LIMITED WARRANTY
TABLE OF CONTENTS
SERVICE
For service send your product to Auto Meter in a well-packed shipping
carton. Please include a note explaining what the problem is along with
your phone number. If you are sending the product back for Warranty
adjustment, you must include a copy (or original) of your sales receipt
from the place of purchase.
12 MONTHS FROM DATE OF PURCHASE-CABLES 90 DAYS
The manufacturer warrants to the consumer that this product will be
free from defects in material or workmanship for a period of twelve
(12) months from the date of original purchase.
Products that fail within this 12 month warranty period will be repaired
or replaced at the manufacturer’s option to the consumer, when
determined by the manufacturer that the product failed due to defects
in material or workmanship. This warranty is limited to the repair or
replacement of parts and the necessary labor by the manufacturer to
effect the repair or replacement of the product. In no event shall the
manufacturer be responsible for special, incidental or consequential
damages or costs incurred due to the failure of this product.
Improper use, accident, water damage, abuse, unauthorized repairs
or alterations voids this warranty. The manufacturer disclaims any
liability or consequential damages due to breach of any written or
implied warranty on its test equipment.
WARRANTY AND SERVICE INFORMATION
Warranty claims to the manufacturer’s service department must be
transportation prepaid and accompanied with dated proof of purchase.
This warranty applies only to the original purchaser and is non-
transferable. Shipper damage incurred during return shipments is not
covered under this warranty. It is the responsibility of the shipper (the
customer returning the Test Equipment) to package the tester properly
to prevent any damage during return shipment. Repair costs for such
damages will be charged back to shipper (customer returning the Test
Equipment). Protect the product By shipping in original carton or add
plenty of over-pack cushioning such as crumpled up newspaper.
Battery Replacement --------------------------------------2
Safety ----------------------------------------------------------3
Maintenance and Cleaning-------------------------------3
Features-------------------------------------------------------4
Controls and Functions--------------------------------- 4-5
Operation Instructions
DC/AC Current Measurements ---------------------6
DC/AC Voltage Measurements ---------------------7
Frequency (Hz) Measurement ---------------------8
Continuity Test ------------------------------------------8
Resistance Measurement----------------------------8
Relative “ZERO” Measurements -------------------9
Holding the LCD Reading----------------------------9
Finding the MAX/MIN Value -------------------------9
Charging System Tests
State of Charge--------------------------------------- 10
Amp Draw Check------------------------------------- 10
Alternator Test----------------------------------------- 11
Starter Draw Test------------------------------------- 12
Specications ---------------------------------------------- 13
Warranty ---------------------------------------------------- 15
Contact Information -------------------------------------- 16
BATTERY REPLACEMENT
When the low battery symbol is displayed on the LCD or the LCD is dark,
replace the old batteries with two (AA) batteries.
1. Turn the power off and remove the test
leads from the clamp meter.
2. Remove the screw of the battery cover.
3. Lift and remove the battery cover.
4. Remove the old batteries.
5. lnsert two (AA) batteries.
6. Replace the battery cover and
secure the screw.
Battery Replacement --------------------------------------2
Safety ----------------------------------------------------------3
Maintenance and Cleaning-------------------------------3
Features-------------------------------------------------------4
Controls and Functions------------------------------- 4 - 5
Operation Instructions
DC/AC Current Measurements ---------------------6
DC/AC Voltage Measurements ---------------------7
Frequency (Hz) Measurement ---------------------8
Continuity Test ------------------------------------------8
Resistance Measurement----------------------------8
Relative “ZERO” Measurements -------------------9
Holding the LCD Reading----------------------------9
Finding the MAX/MIN Value -------------------------9
Charging System Tests
State of Charge--------------------------------------- 10
Amp Draw Check------------------------------------- 10
Alternator Test----------------------------------------- 11
Starter Draw Test------------------------------------- 12
Specications ---------------------------------------- 13 - 14
Warranty ---------------------------------------------------- 15
Contact Information -------------------------------------- 16