Astral Pool NARBONNE Manuel

ENGLISH

ABOVE-GROUND AUTOMATIC POOL COVER

NARBONNE MODEL

INSTALLATION AND MAINTENANCE MANUAL

Serial N°:

Revision number: B007-2012-10-05

ENGLISH

1/17 Revision number B-007-2012-10-05

TABLE OF CONTENTS

UNLOADING.............................................................................................................. 2

TOOLS REQUIRED FOR ASSEMBLY....................................................................... 2

COMPONENTS OF THE AUTOMATIC POOL COVER............................................. 3

POSITIONING WITH SHARP CORNERS.................................................................. 4

POSITIONING WITH RAYS....................................................................................... 4

ROLLER INSTALLATION........................................................................................... 5

SLATS ASSEMBLY.................................................................................................... 7

SLATS DIRECTION.................................................................................................... 8

SLATS ASSEMBLING................................................................................................ 8

STAIR SETTING ........................................................................................................ 9

ELECTRICAL CONNECTIONS................................................................................ 10

PLAN OF WIRING.................................................................................................... 11

LIMIT SWITCH ADJUSTMENT................................................................................ 12

BRACKET AND STRAP POSITION......................................................................... 13

POSITION OF BRACKETS AND THE STRAPS FOR THE CAPCIR MODEL ......... 13

SAFETY BRACKETS POSITIONING:...................................................................... 14

The structure is an element of ornament, do not sit

down, do not climb on it, and do not use like solarium!

ENGLISH

2/17 Revision number B-007-2012-10-05

UNLOADING

TOOLS REQUIRED FOR ASSEMBLY

Drill and drill bits for concrete Ø 6 and Ø10

Flat head screwdrivers

Phillips screwdrivers

Spirit level

10 - 13 – 17 wrench

Nippers

Wire strippers

5 and 6 mm Allen wrench

Hammer

Standard and long (10 m) measuring tape

Grease

Metal saw

Grinder with material disk

UNLOADING TIME

ASSEMBLY TIME

0 h

3 h

0h30 10h00

ENGLISH

3/17 Revision number B-007-2012-10-05

COMPONENTS OF THE AUTOMATIC POOL COVER

1 Structure PVC or WOOD

(Shaft assembled on the structure):

Roller Shaft

Slats and fixing Brackets assembly

Electrical box

Installation Instructions

Operation, care, winterising and maintenance instructions.

ENGLISH

4/17 Revision number B-007-2012-10-05

POSITIONING WITH SHARP CORNERS

Sharp corner

POSITIONING WITH RAYS

Coping stone rays

POOL LENGTH

Pool slats length 4 m 5 m 6 m 8 m 10 m 12 m

Dimension X in mm 250 265 285 305 335 350

Dimension X: Cut a piece of coping stone of variable length according to the diameter of slat

roller, upon the roller shaft.

"Cut"

"Dimension X according to table

Dimension X according to table

ENGLISH

5/17 Revision number B-007-2012-10-05

ROLLER INSTALLATION

- Position the roller as indicated in the diagram, making sure it is properly centred

with respect to the pool. It must be perfectly horizontal when installed (diagonals

dimensions).

- If there are rays, the roller should be pushed forward to the pool to enable the slats

to lower properly in its full width.

- Mark the position of the roller stand and polish or flatten the coping stone to obtain

a flat horizontal, even surface for placing the stands.

- Cut the coping stone (dimension X) to make it easier for the slats to be lowered over

the pool. Dimension X may vary according to the length of the pool; roller (roller

diameter on the roller shaft). (See page 05/18 table dim. X).

- After assembling the roller and making the adjustments, position the two roller

stands to the final position on the coping stone, using M10×75 Stainless Steel Bolts.

- Not to position it too behind swimming pool in order to avoid the friction of the

blades on the nose of curbstones when the cover is completely rolled up and this

particularly in the center of the roller

Note: If the skimmers are fixed along the length of the pool, we recommend

replacing their existing flanges with 2 mm thickness Stainless Steel flanges to easier

the slats way and avoid their blockage.

Dimension X

ENGLISH

6/17 Revision number B-007-2012-10-05

ENGLISH

7/17 Revision number B-007-2012-10-05

SLATS ASSEMBLY

* Immediately after taking the slats out of the packaging, they should be put into the

water to prevent any possible deformation.

*The number of slats has been determined according to the length of the pool,

though there are 4 extra slats.

* The first set of slats is easily recognisable as it has the straps to be fastening to the

roller. (Long length straps).

*Slide the strap under the fastening plates; tension it without pulling the slat out of the

water

*Centre the cover in the pool leaving enough space on both sides.

*Tighten the attachment plates with a screwdriver

* Bring closer the set of 7 slats to assemble them.

Note: Slats should go down from the front of the roller shaft.

Fixation plate

Strap

slate

set of 7 slats

ENGLISH

8/17 Revision number B-007-2012-10-05

SLATS DIRECTION

* Identify the upper side of the slats (curved side).

* Identify the slats direction:

- Wing to the stair

- Groove to the roller shaft

SLATS ASSEMBLING

Phase 1: Join the slats Phase 2: Join the wing to the groove

Phase 3: Move both slats down Phase 4: Move them up and carry on with it until

slats are perfectly engaged.

Roller shaft Side

Slat Side on the water

Stair Side

ENGLISH

9/17 Revision number B-007-2012-10-05

STAIR SETTING

1°) Put the stair slats on the water

2°) Assemble the slats until the stairs are completely assembled.

3°) Centre the big width slats in the pool (allowed dimension X: from both sides of the pool)

4°) Centre the stair using this slat.

To assemble the stair slats to the pool slats, proceed

as follows:

► Mark the position of both cap edges of the stair

slat on the wing of the long width slat.

► Make two notches of a cap and wing dimension on both

sides of the stair on the wing of the long width slat

without hurting the waterproof of the slat.

Long width slat

Wing

Notch

First stair slat

COVER

ALLOWED

DIMENSION X POOL

Table des matières

Autres manuels Astral Pool Équipement d'éclairage

Astral Pool

Astral Pool 00250 Manuel

Astral Pool

Astral Pool KEOPS Manuel utilisateur

Astral Pool

Astral Pool Viron Connect 10 Manuel utilisateur

Astral Pool

Astral Pool Atomic V-AF Manuel utilisateur

Astral Pool

Astral Pool 33556 Manuel

Astral Pool

Astral Pool 01413 Manuel

Astral Pool

Astral Pool SKIMMER Manuel

Astral Pool

Astral Pool Heliox UV AISI 316 L Manuel

Astral Pool

Astral Pool Heliox UV MP 50 Manuel

Astral Pool

Astral Pool Mini Skimmer Manuel

Astral Pool

Astral Pool DeckWell 330 Manuel utilisateur

Astral Pool

Astral Pool 00081 Manuel utilisateur

Astral Pool

Astral Pool MICRO Manuel

Astral Pool

Astral Pool 23199 Manuel utilisateur

Astral Pool

Astral Pool 11508 Manuel utilisateur

Astral Pool

Astral Pool LumiPlus Mini 2.0 Quadraled 52130 Manuel utilisateur

Astral Pool

Astral Pool TRAMONTANE Manuel utilisateur

Astral Pool

Astral Pool Eco Manuel utilisateur

Astral Pool

Astral Pool ECO-CCE Manuel

Astral Pool

Astral Pool Selwatch Manuel d'exploitation et d'entretien

Astral Pool

Astral Pool 42350 Manuel

Astral Pool

Astral Pool Brick Light 45716 Manuel

Astral Pool

Astral Pool KEOPS Manuel utilisateur

Astral Pool

Astral Pool LUMIPLUS FLEXIMINI Manuel utilisateur

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur