!
