ATUNE ANALOG SBB-A5527 Manuel utilisateur

Model: SBB-A5527

16" Bluetooth soundbar speaker

Please read this instruction manual carefully and keep it for future reference

WARNING:TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE

THIS UNIT TO RAIN OR MOISTURE.

WARNING: USE UNDER SUPERVISION OF AN ADULT DUE TO LONG

CORD This unit has a long cord that can be easily tripped on or pulled on,

causing injury. Please make sure it is arranged so that it will not drape over a

tabletop, etc. Where it can be pulled on by children or tripped over accidentally.

CAUTION: TO REDUCE THE ELECTRIC SHOCK, DO NOT REMOVE THE

COVER (OR BACK). NO USER SERVICEABLE PART INSIDE, REFER

SERVICING TO QUALIFIED SERVICE PERSONNEL.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

DANGEROUS VOLTAGE:The lighting flash with arrowhead symbol within

an equilateral triangle is intended to alert the user to the presence of

uninsulated “dangerous voltage” within the product’s enclosure that may

ATTENTION:The exclamation point within an equilateral triangle is intended to

alert the user to the presence of important operating and maintenance

(servicing) instructions in the literature accompanying the appliance.

1. Read these instructions

All the safety and operating instructions should be read before the appliance is

operated.

2. Keep these instructions

The safety and operating instructions should be kept for future reference.

3. Heed all warnings

All warnings on the appliance and in the operating instructions should be

adhered to.

4. Follow all instructions

All operation and use instructions should be followed.

5. Do not use this apparatus near water

The appliance should not be used near water; for example, near a bath tub,

be of sufficient magnitude to constitute a risk of electric shock to persons.

Before using the unit, be sure to read all operating instructions carefully, please

note that these are general precautions.

washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming

pool.

6. Clean only with dry cloth

The appliance should be cleaned only as recommended by the manufacturer.

7. Do not block any ventilation openings.Install in accordance with the

manufacturer’s instructions.

Slots and openings in the cabinet and in the back or bottom are provided for

ventilation, to ensure reliable operation of the product and to protect it from

overheating. These openings must not be blocked or covered. The openings

should never be blocked by placing the product on a bed, sofa, rug, or similar

surface. This product should never be placed near or over a radiator or heat

source. This product should not be placed in a built-in installation, such as a

8. Do not install near any heat sources such as radiators, heat registers,

stoves, or other apparatus (including amplifiers) that produce heat.

10. Protect the power cord from being walked on or pinched particularly

at plugs, convenience receptacles, and the point where they exit from the

apparatus.

11. Only use attachments / accessories specified by the manufacturer.

12. Use only with a cart, stand, tripod, bracket, or table

specified by the manufacturer, or sold with the apparatus.

When a cart is used, use caution when moving the

cart/apparatus combination to avoid injury

from tip-over.

An appliance and cart combination should be moved with care. Quick stop,

combination to overturn.

13. Unplug this apparatus during lightning storms or when unused for

long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is

required when the apparatus has been damaged in any way, such as

power-supply cord or plug is damaged, liquid has been spilled or objects

have fallen into the apparatus, the apparatus has been exposed to rain or

bookcase or rack unless proper ventilation is provided or the manufacturer's

instructions have been adhered to.

excessive force and uneven surfaces may cause the appliance and cart

9. Do not defeat the safety purpose of the grounding-type plug. A

grounding type plug has two prongs and a third grounding prong. The

third prong is provided for your safety. If the provided plug does not fit

into your outlet, consult an electrician for replacement of the obsolete

outlet.

To protect your product from a lightning storm, or when it is left unattended and

unused for long periods of time, unplug it from the wall outlet. This will prevent

damage to the product due to lightning and power-line surges.

Portable Cart Warning

moisture, does not operate normally, or has been dropped.

15. Power source

This product should be operated only from the type of power source indicated

on the marking label. If you are not sure of the type of power supply to your

home, consult your appliance dealer or local power company. For products

intended to operate from battery power, or other source, refer to the operation

instructions.

16. Power lines

An outside antenna system should not be located in the vicinity of overhead

power lines or other electric light or power circuits, or where it can fall into such

power lines or circuits. When installing an outside antenna system, extreme

care should be taken to keep from touching such power lines or circuits as

contact with them might be fatal.

17. Overloading

Do not overload wall outlets and extension cords as this can result in a risk of

fire or electric shock.

18. Object and liquid entry

Never push objects of any kind into the product through openings as they may

touch dangerous voltage points or short out parts that could result in fire or

electric shock. Never spill or spray any type of liquid on the product.

19.

20.

Service

Do not attempt to service this product yourself as opening or removing covers

may expose you to dangerous voltage or other hazards. Refer all servicing to

qualified service personnel.

When replacement parts are required, be sure the service technician uses

replacement parts specified by the manufacturer or those that have the same

characteristics as the original parts. Unauthorized substitutions may result in

fire or electric shock or other hazards.

21.

Replacement parts

Upon completion of any service or repairs to this product, ask the service

technician to perform safety checks to determine that the product is in proper

operating condition.

2 . Wall or ceiling mounting

Theproduct should be mounted to a wall or ceiling only as recommended by

the manufacturer.

Safety check

b)If liquid has been spilled or objects have fallen into the product.

c)If the product has been exposed to rain or water.

d)If the product does not operate normally by following the operating

instructions. Adjust only those controls that are covered by the operating

instructions, as an adjustment of other controls may result in damage and will

require extensive work by a qualified technician to restore the product to its

normal operation.

e)If the product has been dropped or the cabinet has been damaged.

f)When the product exhibits a distinct change in performance- this indicates a

need for service.

Unplug this product from the wall outlet and refer service to qualified service

personnel under the following conditions.

a)When the power- supply cord or plug is damaged.

2 . Damage requiring service

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of

the following measures:

●Reorient or relocate the receiving antenna.

●Increase the separation between the equipment and receiver.

●Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

●Consult the dealer or an experienced radio/TV technician for help.

FCC WARNING:

To assure continued operation, follow the attached installation instructions and

use only shield cables when connecting to other devices. Changes or

modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

FCC NOTICE:

FCC STATEMENT:

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference

that may cause undesired operation. The antenna(s) used for this transmitter

must be installed to provide a separation distance of at least 20 cm from all

persons and must not be co-located or operating in conjunction with any other

antenna or transmitter.

Cancer and Reproductive Harm-www.P65Warnings.ca.gov

PROdUCT OvERvIEW

CONTROL PANEL

FRONT VIEW

REAR PANEL

3 4 5 6 7 8 9 10 11 12

1. Speaker

2. Remote sensor

3. SB PAIR button

4. Mode button

6. Mode indicator

8. Volume up button

9. AUX IN jack

10. Optical In jack

11. LINE IN jacks

12. DC IN jack

5. Pow er button

7. Volume dow n button

BATTERY INSTALLATION OF REMOTE CONTROL

Fig.1

Fig.2 Fig.3

Remove and discard the insulation film as Fig.1.

Replacing battery for Remote Control

First time use

REMOTE CONTROL

OPEN

OPE N

3V CR2025

3V C R 2 025

1. Pull out the battery holder as indicated in Fig.2.

2. Replace the old button cell with a new CR2025 button cell

with the polarity markings facing upward as Fig.3.

3. Push back the battery holder as Fig.4.

Fig.4

1. (Power On/Off) Button

2. AUX Button

3. LINE IN Button

4. (Previous) Button

6. (Mute) Button

10. (Next) Button

11. Play/Pause Button

12. (Volume Down/Up) Button

9. (Mode Switch) Button

AUX

OPTICAL

LINE

TALK MOVIE

MUSIC

Sound Mode

VOL

STANDARD

7. (Bluetooth)Button

8. OPTICAL Button

5. Sound Mode (MUSIC,

TALK, MOVIE, STANDARD)

BATTERY PRECAUTIONS

Follow these precautions when using a battery in this device:

1. Use only the size and type of battery specified.

2. Be sure to follow the correct polarity when installing the battery as indicated in the battery

3. Do not mix different types of batteries together ( e.g: Alkaline and Carbon -zinc )

or old batteries with fresh ones.

4. If the batteries in the device are consumed or the device is not to be used for a long period of time,

remove the batteries to prevent damage or injury from possible leakage.

5. Do not try to recharge the battery as it is not intended to be recharged; it can overheat and rupture.

(Follow the battery manufacturer’s instructions.)

6. The batteries shall not be exposed to excessive heat such as sunshine or fire.

7. Clean the battery contacts and also those of the device prior to battery installation.

8. The remote control is supplied with a coin/button

cell battery. If the coin button cell battery is

swallowed, it can cause severe internal burns in

just 2 hours and can lead to death. Keep new

and used battery away from children. If the

stop using the product and keep it away from

children. If you think batteries might have been

swallowed or placed any part of the body, seek

immediate medical attention.

CR2025

Remote control operation range

●

●When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light

shines on the REMOTE SENSOR of the unit, the operation of the remote may be unstable.

CAUTION

●Danger of explosion if the battery is incorrectly replaced.

●Replace only with the same or equivalent type.

16.4 Feet (5M)

When there is an obstacle between the transmitter and the unit, the unit may not operate.

compartment, a reversed battery may cause damage to the device.

battery compartment does not close securely,

AUX

OPTI CAL

LIN E

TALK MOVIE

MUSIC

Sound Mode

VOL

STANDARD

PLACEMENT AND MOUNTING

1. Placing the device on a table - Ventilation

2. The Installation Distance

2-3inches

2900mm(11.4 inches)

When placing the soundbar on an entertainment center, bookshelf, or any type

of enclosed space, be sure to allow enough space for ventilation.

Otherwise, the heat generated will produce potential heat hazard.

Table des matières

Autres manuels ATUNE ANALOG Système de haut-parleurs

ATUNE ANALOG

ATUNE ANALOG SBB-A5520 Manuel utilisateur

Manuels Système de haut-parleurs populaires d'autres marques

JVC

JVC CA-MXK5R Manuel utilisateur

LG NB4532B Manuel utilisateur

JVC

JVC CA-FSH100 Manuel utilisateur

5Core

5Core Pro Series Manuel utilisateur

EAW

EAW MQV1394e Manuel utilisateur

Lynx

Lynx GXR-LA10A Manuel utilisateur

iLive

iLive ITB066B Manuel utilisateur

RDX

RDX QuickStation 4 Manuel utilisateur

Electro-Voice

Electro-Voice S-122 Manuel utilisateur

Sven

Sven SPS-619 GOLD Manuel utilisateur

Pioneer

Pioneer CS-7070 Manuel utilisateur

EAW

EAW UB82e Manuel utilisateur

Sondpex

Sondpex Active Speaker System and Digital Music... Manuel utilisateur

JVC

JVC NX-PN7 Manuel utilisateur

Marshall Amplification

Marshall Amplification AR-DM61-BT Manuel utilisateur

Yamaha

Yamaha NX-A01 - Speaker Sys Manuel utilisateur

SE Audiotechnik

SE Audiotechnik I-LINE Manuel utilisateur

Gemini

Gemini WRX-843 Series Manuel utilisateur