Apache Labs PiHPSDR Manuel utilisateur
PiHPSDR CONTROLLER ASSEMBLY MANUAL
Please note that you will have to create a bootable MicroSD card and install it in your Pi before
proceeding with the hardware assembly, it is assumed that you know how to do this, instructions are
available on the raspberripi.org website.
Contents of the Rpi and the official Rpi inch screen kit
Please remove the two spacers as shown above and replace with the supplied screws
De solder the 5 pin header and solder the 5 pin ribbon cable as shown above
Fix the two spacers removed earlier from the Screen PCB and secure on to the Controller PCB with
nuts (Supplied with the kit) as shown above
Your 5 pin cable assembly should look like this once soldered
There are four Philips head screws supplied with the kit
Use the above screws to fix the screen on to the controller PCB, ensure orientation is as above
Once the screen and the controller pcb are secured, place the Rpi on the four spacers and screw on
the four screws supplied with the Rpi kit.
Now connect the Display flex cable as shown above to the Display PCB and the Pi
Connect the 40pin IDC cable to the controller PCB and Pi observing polarity (red strip) as above
Place the assembled Kit on the Controller back chassis as above an screw the Hex nuts
Remove the plastic protection film from the display
Place the top cover and screw on the front panel screws
Autres manuels pour PiHPSDR
1
Autres manuels Apache Labs Contrôleurs
