ATD Tools Saber Light ATD-80103 Manuel utilisateur
ATD-80103 Instructions
1. Charging Instructions
Fully charge your ATD Saber Light®for 8-10 hours before use.
The battery is only 50% charged before shipping.
Be sure your ATD Saber Light®is turned off, and then plug the AC charging unit into the wall and into
the bottom of your ATD Saber Light®. The green LED indicator at the top of the LED board will light
up when the ATD Saber Light®is fully charged.
After using your ATD Saber Light®for 5 hours, recharge it until the green LED indicator light comes
on.
2. Operating Environment
•The performance of your ATD Saber Light®will decline in temperatures exceeding 104°F (40°C)
or in temperatures lower than -4°F (-20°C) due to the battery’s natural inability to perform under
these conditions.
•Keep your ATD Saber Light®away from heat sources.
•Keep your ATD Saber Light®away from acids and alkalines.
•Avoid bumping or dropping your ATD Saber Light®.
3. LED board replacement instructions
•When repairing your ATD Saber Light®, do not allow any metal to come in contact with the
internal battery pack or the PC board and its components.
•Turn the ATD Saber Light®off.
•Remove end cap (2) from end of tube (3) using care not to crack the tube.
•Pull the LED PC board (8) from top of the tube (3).
•Disconnect the wiring connector from the LED PC board, and reconnect it to a new PC board (8).
•Carefully slide the PC board assembly (8) back into clear tube (3) and replace the end cap (2).x
4. This unit is NOT waterproof, and is NOT intended to be used in showers, saunas, or
any other potentially wet locations. Keep the ATD Saber Light®away from sinks, tubs, showers, etc.
Retrieving ANY electrical appliance when they fall into the water can be fatal.
5. The ATD Saber Light®is to be used for general indoor lighting. It is NOT intended to be used in
potentially hazardous locations such as near flammables or in explosive atmospheres.
6. Your ATD Saber Light®has a built in automatic discharge shut off feature that prevents the battery
from becoming fully discharged, thus extending the battery life. After around 8 hours of use (after fully
charging) the LED’s will flash and then the light will shut off automatically to protect the battery.
7. You ATD Saber Light®can be fully discharged, and used when plugged into the AC adapter for
recharging. It will recharge while it is in use.
ATD Saber Light®is a registered trademark of ATD Tools, Inc. Patent Pending
Table des matières
Autres manuels ATD Tools Lampe de poche
