Amroad DP3210 Manuel utilisateur

Autres manuels pour DP3210

2

Table des matières

Autres manuels Amroad Système d'interphone

Manuels Système d'interphone populaires d'autres marques

Bticino

Bticino LINEA 3000 Manuel utilisateur

MSI

MSI MSI-140 Manuel utilisateur

golmar

golmar Stadio Plus Manuel utilisateur

CyberData

CyberData 011211 series Manuel

Vidos

Vidos duo M1021 Manuel utilisateur

Vimar

Vimar ELVOX 7539/E Manuel utilisateur

SSS Siedle

SSS Siedle BTSV 850-03 Manuel utilisateur

Dahua

Dahua VTO Series Manuel utilisateur

Elvox

Elvox 5651 Manuel utilisateur

Videx

Videx VIDEOKIT Series Manuel utilisateur

Rocom

Rocom Doortello Business FW T2.05W2.04 Manuel utilisateur

Viking

Viking E-35-EWP Manuel utilisateur

Safeguard Supply

Safeguard Supply LRA-EX1000 Manuel utilisateur

SSS Siedle

SSS Siedle BFCV 850 Series Manuel utilisateur

GRD

GRD MAX V2 Manuel utilisateur

Alecto

Alecto ADI-250 Manuel utilisateur

Aiphone

Aiphone IE-8MD Manuel utilisateur

Perel

Perel EDB4 Manuel utilisateur

AMROAD DP3210

DOOR STATION

~

Installation Manual

AMROAD DP3210

Contents

Contents............................................. i

Package Contents...............................1

The Size of Main Unit......................... 2

Rear Side ........................................... 3

Reset Button .................................................3

Installing Procedures......................... 4

Back Plate ..................................................... 4

Wire and Cable Connection......................... 5

Install Main Unit .......................................... 6

Contents

i

AMROAD DP3210

Package Contents

1. Main Unit x1

2. Back Plate x1

3. Wall Mounted Screw Pack (Self Tapping

Screw TP3-L16 x4, Wall Plug x4)

4. Screw M3-L6 x2

5. Screw for Earth Wire M3-L4 x1

6. 2-Pin Terminal Connector x1

7. Cord End Terminal (Blue x1, Gray x1)

Package Contents

1

AMROAD DP3210

The Size of Main Unit

The Size of Main Unit

2

AMROAD DP3210

Rear Side

Reset Button

1. The device will be switched to the static IP

mode and reboot itself when the user has

pressed the reset button for 3 seconds. IP is

"192.168.0.50".

2. When the button has been pressed for

more than 6 seconds, the device will be

switched to the DHCP mode and reboot

itself (the users need to restore the factory

setting).

Rear Side

3

AMROAD DP3210

Installing Procedures

Back Plate

1. Make sure that is able to let the Power

Cord, Ethernet cable, and Earth Wire pass

through the hole. The bottom of standard

wall box is height 148cm from the floor.

2. Connect the ground wire to the Back Plate.

3. Use Wall Mounted Screw Pack to fix Back

Plate on the wall.

Notice：

Do not force overload when fastening the Back

Plate. Otherwise, Back Plate will be out of

shape and install Main Unit failed.

Installing Procedures

Back Plate

4

AMROAD DP3210

Wire and Cable Connection

1. connect Ethernet Cable；Connect 12V

DC power cord.

2. Use Ferrule Crimping Tool to crimp Cord

End Terminal with wire tight.

3. Insert the Cord End Terminal into 2-pin

Terminal Block, and tighten them.

4. Insert 2-pin Terminal Block into 12V DC

connector on the rear side.

Installing Procedures

W

ire and Cable Connection

5

AMROAD DP3210

Install Main Unit

1. Lift Main Unit up Back Plate.

2. Let the rear side locate on Supporting

Hooks. Put down the Main Unit vertically.

3. Secure the Main Unit by fastening the 2

screws on the bottom. Then, the

installation would be completed.

4. The protective film on the Main Unit

should not be torn up during installation.

Do not tear up the protective film until

new residents move in the house.

Observe the bottom of Main Unit and Back

Plate.

If the Back Plate on the bottom of the

Main Unit is raised, it means that Main

Unit and Back Plate don’t meet closely.

The waterproof function is not good. (A

little external force from top of the Main

Unit may improve this situation.)

However, if the bottom of Main Unit and

back plate meet closely, it means that

the DP3210 will be with better

waterproof function.

Apply Silicon Glue around the Main Unit

if required to strengthen waterproof

ability.

Installing Procedures

Install

Main Unit

6