ATOMSTACK MAKER E85 Manuel utilisateur

ATOMSTACK MAKER E85 Extended frame

English

F03-0105-0AA1

Versions: B

Packing list

Dovetail groove

laser slide rail

M5*14 M5*8 M5*6 M4*8 T-Nut M3 screw

assembly Hex screwdriver

Y-axis left slide rail Suppo beam

Suppo beam

Y-axis right slide rail X-axis rail

Wrench Cable tie Foot bracket*3 Control box

Laser slide rail Cable holder M5 lock nut Timing belt M5*25

Product Manual

5PIN to 4PIN adapter cable

5PIN to 3PIN adapter cable

Suppo beam

Y-axis left slide rail Y-axis right slide rail

M5*25 M5*25

M5*25

Assembly of X-axis slide rail assembly and frame

M5*25

M5*14

M5*6

3 5

Assembly of X-axis slide rail assembly and frame

Fastening method of connecting

wire xing steel wire

Installation of the xing bracket

for the motherboard cable

M5*8

M3 screw

assembly

M3 screw

assembly

The stroke of the X-axis is too large. In order to prevent the left-right asymmet

in the assembly of the Y-axis synchronous belt, when the Y-axis synchronous belt

is assembled and tightened, the X-axis slide rail assembly should be close to the

limit columns at both ends of the Y-axis.

Y-axis limit column installation

Cable xing module installation

Y-axis timing belt installation

Judgment and adjustment method of the tightness of the POB wheel on the X-axis slide rail:

In the case of ensuring that the suppo does not shake, one end of the machine can be lifted

to 45° from the horizontal plane, and then the X-axis or Y-axis suppo can be released from a

high place. If the bracket slides all the way at a constant speed, then it's tight enough.

POM wheel adjustment

The adjustment state of the POM wheel is from loose to tight cycle, just adjust to

the appropriate tightness.

90°

45°

M5*6

Dovetail groove laser slide rail Laser slide rail

Select the laser xing slide rail according to the laser module

Dovetail laser slide rail is compatible with ATOMSTACK 20W/30W laser module

Laser slide rail is compatible with ATOMSTACK 10W laser module

M4*8

Laser xed slide rail installation

Schematic diagram of the wiring position of the mainboard cable

Note: 1. The control box is compatible with 12V/24V power adapter.

2. When replacing the laser module with dierent power, you need to replace the suppoing power adapter, otherwise the laser module will be damaged!

3. After installing the connecting wire, it is necessa to tie the wire to the steel wire of the X-axis and the xed bracket with a cable tie, otherwise the connecting wire is too

long and may scratch the engraved object below.

4.For users whose existing laser module has a 4PIN or 3PIN power connector, we provide 5PIN to 4PIN and 5PIN to 3PIN adapter cables, please select the corresponding

adapter cable according to the actual situation.