6
In order to log into the system it is enough to have a
key fob (if the key fobs were included into IGLA system
set) or smartphone paired to the system (if the key fobs
were not included into IGLA system set).
Get into the car and start up the ignition. When the key
fob/smartphone is detected, the system will give out
two verication signals (see the annex), after that you
can start driving.
If the key fob/smartphone is not detected, there will
be no verication signals and if one attempts to start
driving or start up the ignition, the engine will be
locked (see page 18).
Authorization with the PIN-code
The authorization method depends on the chosen way
of engine locking, see page 18:
• If the system inhibits the engine start, the PIN-code
should be entered before the start of the engine.
• If the system does not inhibit the engine start, the
PIN-code can be entered both before the start of the
engine or after.
ATTENTION!
The initial PIN-code is set by the specialists
of the service centre during the installation. Before
running the system for the rst time change the PIN-
code and memorize a new one (see page 20)
.
Get into your car, start up the ignition, start the engine
if needed and enter the PIN-code using the standard
vehicle buttons*.
* Some buttons star t functioning in 2-5 seconds after switching on the ignition
or starting the engine (see the annex). Moreover, some buttons shall not be
pressed quicker than one time per second.
