AVer H300 Manuel utilisateur

AVer H300/H100 Installation Guide

Thank you for choosing AVer video conferencing solutions. This hardware installation guide serves as a reference for making the connections

needed to get your new system up and running as quickly as possible.

Make sure all devices are powered o. Follow the illustrated connection diagrams below and also refer to the user

manual of the device you are connecting to the video conferencing system.

Connect the VGA input port of the display device to either VGA OUT 1 (main system) or VGA OUT 2 (Table Hub). Both

VGA OUT 1 and VGA OUT 2 can be used at the same time. Shared data and captured images will be displayed thru VGA

OUT 2 when implementing dual display mode.

1. Before making the connections

2. Connecting a VGA Display Device (Recommended Connection Method)

3. Connecting a TV Display Device (Alternate Method)

formerly

AVerMedia In formation

Locate the S-VIDEO, VIDEO, or SCART RGB input of the TV/LCD monitor and connect it to AVer H300/H100 using the

appropriate cable.

• Make sure the NTSC/PAL switch is set to the proper TV format.

• For better video quality, we recommend using the S-VIDEO connection if available.

Locate the CAMERA port on the camera and connect it to the CAMERA port of the main system.

• The included 26 Pin-D Sub cable (DB26 female/female) is 5 ft long

Connect the HUB I/O port of the table hub to the HUB I/O port of the main system using the included D-Sub cable.

• The included 26 Pin-D Sub cable (DB26 male/male) is 15 ft long

4. Connecting the Camera and Main System

5. Connecting the Table Hub and Main System

Contact Support

Tel: (877)528-7824

Email: support.cpdusa@aver.com

www.averusa.com/communication

No part of this document may be reproduced or transmitted in any form, or by any means without the prior written permission of AVer

Information Inc. AVer Information Inc. reserves the rights to modify its models, including their characteristics, specifications, accessories and

any other information stated herein without notice. The official printout of any information shall prevail should there be any discrepancy

between the information contained herein and the information contained in that printout.“AVer”is a trademark owned by AVer Information

Inc. Other trademarks used herein for description purpose only belong to each of their companies.

Locate the MIC IN port of the Table Hub and use the supplied 6P4C cable then connect it to the speakerphone mic port.

• The included Mic cable (6P4C) is 10 ft long

Use an RJ-45 Ethernet cable to connect the LAN port of the Main System to a RJ-45 wall jack or Ethernet hub.

• Make sure to connect it to an IP-based network

Connect the power adapter to a standard 100V~240V AC power outlet.

• To prevent shock, make sure all other ports in the main system are connected before connecting and turning on the power

• Make sure to use the supplied 19V power adapter

6. Connecting the MIC

7. Connecting the LAN and the Power

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels AVer Système de conférence

AVer

AVer EVC Series Manuel utilisateur

AVer

AVer EVC100 Manuel utilisateur

AVer

AVer H series Manuel utilisateur

AVer

AVer HVC310 Manuel utilisateur