Installation Instructions AV-706 & AV-701
Step Four (optional): Connecting more than one keypad
For connecting more than one keypad to the same control panel, first refer to the “Control
Panel Manual” for maximum keypads allowance. Connect all keypads in parallel to the
control panel, by running wires from each keypad directly to control panel. Don’t run wires
from one keypad to another and then to control panel – this wiring way cause problems.
Step Five: Closing the keypad
Before closing, check the keypad(s) to make sure they operate properly, arrange wires to be
compact as possible at the rear housing, left side.
To connect the front keypad to mounted part, fit the two lower slots (note 2 at fig.2) onto the
two protruding tabs on the mounted bottom part, push front part forward and press firmly
until top slots and tabs snap together. Make sure that all sides are securely closed.
Note: There are two additional small tabs on upper and lower inner sides of the housing. These
tabs ensure tighter closure. However, if you encounter difficulty in closing the unit,
you can cut off the tabs (note 1 at fig. 2). This will release the closure.
Note 1: Two additional small tabs for tighten closure
Note 2: Fit the two slots onto the two protruding tabs
Back Illumination
The 706 and 701TI/701TIP keypads feature timed back
illumination. Two LED’s backlight dimly illuminates
the keypad’s key when keys are not active.
Pressing any key will increase brightness of backlight,
which will remain bright for about 10 seconds for
701TI/TIP and 60 seconds for all 706 keypads (after
last key is pressed). This feature requires no additional
wiring.
When keys are fully lit, current consumption rises
by 50 mA. AV-701TI current consumption with
dim lighting: 90 mA, AV-706 consumption: 130 mA.
Tamper Switch Fi gu r e 2: C l o s i n g t he k e yp a d
The models AV-701TIP and AV-706TP feature a tamper switch, which requires one additional
wire. Connect to TMP and -V on the wire terminal.
Wire the tamper to any zone programmed as Tamper, Day or 24H zone type. Upon opening the
keypad housing the tamper switch will activate the connected zone.
Ordering Information
AV-701TS: Semi - Illuminated keypad AV-706: LCD Illuminated keypad
AV-701TI: Timed Illuminated keypad AV-706TP: LCD Illuminated keypad + tamper
AV-701TIP: Timed Illuminated keypad + Tamper
Item 4713/W6/701INS_E4/ All rights reserved to Av-Gad Systems Ltd. May 2011
