Atlantic FT30-8MA Manuel utilisateur
OWNER’S MANUAL
12” TABLE FAN
MODEL:FT30-8MA
READ AND SAVE THESE INSTRUCTIONS
CAUTION
Read Rules for Safe Operation and Instructions Carefully.
WARNING
1. To reduce the risk of fire or electric shock, do not use this fan with any solid
state speed control device.
2. This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit in a polarized
outlet only one way. If plug does not fit fully in the outlet, reverse plug. If it
still does not fit, contact a qualified electrician. Do not attempt to defeat this
safety feature.
3. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities,or lack of experience and
knowledge, unless they have been supervised or instructed concerning
use of the appliance by a person responsible for their safety.
4. Do not leave the fan running unattended.
RULES FOR SAFE OPERATION
1. Fan should be used under rated voltage.
2. Connect power after the fan is fully assembled.
3. Never insert fingers, pencils, or any other object through the guard when fan is
running.
4. Unplug from outlet when not in use, when moving fan from one location to
another, before putting on, or taking off parts, and before cleaning.
5. Disconnect fan when removing grilles for cleaning.
6. Be sure fan is on a stable surface when operating to avoid overturning.
7. DO NOT use fan in window. Rain may create electrical hazard.
PARTS NAME
BASE ASSEMBLY
1. Detach screw from base of the fan.
2. Match locking tab to base and click into position.
3. Tighten the screw in the base to secure the fan to the base.
ASSEMBLY OF BLADE AND GRILLS
1. Unscrew the spinner clockwise and the nut counter clockwise and remove
both of them.
2. Set the rear grill in the proper position with the handle up.
3. Screw on plastic nut tightly to attach grill.
4. Discard plastic sleeve on shaft.
5. Install the blade onto the shaft until the retaining pin fits into the notch on
the blade.
6. Screw spinner on to motor shaft counterclockwise.
7. Mount the Front Grill and join both Grills together using the Clips.
OPERATION INSTRUCTION
Speed control
Speed is controlled by the button switch or rotary switch
OFF--Off L--Low M---Medium H---High
Oscillation control
To make the fan oscillate, push down on the oscillation knob located on the top
of the motor housing. To stop the fan down from oscillating in the position desired,
push on the oscillating knob once more.
Alternative, there is a oscillation switch on the fan body, push down the switch,
you can also make the fan oscillate.
Tilting control
The airflow can be adjusted upward or downward by tilting the fan head to a
vertical angle as desired.
CLEANING
1. Unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with mild soap and damp cloth or sponge.
Thoroughly remove soap film with clean damp cloth or sponge.
3. Do not allow water or other liquid near the motor.
4. Only use mild soap water to clean-No solutions.
PRINTED IN CHINA
Base
Front Guard
Blade
Plastic Nut
Rear Guard
Motor Shaft Oscillating
Fan Body
Piano-key
Spinner
unscrew
Autres manuels Atlantic Ventilateur
