TrachFlush Quick Guide
Alarms and Information Signals
Frequency ≥28 b/min
Unstable ventilator signal
Cuff pressure above target
Settings OK
Frequency is too high for Spont Flush. If
clinically safe, reduce Rf and try again
Inspect ventilator and press
Flush button to try again
Cuff pressure is above the target pressure,
please wait for TrachFlush to reduced
Please wait, Flush or Spont
Flush will start
Page 4 of 4
Return to Pre-Flush Settings
Make sure to return to Pre-Flush or
Pre-Spont Flush ventilator settings
Instructions for Use
For further guidance or details on how to
use TrachFlush, please see the TrachFlush
Instructions for Use.
Visit: www.trachflush.com/downloads
Or scan
the QR-code
Alarms
Cuff pressure ≥70 cmH2O
Cuff pressure > 50 cmH2O
Cuff pressure < 5 cmH2O
Cuff regulation error
Power off not possible
Cuff deflated > 1 minute
Power is disconnected
Cuff pressure tube disconnected
Decrease cuff pressure
Decrease cuff pressure
Increase cuff pressure
Inspect the cuff for damage
Disconnect airway and cuff pressure
tube from device
Inflate cuff or disconnect and turn off
device
Re-connect the power supply
Connect Cuff Pressure Tube or
change the tube
No ventilator signal
Connect Airway Tube and ventilator
Reading ventilator signal
Device is reading ventilator signal for
changes
Service required
Disconnect device and send to service
Information signals
Flush Control in progress
Flush Control complete
Cuff pressure incorrect
Pressure above PEEP too low
Inspiratory time too short
Wait until Flush Control is completed
Press to return to main screen
If clinically safe, adjust cuff pressure to
the range 15 – 35 cmH2O
If clinically safe, increase pressure above
PEEP to ≥10 cmH2O
If clinically safe, increase
inspiratory time to ≥1,33 s
