Common Information
Note:
Your Audipack product is equipped with a DC 24 volt control as below.
This control has been designed to control an external product suitable for
controlling by contact closures.
This type of control is also available as a set inclusive a IR remote set part no.
260218 or as an RF remote control set part no. 260219.Refer to the manual of the
IR and RF module for connecting and programming.
Cautions:
The relay control is not suited to high revving motors
Do never overload the relay control
The relay control should always be mounted inside an appropriate housing
The wiring which is connected to the relay control has to be wrapped by a tie-rap
The relay control may only be plugged to a grounded power-point
Properties:
The motor needs to be braked before switching the direction
It is possible to have the motor run for a pre-set time (impulse push).
It is possible to connect a safety relay to the control print (i.e. for an emergency
button). The connector is suited only to an external standardized relay.
If the relay control is mounted in machines used within the reach of bystanders, or
over bystanders, the following safety guidelines have to be observed.
Installation and connections may only be carried out by qualified staff
The power cable must be conform (3x1 mm²) EN60227
Warning
A.
While the machine is in motion, the operator should have full sight over the
machine
B.
The control buttons have to be installed in a place which offers the operator full
sight over the machine
C.
No bystanders may stand under the machine, or within the radius of the machine,
if the lowest point of the machine is less than 2 meters above the floor.
D.
If the machine shows up damage during testing or normal operation, the machine
should be taken out of service. The machine should be repaired by a qualified
installer. The machine should be released by a qualified installer.
E.
If the machine is damaged or fractured, the operator should have the machine
repaired by a qualified installer or by Audipack.
•© Audipack
