AutoWatch 279 RLi Manuel utilisateur
ADVANCED VEHICLE
SECURITY SYSTEMS
279 RLi
ALARM IMMOBILSER
OWNER’S MANUAL
FRONT OF PAGE 1
FRONT OF PAGE 2
FRONT OF PAGE 3
LIGHTNING OR ACTS OF GOD.
GUARANTEE
PFK ELECTRONICS (PTY) LIMITED AND KNIGHTWATCH (UK) LIMITED WARRANTS THIS
PRODUCT TO THE ORIGINAL CONSUMER PURCHASER TO BE FREE FROM DEFECTS IN
WORKMANSHIP AND MATERIAL FOR A PERIOD OF TWO YEARS. SHOULD THIS PRODUCT BE
FOUND TO BE DEFECTIVE IN THE VEHICLE IN WHICH IT WAS ORIGINALLY INSTALLED, PFK
ELECTRONICS SHALL REPAIR OR REPLACE THE PRODUCT OR ANY PART OF THE PRODUCT
WHICH PFK ELECTRONICS AGREES IS DEFECTIVE WITHOUT CHARGE. THIS WARRANTY DOES
NOT APPLY TO ANY PRODUCT WHICH HAS BEEN DAMAGED BY ACCIDENT, PHYSICAL OR
ELECTRICAL ABUSE, IMPROPER INSTALLATION, ANY USE CONTRARY TO ITS INTENDED
FUNCTION, UNAUTHORISED SERVICE (I.E. SERVICE BY ANYONE OTHER THAN PFK
ELECTRONICS OR ITS AUTHORISED AGENTS/SERVICE PERSONNEL), FIRE, FLOODING,
INDEMNITY
PFK ELECTRONICS (PTY) LIMITED AND KNIGHTWATCH (UK) LIMITED SHALL NOT BE
RESPONSIBLE FOR ANY REMOVAL AND/OR INSTALLATION CHARGES, DAMAGE TO OR THE
THEFT OF THE VEHICLE OR ITS CONTENTS, OR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES
CAUSED BY ANY FAILURE OF THE PRODUCT TO FUNCTION PROPERLY. UNDER NO
CIRCUMSTANCES SHOULD THIS WARRANTY, OR THE PRODUCT COVERED BY IT,
BE CONSTRUED AS AN INSURANCE POLICY AGAINST LOSS. PFK ELECTRONICS NEITHER ASSUMES
NOR AUTHORISES ANY PERSONS OR ORGANIZATION TO MAKE ANY WARRANTIES, NOR DOES
IT ASSUME ANY LIABILITY IN CONNECTION WITH THE SAFE INSTALLATION, OR USE OF THIS
PRODUCT. THIS IS THE COMPLETE PFK ELECTRONICS WARRANTY AND NO OTHER WARRANTY
EXISTS.
DPFK 279-510
The alarm can be disarmed without the use of the remote, by entering the override PIN.
The siren/hooter will sound during this procedure.
Refer to the PIN attached to the key tag and enter each digit of the PIN individually as follows:
(Note that a 0 is represented by 10 flashes)
Switch the ignition on – the status light will illuminate.
Switch the ignition off – the status light will begin to flash.
After the number of flashes equivalent to the first digit of your code, switch the ignition on. – the
status light will illuminate.
st nd rd th
This is the 1 digit entered. Switch the ignition off and counting the flashes enter the 2 , 3 , 4 and
th
5 digit of your PIN.
After correct entry of all 5 digits – the alarm will disarm. The LED will turn on solid. Switch off ignition
and wait 10 flashes – the status light will extinguish.
It is important that the 5 digits are entered sequentially. If you make a mistake, wait until the flashes
return to the alarm armed flashing sequence -3 flashes – pause – 3 flashes… Then begin again
st
starting from the 1 digit of your PIN.
The PIN number is also required by your Autowatch dealer should you require additional remotes.
The doors unlock.
If selective unlock is configured, then only the driver’s door will unlock.
Switch the ignition off.
UNLOCK WITH IGNITION (OPTIONAL)
EMERGENCY OVERRIDE (PIN CODE)
Congratulations. Your vehicle is protected by an
Autowatch vehicle security system designed to give
years of trouble free operation, made with only the
highest quality components and using state of the
art technology you can be assured that your vehicle
has the best electronic protection available.
INTRODUCTION DISARM
ARM
ANTI HIJACK IMMOBILISER (OPTIONAL)
1 arming tone and park lights flash once.
The status light flashes armed sequence.
3 flashes – pause – 3 flashes…
2 disarming tones and the park lights flash
twice. The status light extinguishes.
The status light illuminates for 1 second to
indicate that hijack has been cancelled.
A “door open” warning tone can be programmed by your Autowatch dealer.
The “on” and “off” tones may be de-selected by your Autowatch dealer.
Failure to do so will result in warning tones, slowing down of the vehicle followed by immobilization
and siren/hooter at full volume with park lights flashing, press the cancel button at any stage to exit.
HIJACK SERVICE MODE
With the alarm disarmed, press and hold the
hijack cancel button. While depressed, press the
arm or disarm button on the remote.
To re-select hijack, repeat the above procedure.
2 tones will be heard indicating the hijack
feature is disabled.
1 tone will be heard indicating the hijack
feature is enabled.
(Use this feature to avoid revealing the location of the cancel button)
If the vehicle is bumped. The siren/hooter will sound momentarily and
the park lights will flash.
EARLY WARNING DETECTION (OPTIONAL)
A tone is heard indicating the feature is
deselected for this arm cycle.
EARLY WARNING ISOLATION
Press the Arm button a second time within one
second after turning the alarm on.
Each zone will trigger the alarm a maximum of 3 times per “on” cycle.
INTRUSION DETECTION
The Alarm will detect a significant impact to the
vehicle, the ignition being switched on and doors,
bonnet or trunk opening.
The siren/hooter will sound and the hazards
flash for 30 seconds, unless the remote is
pressed.
ARMING OF THE ALARM
DISARMING OF THE ALARM
Press the Arm button momentarily.
Press the Disarm button momentarily.
Press the hidden cancel button after switching
the ignition on, or opening the hijack door/s.
IMPACT SENSOR ISOLATION
REMOTE PANIC
A tone is heard indicating the feature is deselected
for this arm cycle.
The siren/hooter will sound and the hazards flash,
unless the remote is pressed.
The doors will lock.
The doors will lock/unlock.
The doors will unlock.
The passenger doors will unlock.
The driver’s door will unlock.
The doors will lock.
Press the Arm button a third time within 1
second after isolating early warning..
Press and hold the Arm or Disarm button
on the remote for 3 seconds.
Turn the alarm on.
With the ignition on, press the remote.
Turn the alarm off.
CENTRAL LOCKING (OPTIONAL)
SELECTIVE UNLOCKING (OPTIONAL)
Turn the alarm off.
Press the Disarm button again.
LOCK WITH IGNITION (OPTIONAL)
Switch the ignition on with doors closed.
Inside Pages 1 Inside Pages 2
Inside Pages 3
Autres manuels pour 279 RLi
1
Autres manuels AutoWatch Système de sécurité
Manuels Système de sécurité populaires d'autres marques
EDM
EDM Solution 6+6 Wireless-AE Manuel utilisateur
Highway Safety Group
Highway Safety Group EA401 Manuel utilisateur
Siren
Siren LED GSM Manuel utilisateur
Detection Systems
Detection Systems 7090i Instructions de montage
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 Manuel utilisateur
Siemens
Siemens FDM273 Manuel utilisateur