AVPro Edge AC-CXWP-KVM-KIT Manuel utilisateur

ac-CXWP-KVM-kit

Quick Start Guide

AVPro Edge’s ConferX Dual Gang Wall Plate presents a Full 4k60 444 KVM solution

for anything from the home oce to the classroom. Fully integrate with today’s

interactive displays using bidirectional USB and ARC up to 40 meters over a single

category cable.

This guide will walk you through the following topics:

• Installation

• EDID Management

• Scaling

• Test Pattern Generator

• IR Control Signals

• RS232 Control Signals

• Audio Extraction

• ARC

• USB Extension

• Troubleshooting

installation

1. Install a CAT5e (or better) cable between the display and the source (be sure

to follow local low voltage code. This varies state to state).

2. The Tx has an HDMI input. Connect this to the output of the source with an

18Gbps HDMI cable

3. The Rx has an HDMI output. Connect this to the input of the display with an

18Gbps HDMI cable.

4. Both the Tx and Rx have an RJ45 HDBT connector. Connect each end of the

installed Category cable to these ports.

5. Install the TX Wall Plate into the dual gang box

6. Connect the orange 2 Pin Phoenix power supply to the RX, setting the RX POE

Switch to the “RX” Position

*NOTE - Only use the included power supply

EDID management/Scaling

The EDID Management Pin Wheel allows

you to manage the input device (typically the

display) to request speciﬁc video resolutions

and/or audio codecs from a source. EDID Pin

Wheel also allows for downscaling for use with newer sources and legacy displays.

HDMI & Bi-Directional USB Extension Kit with HDBas eT technology

Using a small, ﬂathead screwdriver adjust the EDID Pin Wheel to the desired EDID

*”E” Copies EDID from Display and downscales incoming signal to 1080p

Test Pattern Generator (Tx only):

The Test Pattern Generator can be used for testing and troubleshooting

infrastructure, cables, and signal path. This test pattern will be generated at

1080p.

1. Toggle Test Pattern by turning EDID Wheel to “F”

RS 232 Control

RS232 control signals can be sent 2 dierent ways:

1. From the rack using a control system (Control4, Crestron, etc) to the display

2. From the display back to the rack

Audio Extraction (TX Only)

This feature will allow you to extract 2ch audio from the source or ARC in order to

send audio signals to an ampliﬁer or AVR.

You can make a cable, or a premade cable can be purchased separately (AC-

CABLE-3PIN-2CH).

Follow the diagram below if you are making your own cable.

1. Plug the 3 pin connector into either the Tx or Rx (the audio port on both the Tx

and the Rx are always active). The port is labeled “L/R Audio Extraction”.

2. Plug the L/R stereo cables into the audio input of an ampliﬁer or AVR.

3. Set the audio output of the source/display to 2CH PCM

ARC

ARC can return audio from a display upstream to an audio device. ARC on the

KVM Wall Plate is enabled simply by ﬂipping the Audio Extraction Switch to “ARC”.

ARC audio input can be selected using the “Audio IN” switch on the RX device. ARC

audio can be extracted from the TX 2 ways:

1. HDMI Input (ARC): Up to DD+ Atmos*

2. L/R: 2CH PCM Only

Remember, ARC must be enabled in source/display to use over HDMI

*Must be supported by both devices

USB Extension

The AC-CXWP-KVM-Kit can extend USB 2.0 bidirectionally up to 40 meters. USB

Direction is selected by the “USB DIR. SELECT” switch on the RX. Use the USB Type

A ports to extend USB devices to the PC on the opposite USB type B port.

Troubleshooting

1. Try dierent HDMI cables. A defective HDMI cable can bring the entire system

down.

2. If using short HDMI cables (.5m, 1m) try a longer cable. Some short HDMI

cables do not sync well.

3. Use the built in Test Pattern generator to conﬁrm that the infrastructure is

passing a signal

4. Re-terminate the Category cable (even if a cable tester indicates that the

cable is passing signal).

4K Display

Pan tilt

zoom Camera

Table top

conference control

hdmi

cat 6a

usb

bi-directional usb extension

ac-cxwp-kvm-kit

5. Avoid RJ45EZ connectors

6. Check the Category cable length. It may be too long.

7. Remove any excess Category cable and be sure that it is not twisted or

damaged.

8. Bypass any patch panels or punch-down blocks

9. If you are powering the Rx with the power supply and the Tx is not getting

power, try plugging the power supply into the Tx instead. Be sure to double

check the POE switch on the extender

10. If you are still having issues after troubleshooting, feel free to contact our Tech

Support department.

Have a question or need assistance?

Don’t hesitate to contact us!

SUPPORT: +1 605-274-6055

USA TOLL FREE: 877-886-5112

EMAIL: support@avproedge.com

Drivers are available at www.avproedge.com/drivers

Table des matières

Autres manuels AVPro Edge Extenseur

AVPro Edge

AVPro Edge AC-EX70-444-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX100-444-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EXO-444-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX100-444-KIT-GEN Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX100-UHD-T Manuel utilisateur

AVPro Edge

AVPro Edge FRESCO-SIX-A-GEN2 Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX70-UHD-BKT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX40-444-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-CXWP-HDMO-BKT Manuel utilisateur

AVPro Edge

AVPro Edge AVP-AC-EX70-444-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX70-UHD-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX70-444-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX40-444-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-CXWP-MDP-T Manuel utilisateur

AVPro Edge

AVPro Edge AC-CXWP-KVM-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX70-UHD-ARC Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX100-444-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX70-UHD-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX100-444-KIT-GEN2 Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX70-UHD-BKT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EXO-X-KIT Manuel utilisateur

AVPro Edge

AVPro Edge AC-AUDEX-DIGI Manuel utilisateur

AVPro Edge

AVPro Edge AC-DA210-HDBT Manuel utilisateur

AVPro Edge

AVPro Edge AC-EX70-444-T Manuel utilisateur

Manuels Extenseur populaires d'autres marques

SY HDBT-60T Manuel utilisateur

Appsys ProAudio

Appsys ProAudio ADX-16 Manuel utilisateur

Atlona

Atlona RS232 Manuel utilisateur

IDK

IDK OPF-TH1000-A Manuel utilisateur

Enable-IT

Enable-IT 824WP Manuel utilisateur

Worx

Worx Landroid RadioLink WA0864 Fiche technique

TP-Link

TP-Link TL-WA730RE Manuel utilisateur

Camplex

Camplex CMX-HDMI-SFPL Manuel utilisateur

SC&T

SC&T HE03-4K Manuel utilisateur

Marmitek

Marmitek MegaView70 Manuel utilisateur

Samsung

Samsung SCS-26UC4 Manuel utilisateur

Foxun

Foxun SX-GES24 Manuel utilisateur

MuxLab

MuxLab 500771 Manuel utilisateur

foxunhd

foxunhd SX-AEX01 Manuel utilisateur

TERK Technologies

TERK Technologies LFIRX2 Manuel utilisateur

Devolo

Devolo Audio Extender Manuel

Edimax

Edimax EW-7438RPn V2 Manuel utilisateur

Shinybow USA

Shinybow USA SB-6335T5 Manuel utilisateur