AR BLUE CLEAN 6630 - 6640 - 6650 - 6670
USE AND MAINTENANCE HANDBOOK page 8
7. MACHINE RUNNING
After having installed the machine, it can be started; open the water
faucet H, press the start button I and pull on the gun lever L for a few seconds, in a way to
discharge the air contained in the hose.
When the machine is started for the first time, it’s necessary to let it run for a few minutes
without nozzle, so that any impurities and air will be discharged from the pump; after this
operation, reassemble the nozzle.
The performance with cold water, can be obtained by pressing the start switch I, so the
pump running, then pull the gun lever L.
The hot water, can be obtained by pressing the start switch I, than adjust the working
temperature on the thermostat handgrip M, pull the gun lever L and the burner starts
burning and producing hot water at the temperature desired.
After having used the cleaner with hot water, before you stop it, let it run with cold water for
a few minutes. The pressure regulation N is fixed by the manufacturer and cannot be
changed for any reason.
The detergent is applied by opening the intake device of the lance (on
the position - see figure) and then operating with the gun lever.
At the end of the working day, switch off the start button and,
operating on the gun, remove the residual pressure from the hose.
8. STANDARD EQUIPMENT
Thermal lance with spray nozzle-holder and gun
High pressure hose: lenght m 10
Spray nozzle 1/4” MEG
9. DETERGENTS
It is advisable to use detergents with liquid base and not with dusts. Use biodegradabile
detergents, observating the relative regulations in force.
https://www.kipogeorgiki.gr/
https://www.kipogeorgiki.gr/
