OTHER FUNCTIONS
Reconnection
Previously paired bluetooth devices will reconnect to beamit automatically
once turned back on. beamit will not initiate reconnection. If beamit itself is
turned off, it is recommended to turn it back on first before turning on the
paired devices so that it can accept the incoming Bluetooth connection from
the devices.
Adjusting the Volume
beamit, by design, is a passive transmitter or receiver and has no volume
control. User volume level must be adjusted via the input and output sources
connected to beamit.
Volume can be individually adjusted on each set of headphones paired with
beamit using the built-in volume controls on the headphone. With some TVs
and connection options, TV volume may be further raised or lowered to
change the volume of all headphones paired with beamit. In this case, volume
should be maximized on the TV and then adjusted via headphones for best
audio quality.
Factory Reset
In standby mode, slide and hold the spring-loaded slider (Multi-Function Switch)
all the way to the right for approximately 5 seconds until the blue indicator
light begins to blink. Release the spring-loaded switch. The unit will enter
pairing mode and any previously paired devices will be cleared from memory.
14
TROUBLESHOOTING TIPS
beamit is connected but it will not turn on - LED indicator does not light up.
Confirm that the power adapter is connected to beamit with the included USB
cable and plugged into a functioning AC outlet. The blue LED indicator on the
front of the unit will light up when the unit is turned “ON” by setting the TX/RX
toggle switch on the rear of the unit to “TX or RX”.
Unable to pair and connect beamit to my Bluetooth device.
Make sure you are operating beamit in the appropriate Bluetooth mode.
In TX Mode: beamit can only pair with a Bluetooth receiving device such as a
Bluetooth headphone, speaker or receiver. In this mode, ensure that beamit
and the Bluetooth headphone, speaker or receiver are in pairing mode at the
same time and are within 1 meter (3 feet) of each other.
In RX Mode: beamit can only pair with a Bluetooth transmitting device such as
a smartphone, tablet or computer. In this mode, ensure that Bluetooth is turned
‘ON’ on your smartphone, tablet or computer. Make sure that the LED indicator
is blinking and your device and beamit are within 1 meter (3 feet) of each other.
My Bluetooth headphone is connected but there is no audio output.
1. Ensure that your audio source (TV/computer) OUTPUT is properly connected
to beamit audio INPUT. Audio inputs are used with TX MODE only.
2. Check whether the audio input is correctly selected on beamit (AUX OPT).
If AUX is selected, make sure make sure your audio source is connected to the
AUX input. If OPT is selected, make sure your audio source is connected to the
Optical input.
3. Confirm that audio is playing on the TV/computer and the volume is set to
“High” on the TV/computer. Make sure that volume is sufficiently high on your
Bluetooth headphone / speaker.
1515
