APsmart RSD-EYE+ Manuel utilisateur
2020/6/10 Rev1.0
1
RSD-EYE+ Operation Manual
◆Introduction
◆Product Structure
Signal Smart Detector
RSD-EYE+
RSD-EYE+ is a small and lightweight multifunctional
handheld detection device for sensing pulse modulation
from the power line communication (PLC) signal between
transmitter and RSD-S-PLC, to ensure compliance to the
SunSpec Alliance Rapid Shutdown protocol. In addition,
the RSD-EYE+ can also be used as a handheld transmit
device, by connecting an optional external DC cable to
send an in-line keep-alive signal to RSD-S-PLC.
Sensor Area
Power LED
Transmit LED
Transmit Button
Detected LED
Detected Button
Place the sensor area on
the RSD-EYE+ within 2cm
from the RSD-S-PLC output
line
Not supplied by APsmart ，
please purchase by yourself
9V Battery
+ -
Please confirm
the positive and
negative poles of
the battery when
installing it
Black Cable
Negative
Connection
Red Cable
Positive
Connection
2020/6/10 Rev1.0
2
◆System Diagram
◆RSD-EYE+ Detected Mode
◆RSD-EYE+ Transmit Mode
Warning: Please only connect one RSD for testing.
19925 Stevens Creek Blvd, Suite 100, Cupertino, CA 95014
①RSD-S-PLC
②RSD-EYE+
③Transmitter-PLC
④Inverter
After all RSD-S-PLC in the PV system have
been installed and the transmitter is connected
and powered on, place the sensing area on the
RSD-EYE+ within 2cm from the RSD-S-PLC
output powerline. Testing each RSD-S-PLC
with the RSD-EYE+ to confirm the presence of
a keep-alive signal. During the detection, the
“Detected Mode” button B should be hold for
more than 3 seconds, and the yellow power
LED will be lit. When the keep-alive signal is
detected, the detected mode LED will be lit
blue and an audible alert will sound to confirm.
This will hold about 7 seconds even if
RSD-EYE+ leave the detecting area, so during
a new test, wait for the indication disappears
or press the key again.
OUTPUT- OUTPUT+
+ -
Confirm the RSD-S-PLC input cables are
connected to PV module output cables, and
its output cables are connected to the
external cable from RSD-EYE+ properly, and
the RSD-S-PLC is on the off state. During the
detection process, the transmission mode
button A should be pressed above 2 seconds,
then the yellow power LED lights on. If the
output voltage detected greater than 20V, the
corresponding transmitted mode LED light
turns green and an audible alert will sound
continually.
Autres manuels APsmart Capteur de sécurité
