Controls
FRONT PANEL
1 - MIC INPUT
The M6 is equipped with 2 ultra low-noise pre-amps featuring a 60 dB gain range
and 115 dB of S/N ratio. A 48V phantom power is available for condenser or
electret microphones. The phantom power must be switched off when using
dynamic microphones. The on/off switch is (24).
Those two channels can be used for musical instruments or digital processors
thanks to ¼’’ unbalanced phone jacks.
Warning : never connect a line signal into a XLR MIC input connector when the
phantom power is engaged. It could damage your equipment.
2 - STEREO LINE INPUT
These are channels 3/4, and 5/6. They are organized in stereo pair and provided
with ¼’’ TRS phone sockets. If you connect only the left jack, the input will operate
in mono mode, that’s mono signal will appear on both input channels. You can
use these inputs with electronic instruments.
3 - TRIM
This control is provided with 2 different indication rings: one is for the MIC and the
other for the LINE input. When you use a Microphone, please read the MIC ring
[0 ~ 60 dB]; when you use a line level device, please read the LINE ring
[+15 ~ -45 dB]. For optimum operation, you need to set this control in a way that the PEAK LED will light up
only occasionally in order to avoid distortion on the input channel.
4 - STEREO AUX RETURN
You can use these stereo ¼’’ phone sockets to return the stereo signal of an effect
unit to the Main Mix.
Alternatively you can use them as an extra auxiliary input and using the MASTER
AUX (21) as volume control. However, this specific connection disengages the
effect processor.
5 - AUX SEND
This ¼’’ phone socket is used to send out the signal from AUX bus of the input
channels into external devices such as effect units and/or stage monitors. AUX
SEND is wired post-fader to control the signal of the internal multi-effect unit. You
can also connect an external effect unit. In such a case; the internal effect unit will
be automatically disconnected. If you want to wire the AUX circuit as pre-fader,
read chapter 5 of this manual. In the pre-fader mode, the AUX bus can send the
signal to a stage monitor.
6 - PHONES
This socket will be used to send the signal to a pair of headphones.
7 - CTRL RM OUT
These ¼’’ phone sockets will be used to send the signal to a pair of powered
monitor speakers or to a second set of PA.
5%
3
TRIM%
