Aurora PDL20 Manuel

OUTDOOR LOW VOLTAGE SPOTLIGHT

IP65

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION

LEAVE A COPY FOR THE USER / MAINTENANCE ENGINEER FOR FUTURE REFERENCE

USING THIS INSTRUCTION LEAFLET

This instruction leaflet has been designed as a general installation guide to help you install your particular outdoor

luminaire. Please pay particular attention to how your luminaire is wired. If you require any guidance or any further

information regarding your outdoor luminaire, please contact us via the details below or visit our web site.

IMPORTANT INSTALLATION INFORMATION

Installation shouldbe carried outin accordance with the latest edition ofthe I.E.E. Wiring Regulations (BS7671) and taking

into consideration thelatest Building Regulations. If in doubt, consult a qualified electrician.

Before commencing any installation or maintenance work, ensure electricity is switched off at the mains.

Please take note of the IP (Ingress Protection)rating of your luminaire when deciding location.

All luminaries run HOT. It is the installer’s responsibility to consider fire & safety risks and take appropriate precautions.

Please take note of the maximum lamp wattage for this luminaire is 20W.

Ensure that ALL electrical connections are tight with no loose strands, including factory made connections.

Please take note of the nearest illuminated surface as detailed on theproduct label.

IMPORTANT USER INFORMATION

Always switch off mains supply before installation, servicing, fitting or changing the lamp.

Replace failed lamps immediately. Allow the lamp and fitting to cool before replacing lamp. Checkthat the correct lamp type

and wattage is fitted. Dispose offailed lamps correctly.

It is recommended to clean every two to threemonths to preserve the finish of this product. Do not use solvents or

aggressive cleaning agents.

GENERAL INSTALLATION - SAFETY

When positioning your luminaire, please take note that outdoor electrical installations should be installed by qualified

electricians. Proper circuit protection for all exterior electrical services should include a residual current device (RCD), also

known as an earth leakage circuit breaker (ELCB). This simple device ensures that the power is cut off immediately; it

detects a leakage of current to earth, which indicates an electrical fault which is potentially threatening to life. Observe these

few simple rules and keep your outdoor electrical installation safe.

GENERAL INSTALLATION – LAYING CABLE

Laying electrical cables in the ground may be subject to specific regulations. The aim is to ensure that the cables are buried

deeply enough in the ground to avoid any disturbance which is likely to occur. Where armoured cables can be buried at

adequate depth to avoid being damaged by any reasonable foreseeable disturbance of the ground, they can be laid in a

buffer layer of sand and covered with cable warning tape. Where it is not possible to bury the cables deeply enough because

of the presence of tree roots or unsuitable ground conditions, extra mechanical protection around the cables will be

required. This is usually in the form of plastic ducts or conduits through which the cables are run.

Document version - AU-PDL20_V1_11

INSTALLATION

Select the required position for the luminaire.

Fit the lamp into the spotlight (20W MR16 Max).

Fix the Spotlight into position – This product is spike mounted.

For MR16 lamps a 12V Low Voltage Transformer must be used, see Transformer instructions for wiring details.

Select a suitable position for the LowVoltage Transformer and provide a suitable mains supply. Connect themains supply

to the Transformer via a suitable IP rated junction box - see Transformer or Driver instructions for wiring details.

Use a suitable IP rated junction box to connect the Spotlight to the Transformer - see theTransformer instructions for

wiring details.

Switch on the power supplyand test the luminaire.

Warning

If the external flexible cable or cord of this luminaire is damaged, it

should be exclusively replaced by the manufacturer or his service

agent or similar qualified person in order to avoid a hazard

Environmental Protection (W.E.E.E.) – Aurora’s WEEE Reg.No. WEE/BG0130YX

Waste Electrical & Electronic Equipment Regulations (WEEE) requires that any of our products

showing this marking (left) must not be disposed of with other household or commercial waste.

Aurora does not levy any WEEE disposal charges to its customers for affected WEEE related products.

To prevent possible harm to the environment or human health from uncontrolled waste disposal,

please separate any such product from other waste types and recycle it responsibly at your local

facilities. Check with your Local Authority, Recycling Centre or retailer for recycling advice. If, when

you purchased any Aurora product, your supplier included a WEEE disposal fee, you should then

contact your supplier for advice on his take back of the product for the correct disposal.

GUARANTEE

This product is guaranteed in the UK for a period of 1 year from the date of purchase, unless otherwise stated in

current company literature. The guarantee is invalid in the case of improper use, installation, tampering, removal of the

Q.C. date label, installation in an improper working environment or installation not according to the current edition of

the I.E.E. Wiring Regulations (BS7671). Should this product fail during the guarantee period, it will be replaced free of

charge, subject to correct installation and return of the faulty unit. Aurora does not accept responsibility for any

installation costs associated with the replacement of this product. Your statutory rights are not affected. Aurora

reserves the right to alter specifications without prior notice.

Table des matières

Autres manuels Aurora Mettre en lumière

Aurora

Aurora AU-SPT3031 Manuel

Manuels Mettre en lumière populaires d'autres marques

Guangzhou Yinhe Lighting&Sound Equipment Factory

Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Manuel utilisateur

LIVARNO home

LIVARNO home 375304 2101 Instructions originales

Cameo

Cameo CLQS40WW Manuel utilisateur

Leviton

Leviton Ellipsoid 5/50 Manuel utilisateur

Monacor

Monacor img Stage Line PARL-56PDX/CR Manuel utilisateur

Vector

Vector SL3AKV Manuel utilisateur

Quantum

Quantum Q262 Manuel d'exploitation

Philips

Philips Vari-lite VL3015LT Manuel utilisateur

EUROSPOT

EUROSPOT C51 Manuel utilisateur

DTS

DTS MINI BRICK ARC Manuel utilisateur

Federal Signal Corporation

Federal Signal Corporation VISIBEAM II Manuel

ACME

ACME LED-MS350B Manuel utilisateur

EuroLite

EuroLite Akku flat light 1 Manuel utilisateur

Commercial Electric

Commercial Electric SPTM-1401 Manuel utilisateur

Vision & Control

Vision & Control SLB-500-W5K7-P-SL Manuel utilisateur

Teknik

Teknik FLEXI Manuel utilisateur

Craftsman

Craftsman CMXLSB10 Manuel utilisateur

EuroLite

EuroLite LED SLS-144 UV Floor Spot Manuel utilisateur